engine AUDI S4 1997 B5 / 1.G 01E Transmission Clutch Mechanism Service Workshop Manual
Page 9 of 27
30-9
 
  
Clutch Pedal Position (CPP) switch -F 194-, 
removing and installing
 
Note  
The clutch pedal position (CPP) switch -F194- 
ensures that the engine can only be started with the 
clutch pedal depressed. 
1 - 
Mounting bracket 
2 - 
Cable bracket 
3 - 
Fuse 
4 - 
Bolt 
Lock into clutch pedal
5 - 
Clutch pedal Removing and installing   Page 30
-5
Pa
ge 9 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1 
Page 17 of 27
30-17
      
Master cylinder, removing and installing
 
     
Special tools, testers and auxiliary items  
    
Removing  
Remove E-Box from plenum chamber as follows:  
Hose clamp 3094
-  If installed, remove cover above plenum chamber.
-  Disconnect battery Ground (GND) strap with the ignition switched off.
    
 Repair Manual, Electrical Equipment, Repair Group 97
    -  Pull off clip -1- and lift wind grill -A- slightly. Now remove screw (arrow -
2-). 
-  Remove remaining screws (arrows) and remove cover.
-  Remove engine control unit and 8-point relay carrier (if fitted)
-  Unplug connector in connector station.
-  Pull engine wiring harness together with rubber grommet out through 
opening in electronics box. 
Pa
ge 17 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1 
Page 24 of 27
30-24
      
-  Remove driver's side storage compartment:
     
       Repair Manual, Body Interior, Repair Group 
68
   
    
 Repair Manual, Electrical Equipment, Repair Group 97
    -  Always replace seal -C-. 
-  Make sure seal does not cover chassis opening and elevated edge of 
sheet metal. 
-  Insert E-Box in securing point -B- and tighten nuts -A- to 4 Nm.
-  Press cover on by hand and tighten bolts -A- diagonally to 4 Nm (also 
see inscription on cover). 
-  Install engine wiring harness and connect harness connector in 
connector station. 
-  Install engine control module and if necessary, auxiliary relay carrier 
and auxiliary fuse holder. 
Pa
ge 24 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1