ignition AUDI A8 1996 D2 / 1.G AHA ATQ Engines Cooling System Components Workshop Manual
Page 8 of 40
19-6
7 -
Engine Coolant Temperature (ECT) sensor
-G62-
For Engine Control Module (ECM)If necessary, release pressure in cooling
system before removing Checking Repair Manual, 2.8 Liter V6
5V Fuel Injection & Ignition, Repair Group
01
8 -
Rear coolant line
Coolant hose connection diagram page 19
-9
9 -
Lifting eye
10 -
10 Nm (7 ft lb)
11 -
Coolant line
Coolant hose connection diagram page 19
-9
12 -
Front coolant hose
Coolant hose connection diagram page 19
-9
13 -
Sealing cap
Check using VAG1274 cooling system
tester with VAG1274/8 adapter Test pressure: 1.4-1.6 bar (20-23 psi)
Pa
ge 8 of 40 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.19.1
Page 32 of 40
19-26
Coolant fan, checking
Test requirements
Test procedure
Fuse No. 34 OK Coolant Fan Control (FC) thermal switch -F18- OK
- Disconnect 3-pin harness connector from coolant Fan Control (FC)
thermal switch -F18- at bottom left of radiator.
- Switch ignition on.
- Bridge terminal -1- and terminal -2- of harness connector using
auxiliary cables from VW1594 connector test kit.
Coolant fan -V7- must run on 1st speed.
Pa
ge 32 of 40 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.19.1