seat BUICK LACROSSE 2017 Get To Know Guide

2
Power
Mirror/
Window
Controls Memory
Seat
Buttons
F
Instrument Panel
Illumination Control
Engine
Start/Stop Button
Driver
Information
Center Controls/ Audio Steering
Wheel Controls Windshield
Wipers Lever
Driver
Information Center
Tap Shift
Controls
Turn
Signal Lever
Electric
Parking Brake Head-Up
Display
Controls
F
Trunk
Release Button Steering
Wheel
Adjustment Lever or Power
Control
F
Cruise Control/Forward
Collision AlertF/Heated
Steering WheelF/Voice
Recognition Buttons
Exterior Lamps
Controls
Instrument Panel
Symbols
Low Tire Pressure
Antilock Brake System
Warning

Brake System Warning
Airbag Readiness
P
ARK Electric Parking Brake
Door Ajar
Fog Lamps

Lane Keep Assist Warning
Cruise Control Set
Vehicle Ahead
Adaptive Forward Lighting
Service Electric Parking Brake
Traction Control Off
Charging System

3
Hazard Warning Flashers Button Infotainment
System Touch Screen
Electronic
Precision Shift Lever
Driver’s Heated/
Vented Seat Buttons
F
Sport Mode/Traction
Control Off/Automatic
Parking Assist
F/Parking
Assist/Lane Keep AssistF
Buttons Infotainment
System Controls
Refer to your Owner Manual to
learn about the information being
relayed by the lights, gauges and
indicators on the instrument cluster.
See In Brief in your Owner Manual.
Passenger’s
Heated/Vented Seat Buttons
F
Climate
Controls
Engine Oil Pressure
Engine Coolant Temperature
High Beam Headlamps

Security
StabiliTrak Off
Traction Control/
StabiliTrak Active
Safety Belt Reminder
Check Engine
Low Fuel
Lights On Reminder
F Optional equipment

4
Remote Keyless Entry Transmitter (Key Fob)
Lock
Press to lock all doors.
Unlock
Press to unlock the
driver’s door. Press again
to unlock all doors.
Trunk
Press twice to open the
trunk.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle.
The exterior lamps will flash and the horn
will sound.
Press and hold to activate the alarm. Press
it again to cancel the alarm.
Door Key
Press the button on the back of the
transmitter to pull out the door key.
Note: To change the remote lock, unlock, and
remote start settings, go to Remote Lock, Unlock,
Start in the Vehicle Settings menu.
Remote Vehicle Start
Press and release the
Lock button and
then immediately press and hold the
button until the turn signal lamps flash to
start the engine from outside the vehicle.
After entering the vehicle, turn on the
ignition.
• During a remote start, the engine will
run for 10 minutes. Repeat these steps
to run the engine for an additional
10 minutes. A remote start can be
extended once.
• Press and hold the
button until
the parking lamps turn off to cancel a
remote start.
Remote Start and Heated/Vented Seats
F
Select the remote start heated or vented
seat option in the Vehicle Settings to have
the heated/vented seats turn on during a
remote start. The seat button indicators
do not illuminate and the temperature
performance of the unoccupied seat may
be reduced during a remote start.
See Keys, Doors and Windows in your Owner Manual.
Keyless Access System
The Keyless Access System enables operation of the doors, ignition and trunk without
removing the Remote Keyless Entry transmitter from your pocket or purse. The trans­
mitter must be within 3 feet of the door being unlocked or the trunk.
Keyless Unlocking
With the transmitter within range:
Press the lock button on the driver’s door handle to unlock the driver’s door; press it
again within 5 seconds to unlock all doors.
Press the lock button on a passenger door handle to unlock all doors.
Press the bottom of the Buick emblem above the license plate to open the trunk.
Keyless Locking
With the ignition off, the transmitter removed from the vehicle, and all doors closed:
Press the lock button on any door handle to lock all doors immediately.
If Passive Locking is turned on, all doors will lock automatically after a short delay.
Note: To change the Keyless Locking and Unlocking settings, go to Remote Lock, Unlock, Start in the
Vehicle Settings menu.
See Keys, Doors and Windows in your Owner Manual.F Optional equipment

6
Front Seats
Power Seat AdjustmentA. Seat Adjustment
Move the horizontal control to move
the seat forward or rearward and to tilt,
raise or lower the seat.
B. Seatback Recline Adjustment
Move the vertical control to recline or
raise the seatback.
C. Lumbar Adjustment
Press the round control to adjust the
lumbar support.
D. Massage
F
Press the control button to turn the
massage feature on/off. It will turn off
after 10 minutes.
Memory Seat
With the driver’s seat, power steering columnF and power outside mirrors in the
desired position, press and release the SET button. A beep will sound. Immediately
press and hold button 1 until two beeps sound. Repeat the steps using button 2 for a
second driver and the
Exit button to set the exit position.

To recall the setting, press and hold button 1 or 2 or the [ Exit button until the
stored position is reached.
To set the Auto Memory Recall or Easy Exit options, go to Settings > Vehicle > Comfort
and Convenience.
Auto Heated/Vented Seat
F
The auto heated or vented seats will turn on automatically when the ignition is on at the
level required by the vehicle’s interior temperature.
To turn the Auto Heated/Vented Seats feature on or off, go to Settings > Vehicle >
Comfort and Convenience.
See Seats and Restraints in your Owner Manual.
F Optional equipment
Folding Rear Seatbacks
1. Press the button at the base of the head restraint post to lower the head restraint.
2. Use the door key from the RKE transmitter in the mini-buckle slot to disconnect the
mini-latch of the center safety belt.
3. Pull the release handle in the trunk to release the seatback.
4. Fold the seatback forward.
See Seats and Restraints in your Owner Manual.
ABCD

12F Optional equipment
Automatic Climate Controls
Driver’s Heated/Vented Seat ControlsF
Automatic Operation
1. Press AUTO.
2. Set the temperature.
The system automatically controls the fan speed, air delivery, air conditioning and recir
-culation to reach the set temperature. Allow time for the system to reach the desired
temperature. If the fan speed or air delivery mode is manually adjusted, automatic
operation is canceled.
SYNC Temperature Settings
Press CLIMATE to display the touch screen controls. Touch SYNC to link all passenger
settings to the driver settings.
See Climate Controls in your Owner Manual.
Passenger’s Heated/
Vented Seat ControlsF
ON/OFF
AUTO
Driver’s
Temperature
Control/Automatic Operation CLIMATE Touch Screen
Display Max Defrost
Passenger’s
Temperature Control/ Recirculation Mode Fan Speed Controls
Rear Window Defog/
Heated Outside MirrorsF
Control

14
Driving Assistance SystemsF
Safety Alert Seat – The driver’s seat pulses — left side, right side or simultaneously —
to alert the driver of potential hazards.
Seat pulsing alerts or audible alerts may be selected. To change the alert settings, go to
Settings > Vehicle > Collision/Detection Systems > Alert Type.
Lane Change Alert with Side Blind Zone Alert – While driving, the system displays a

warning symbol on the left or right side mirror when a vehicle is detected in that side
blind zone area or rapidly approaching that area. The warning symbol flashes if a turn
signal is activated when a vehicle has been detected.
To turn the systems on or off, go to Settings > Vehicle > Collision/Detection Systems >
Lane Change Alert.
Forward Collision Alert – The
Vehicle Ahead indicator illuminates in green on the
instrument cluster when a vehicle is detected and illuminates in amber when following
a vehicle ahead too closely. If your vehicle approaches another vehicle too rapidly, a visual
alert flashes on the windshield and the Safety Alert Seat pulses.
Press the Collision Alert button on the steering wheel to set the alert timing to
Far, Medium, or Near.
Forward Automatic Braking – The brakes may be applied in potential collision situations
to help reduce damage or help avoid collisions with vehicles directly ahead.
To set the Forward Collision Alert and Front Automatic Braking systems to Alert and
Brake, Alert, or Off, go to Settings > Vehicle > Collision/Detection Systems > Forward
Collision System.
Lane Keep Assist with Lane Departure Warning – The
Lane Keep Assist indicator
illuminates in green on the instrument cluster when a lane marking is detected. If your
vehicle approaches a detected lane marking without using a turn signal in that direction,
the system may assist by gently turning the steering wheel and provide a Lane Departure
Warning alert by flashing an amber
and sounding three beeps.

Press the Lane Keep Assist button on the center of the instrument panel to turn
the system on or off.
Front Pedestrian Detection – During daytime driving at speeds of 5–50 mph, the system
detects pedestrians directly ahead up to a distance of approximately 131 feet and dis
-plays an amber indicator. When approaching a detected pedestrian too quickly, a visual
alert flashes on the windshield and the Safety Alert Seat pulses. The system may prepare
the brakes or automatically brake the vehicle.
To set the system to Alert and Brake, Alert, or Off, go to Settings > Vehicle > Collision/
Detection Systems > Front Pedestrian Detection.
Traction Control and StabiliTrak Systems – The traction control system limits wheelspin
and the StabiliTrak® stability control system assists with directional control of the vehicle
in difficult driving conditions. Both systems turn on automatically every time the vehicle is
started. Turn off traction control if the vehicle is stuck and rocking the vehicle is required.
Press the Traction Control/StabiliTrak Off button on the center of the instrument
panel to turn traction control on or off.
See Driving and Operating in your Owner Manual.
F Optional equipment

15
Parking Assistance SystemsF
Battery Location
Capless Fuel Fill
F Optional equipment
Rear Vision Camera – When the vehicle is in Reverse, a view of the area behind the vehicle
displays on the touch screen. Vehicle speed must be below 5 mph.
To turn the guidance lines or Rear Park Assist symbols on or off, go to Settings > Rear
Camera.
Front and Rear Park Assist – During low-speed parking maneuvers, the system provides
“distance to closest object” information on the Driver Information Center, sounds a beep,
and pulses the Safety Alert Seat. When an object is very close, 5 beeps sound from the
front or rear of the vehicle and the Safety Alert Seat pulses.
Rear Cross Traffic Alert – When the vehicle is in Reverse, the system warns of traffic
coming in either direction by displaying a visual alert on the touch screen and pulsing the
left or right side of the Safety Alert Seat or sounding 3 beeps from the left or right.
Press the
Park Assist button on the center of the instrument panel to turn the
Parking Assist and Rear Cross Traffic Alert systems on or off.
Automatic Parking Assist – Automatic
Parking Assist steers the vehicle to help park
in parallel and perpendicular spaces.
1. Press the

Automatic Parking Assist
button on the center of the instrument
panel. A beep sounds and a parking assist
display is shown on the Driver Information
Center (DIC). The system will begin search
-ing for a large enough parking space.
2. Once a space is found, shift the vehicle into Reverse or Drive as directed on the DIC
and apply the accelerator or brake as needed. Parking Complete will be displayed and a
beep will sound when the parking maneuver is complete.
See Driving and Operating in your Owner Manual.
The standard 12-volt battery is located under the trim panel on the driver’s side of the
trunk. Remote jump-start terminals are located under the hood on the driver’s side of
the vehicle.
See Vehicle Care in your Owner Manual.
To open the fuel door, press and release the center of the rear edge of the door. It will
pop out slightly. Pull the door to open.
The capless fuel system does not have a fuel fill cap. Fully insert the fuel pump nozzle
before starting to fill the tank. If the tank must be filled using a portable container, first
insert the capless funnel adapter, located under the trunk floor, into the fuel system.
See Driving and Operating in your Owner Manual.