fuse AUDI A8 2000 D2 / 1.G AEB Engine Ignition Coil System Checking
Page 5 of 11
28-19
Wiring for primary coil and power
supply, checking
Required special tools and test equipment
VAG 1527B LED voltage tester
VW 1594 connector test kit
Wiring diagrams
Test conditions
Fuse for ignition coils OK
Checking
- Disconnect 4-pin harness connector from power
output stage.
- Switch ignition on.
Note: - Connect VAG 1527B LED voltage tester in turn between 4-pin
connector terminals 1, 2, 3 and 4, and engine ground.
LED must light up for all 4 terminals
Pa
ge 5 of 11 Individual i
gnition coil s
ystem, checkin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.28.2
Page 6 of 11
The power supply for the primary circuit is measured via the fuse and
primary coil of the ignition coil.
Pa
ge 6 of 11 Individual i
gnition coil s
ystem, checkin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.28.2
Page 7 of 11
28-20
If the LED in the tester does not light up:
- Check wiring for open circuits between power output stage and
terminal 1 at each coil connector, according to table.
Specified value: max. 1.5
If the wiring is OK: - Ignition coil connector terminal identification
Black 4-pin connector terminal
number (power output stage) Ignition coil terminal 1 at
connector for cylinder number:
1 1
2 2
3 3
4 4
- Check wiring for open circuit between each coil terminal 15 and fuse
and power supply, according to wiring diagram.
Specified value: max. 1.5
Pa
ge 7 of 11 Individual i
gnition coil s
ystem, checkin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.28.2