check engine light AUDI A6 1997 C5 / 2.G ATW Engine Motronic Fuel Injection Syst
Page 22 of 81
24-21
      
Note:  
     Important note: 
     After re-connecting the Engine Control Module 
(ECM), the following work steps must be 
performed: 
     - Perform adaptation of the Throttle Valve Control 
Module -J338-   Page 24
-121
 . 
     - For vehicles with automatic transmission, the 
kick down function must be adapted   Page 24
-
139
 . 
     - Check DTC memory and erase it if necessary 
 Page 01
-16
 . 
     - If DTC memory was erased, readiness code 
must be re-generated   Page 01
-73
 . 
     
Note:  
     During the first adaptation phase, it is possible 
that idle will be rough and vehicle may shake 
lightly in drive mode. 
Pa
ge 22 of 81 Motronic fuel in
jection s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.24.1 
Page 44 of 81
24-40
      
Checking voltage supply  
     
Test requirements: 
     
Fuse for fuel injectors OK 
     
       Electrical Wiring Diagrams, Troubleshooting & 
Component Locations   
     
Fuel Pump (FP) relay OK; checking   Page 24
-53
 . 
     
-  Disconnect harness connector at the fuel 
injector to be tested. 
    
If LED does not light up:  -  Connect VAG1527B voltage tester as follows:Harness connector  
Terminal  
Measure to  
1   Engine Ground (GND)  
-  Switch ignition on.
 
LED must light up. 
Pa
ge 44 of 81 Motronic fuel in
jection s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.24.1 
Page 46 of 81
24-41
      
-  Repair open circuit if necessary.
      If LED lights up:  
     
-  Activation of fuel injectors, checking
     
Checking activation  
     
Test requirement: 
     
Internal resistance of valve OK 
     
-  Slide back rubber grommet of fuel injector 
connector, but leave connector connected. 
    
Note:  
Voltage testers do not go out completely during low current pick-up 
between activations by the ECM, but rather continue to glow a little and 
then get slightly brighter during activation.  -  Connect VAG1527B voltage tester between sockets 2 (signal) and 1 
(B+). 
-  Operate starter briefly (engine can also start).
 
LED must blink.
Pa
ge 46 of 81 Motronic fuel in
jection s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.24.1