BMW MOTORRAD K 1200 GT 2004 Rider's Manual (in English)

9
General information and controls
1
Hazard warning flashers

Note:
You cannot activate the hazard
warning flashers if the ignition is
switched off.
Do not use the hazard warning
flashers for longer than abso-
lutely necessary.
Note state of battery charge.
To switch on the hazard
warning flashers:
• Switch on the ignition
• Operate hazard warning flasher switch 1
– Hazard warning flashers in operation
– Telltale light in switch is on
• Switch off the ignition
– The hazard warning flashers
continue to operate
– Telltale light in switch goes out
To switch off the hazard
warning flashers:
• Operate hazard warning
flasher switch 1
– Hazard warning flashers
cease to operate
1
Hazard warning flashers
10k41bkg3.book Seite 9 Donnerstag, 27. Mai 2004 5:30 17

10
General information and controls
1
KeysYou will receive two master
keys and one spare key.
A small plastic tag indicating
the key number is also
supplied.
 Warning:
If the motorcycle is fitted with
BMW Integral ABS, only a RE-
SIDUAL BRAKING FUNCTION
is available when the ignition is
switched off (
77)

Note:
The ignition switch and steering
lock, fuel filler cap and the seat
lock and system cases are all
operated with the same key.
Ignition switch and steering lock
10k41bkg3.book Seite 10 Donnerstag, 27. Mai 2004 5:30 17

11
General information and controls
1
Ignition switch and steering lock
Key positionsONOperating position,
ignition, lights and all
electrical circuits
switched on
R * Ignition and lights off,
steering not locked
(handlebars can be turned
freely to left or right)
 Warning:
Never turn the key to OFF or

while riding the motorcycle!
* The key can be removed in these
positions
• Turn the handlebars to full left lock.
 Attention:
Engage the steering lock with
the handlebars in this position
only.
OFF * Ignition and lights off,
steering locked
 * Parking light on,
steering locked

Note:
Switch the parking light on only
for limited periods. Note state of
battery charge.
10k41bkg3.book Seite 11 Donnerstag, 27. Mai 2004 5:30 17

12
General information and controls
1

Warning:
To prevent air from entering
the hydraulic circuit of the
clutch:
• do not turn the fitting on the
handlebar.
1 Switch for cruise control
OE
(
17)
2 Hazard warning flasher
switch (

9)
3 Switch for windscreen
adjustment (

24)
4 Horn push 5
Turn indicator switch, left
•Press
– Turn indicators operate
To switch off turn indicators:
• Self-cancelling while rid-
ing, or press turn-indica-
tor cancel switch 12
(

13)
6 High-beam/low-beam
headlight switch

High-beam headlight
Low-beam headlight

Headlight flasher
OEOptional extra
Left handlebar fitting
123
654
10k4101g3.fm Seite 12 Mittwoch, 9. Juni 2004 3:23 15

13
General information and controls
1

Warning:
To prevent air from entering
the brake system:
• do not turn the fitting on the
handlebar.
7 Switch for heated
handlebar grips
OE
A Heating function off
B 50% (centre position)
C 100%
8 BC-Button (

14)
9 Starter pushbutton
10 Emergency off (kill) switch
for ignition (

66)
OEOptional extra
11Right flashing turn indicator
switch
•Press
– Turn indicators operate
To switch off turn indicators:
• Self-cancelling while riding,
or press turn-indicator can-
cel switch 12
12 Turn-indicator cancel switch
•Press
– Left/right turn indicators off
13 Switch for seat heating
OE
0Seat heating off
.Seat heating on
..Fast heating on for rapid
heating
ABC7
13
12
10
11
98
Right handlebar fitting
10k4101g3.fm Seite 13 Mittwoch, 9. Juni 2004 3:23 15

14
General information and controls
1
Toggling between time/
ambient-temperature
reading
• Switch on the ignition
• Briefly press BC-button 1

Note:
Use a ball-point pen or similar in-
strument to press button A or B.
Setting the timePress button A (hours) or
button B (minutes).
Toggling between 12- and
24-hour modes
• Switch off the ignition
• Press and hold down button A
• Switch on the ignition
• Hold down button A for
approximately 3 seconds
longer
Clock
1
AB
10k4101g3.fm Seite 14 Donnerstag, 27. Mai 2004 5:30 17

15
General information and controls
11
AB
Toggling between time/
ambient-temperature
reading
• Switch on the ignition
• Briefly press BC-button 1

Note:
Use a ball-point pen or similar in-
strument to press button A or B.
Toggling between
°C and °F
• Switch off the ignition
• Press and hold down button B
• Switch on the ignition
• Hold down button B for
approximately 3 seconds
longer
Display, ambient temperature
10k4101g3.fm Seite 15 Donnerstag, 27. Mai 2004 5:30 17

16
General information and controls
1

Note:
With automatic cruise control,
speed can be controlled in the
range between 40 and 180 km/h
(25 and 112 mph).
When the motorcycle is at a
standstill and – ignition OFF –
the system is switched off and
the stored road speed is can-
celled.
Telltale light, cruise control
yellow off.
On a motorcycle fitted with
BMW Integral ABS, the cruise-
control system is not operation-
al if the brake light is defective
(general warning light red


ON
68).
OEOptional extra
 Warning:
Do not engage cruise control
when:
– Riding on twisty roads with poor forward vision
– Heavy traffic does not enable
you to maintain a constant
road speed
– Riding on wet, unpaved or dirty roads
The motorcycle might exceed
your chosen cruise control
speed if the engine's braking
effect is insufficient on a down-
hill gradient. It could also drop
below this speed when you
ride uphill.
For safety reasons, always
keep both hands on the
handlebars.
Cruise controlOE
10k41bkg3.book Seite 16 Donnerstag, 27. Mai 2004 5:30 17

17
General information and controls
1
Switching on the system• Move switch1 to ON
– Red telltale light 2 in
switch is on
Setting road speed • Briefly press button 3 in SET
direction
– Telltale light, cruise control
yellow on.

Note:
The motorcycle maintains and
memorises your current cruis-
ing speed.
OEOptional extra
Cruise controlOE
1
3
2
10k41bkg3.book Seite 17 Donnerstag, 27. Mai 2004 5:30 17

18
General information and controls
1
Step-by-step acceleration• Push button1 in SET
direction
– Memorised road speed increases by approx. 2 km/h
(1 mph)

Note:
Every subsequent time you
push button 1 in the SET direc-
tion, road speed increases by a
further 2 km/h (1 mph).
Stepless
acceleration
• Push and hold button 1 in
SET direction
– The motorcycle accelerates
steadily, even though you do
not manually open the throttle
• Release button 1
– The motorcycle maintains and memorises your current cruis-
ing speed
OEOptional extra
Cruise controlOE
1
10k41bkg3.book Seite 18 Donnerstag, 27. Mai 2004 5:30 17