check engine AUDI S4 1997 B5 / 1.G 01E Transmission Remove And Install Workshop Manual

34-33

Installing
Installation is carried out in the reverse order,
when doing this note the following:

- Always replace all seals and gaskets.

- Always replace all self-locking nuts.

- Check whether dowel sleeves for aligning
transmission with engine are in engine flange.
Insert if necessary Page 34
-36
.

- Clean input shaft splines and (in the case of
used clutch plates) hub splines. Remove
corrosion and apply only a very thin coating of
grease G 000 100 to splines. Do not grease
guide sleeve.

- Check clutch release bearing for wear and
replace if necessary.

- Coat area -a- of collar with lithium grease G 052 150 A2 before
mounting slave cylinder into transmission housing.
- Coat contact surface for clutch slave cylinder push rod with a thin layer
of copper grease, e.g. Z381 351 TE.
Pa
ge 16 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.2