turn signal BUICK LACROSSE 2005 Get To Know Guide

A.Air Outlets
B.Interior Lamps Control
C.Exterior Lamps Control
D.Turn Signal/Multifunction Lever
E.Audio Steering Wheel Controls
F.Instrument Panel Cluster
G.DIC ButtonsH.Passenger Air Bag Status
Indicator
I.Audio System Controls
J.Hood Release
K.Parking Brake
L.Cruise ControlsM.Horn
N.Steering Wheel Climate Controls
O.Climate Controls
P.Shift Lever
Q.Accessory Power Outlet
R.Glove Box
Getting to Know YourLaCrosse2
Instrument Panel
See Section 3 of your Owner Manual.

Getting to Know YourLaCrosse6
Remote Vehicle Start
(if equipped)
Use the Remote Keyless Entry transmit
ter (key fob) to start the engine from outside the vehicle. (See the DriverInformation Center personalization menu
section to enable.) Automatic ClimateControl system vehicles will regulate theinside temperature.
To remote start the vehicle:1.Press and release the key fob Lock
button.
2. Press and hold the (Remote Start)
button until the turn signal lights flash.If the lights are not visible, hold theRemote Start button for four secondsand release.
The engine runs for 10 minutes. Extend
run time for 10 minutes from present by
pressing the Lock and Remote Start buttons again. Pressing only the Remote
Start button again will turn off the ignition. Maximum run time is 20 minutes.
See Section 2 of your Owner Manual.
Unlocking the Doors with the Key
Your vehicle’s passenger doors can be
unlocked using the driver’s door key.
With the key in the lock cylinder:
• Turn the key toward the front of the
vehicle to unlock the driver’s door.
• Turn and hold the key toward the
front of the vehicle for two seconds tounlock all doors.
• Turn and hold the key toward the rear
of the vehicle momentarily to lock alldoors.
See Section 2 of your Owner Manual.
Headlamp Controls and
Automatic Headlamp System
You will find the exterior lamps knob on
the left side of the instrument panel.
AUTO:Activates the automatic head
lamp system, illuminating all exteriorlamps and the instrument panel/radiolights when needed.
(On/Off):If the switch is in the AUTO
position but lights are off, turn them onby turning the switch to (On/Off) and
release. To turn the headlamps off whenthe lights are on, turn the control to the
position. The momentary switch
design springs back to AUTO whenreleased.
(Parking Lamps):The parking lamp
position illuminates tail/side
marker/license plate lamps and instrument panel/radio lights.