CADILLAC ELDORADO 1994 10.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine r
I-
DOMESTIC - -Repl-a.oelheybu€b agd,.,swk$~d.,conect the. wiring
.harness. Reinstall th?e&eadiight housing socket ihto *he headlamp
assembly. . . " ' ,.: T 7- +':."+~,
EXPORT - Install new headlight bulb and socket into headlamp
assembly.
NOTICE:
Domot touch.glass.portion of the ngw.halogen bulb! The oil
from your fingers will shorten. the life of your new halogen bulb. .. . ,
r P
r
r
r
I- i L
r kJ
Taillight bulb .replacement---is the same for either Eldorado.or .Eldorado
Touring Coupe.
1. Open the trunk to.gain access , to the taillight housing.
2. Remove the convenience net and pull back the trim.
279

Downloaded from www.Manualslib.com manuals search engine 3. Remove the. two
wing nuts.
4. Gently remove the taillight housing.
J

Downloaded from www.Manualslib.com manuals search engine r
f i
r
r
*;,. -
5. Press the bulb
housing lever,
rotate the housing
counterclockwise and remove it. Push
and rotatethe bu-lb.
counterclockwise
to
remove bulb.
Once you have replaced the burned out bulb, just reverse the \
steps
to
reassemble the taillight.
281

Downloaded from www.Manualslib.com manuals search engine CENTER HIGH MOUNTED STOP LAlMP
BULB REPUCEMENT
2. Twist the socket
(counterclockwise)
and remove the
socket and bulb
from the housing.
3. Replace the bulb.
Reverse the steps
to reassemble the stop lamp assembly.
282

Downloaded from www.Manualslib.com manuals search engine WPER BLADE REPLACEMENT
. Position the windshield wipers on the windshield in the “mid” wipe
position.
To do this, turn the ignition key to ‘‘Accessory” and turn the
wipers on. Then with the door open, turn the ignition key to
“Off. F I L
I- t.
r
Do the same with the passenger side wiper blade assembly.
To install the wiper blade align the wiper arm pin with the hole on the 7 1 wiper blade assembly and snap it into place.
I
Y
283

Downloaded from www.Manualslib.com manuals search engine If you only want to replace the wiper insert, follow these steps:
xr”
..
Disconnect the
wiper insert by
pulling the end
of
the insert. Then
pull it from the
blade housing retaining tab.
Now pull the insert from the blade housing.
Reinstall the new insert by aligning the blade housing tabs and the
edge of the insert. Make sure that the insert
is connected to all the
housing tabs.
Install the wiper blade assembly to the wiper arm.
284

Downloaded from www.Manualslib.com manuals search engine F-
c
r
i
Remove the crankcase
vent tube from the
top
of the air duct.
Loosen the clamp at
the throttle body and
': disconnect the air duct
from the throttle body.
r
I.
285

Downloaded from www.Manualslib.com manuals search engine Unlatch clamp and
gently remove air
cleaner from the
vehicle.
Push the
two tabs and
pivot the top half
to
separate the air
cleaner.
286

Downloaded from www.Manualslib.com manuals search engine r
r 1
r
t T
r
r
n
r
, Once you have
replaced-the air
cleaner filter, reverse
the steps to-reassemble.
and install back into
.your vehicle.
. ..
LOADING YOUR WEHICLE
1"
TIRE-LOADING INFOR'MATION.
OCCUPANTS VEHICLE CAP.
WT.
FRT; CT.R. RR. TOTAL: LBS.. KG
MAX. LOADING &.GVWRSAME AS'VEHICLE
TIRE SIZE SPEED
PRESSURE
CAPACITY WEIGHT . XXX COLD TIRE
RTG
PSVKPa
F RT.
R R.
SPA.
IF TIRES ARE HOT. ADD 4PW28KPa SEE
OWNER'S, MANUAL FOR: ADDITIONAL
INFORMATION

Two labels on your vehicle. show how much weight it may prope,rly carry.
The Tire-Loading Information label found on.the driver's door tells you
the proper size, speed rating and.recommended inflation pressures for
the tires on your vehicle.
It also gives you important information about
the number of people that can be in your vehicle and the total weight that
B" 287

Downloaded from www.Manualslib.com manuals search engine you can carry. This weight is called the Vehicle Capacity Weight and
includes the weight of all occupants, cargo, and all nonfactory-installed
options.
MFD BY GENERAL MOTORS CORP
DATE GVWR GAWR FRT GAWR
RR
THIS VEHICLE CONFORMS TO ALL APPLI-
CABLE U.S. FEDERAL MOTOR VEHICLE
TION STANDARDS
IN EFFECT ON THE
DATE OF MANUFACTURE
SHOWN ABOVE.
SAFETY, BUMPER,
AND THEFT PREVEN-
GEN GME
The other label is the Certification label, found on the rear edge of the
driver’s door. It tells you the gross weight capacity
of your vehicle, called
the GVWR (Gross Vehicle Weight Rating). The GVWR includes the
weight
of the vehicle, all occupants, fuel and cargo. Never exceed the
GVWR for your vehicle, or the Gross Axle Weight Rating (GAWR) for
either the front
or rear axle.
And, if you do have a heavy load, you should spread it out. Don’t carry
more than
185 lbs. (84 kg) in your trunk.
288
c
L -a