differential AUDI A8 1998 D2 / 1.G 01V Transmission Drive Shaft Service Workshop Manual
Page 9 of 23
39-80
- Remove heat shields above driveshaft.
- Unbolt heat shield for driveshaft from cover for Torsen differential
(arrows).
Note:
Only mark location, if same driveshaft is going to be reinstalled. - Check whether there is a factory marking (colored dot -arrows-) on
driveshaft and at flange/driveshaft at rear final drive. If not, mark
location of driveshaft flange -A- to rear final drive -B- with color.
Pa
ge 9 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5
Page 17 of 23
- Turn differential gear via both rear wheels (left and right flanges) at the
same time in one direction until drive flange/driveshaft flange has made
on complete revolution.
- Mark largest radial run-out on outer edge of flange with colored
marking (equivalent to largest distance from turning axis).
- Remove old marking on driveshaft flange.
- Installing driveshaft page 39
-83
.
Pa
ge 17 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5