ECU AUDI A4 1999 B5 / 1.G APB Engine Motronic Multiport Fuel Injection System Servising Workshop Manual
Page 41 of 90
24-36
- When the vacuum hose is re-connected the fuel
pressure should drop by around 0.5 bar.
If the pressure does not change as specified,
carry out the following tests:
Check vacuum hose for cracks and other
damage.
Test vacuum hose for blockages at intake
manifold. To do this, disconnect hose at fuel
pressure regulator and blow into it.
- If there are no leaks and no blockages in the
vacuum hose, install new fuel pressure
regulator.
- Replace hose clamp that secures vacuum hose
to the fuel pressure regulator and make sure
that new clamp is properly installed.
Checking residual fuel pressure
- Residual pressure 10 minutes after switching off
engine (minimum pressure)
With engine cold: at least 2.2 bar
Pa
ge 41 of 90 Motronic Multi
port Fuel In
jection
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1
Page 56 of 90
24-47
- Lift fuel rail off intake manifold together with fuel
injectors and support the fuel rail.
Note:
After lifting off the fuel rail, check to make sure
that the injectors are properly secured to the
fuel rail.
It is possible that some of the fuel injectors will
become detached from the fuel rail and remain
in the intake manifold when the fuel rail is
removed. If this happens, install the fuel
injectors back onto the fuel rail Page 24
-53
.
WARNING!
Make sure test box is inside of passenger compartment. - Connect test box VAG 1598/31 to wiring harness for engine control
unit. Do not connect to the engine control module itself Page 24
-20
.
Pa
ge 56 of 90 Motronic Multi
port Fuel In
jection
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1
Page 62 of 90
24-52
Make sure fuel injectors are correctly
positioned, insert vertically into fuel rail and
secure with retainer clips.
Position fuel rail together with injectors
(properly secured) against intake manifold
and press into place evenly all round.
Replace hose clamps and make sure that
they are securely installed.
Pa
ge 62 of 90 Motronic Multi
port Fuel In
jection
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1