CADILLAC SEVILLE 1997 4.G Owners Manual
Page 181 of 370
Downloaded from www.Manualslib.com manuals search engine You must first load the magazine with discs before you
can play a compact disc. Each
of the 12 trays holds one
disc. Press the button on the back of the magazine and
pull gently on
one of the trays. Load the trays from
bottom to top, placing a disc on the tray label side down.
If you load a disc label side up, the disc will not play
and an
error will occur. Gently push the tray back into
the magazine slot. Repeat this procedure for loading up
to
12 discs in the magazine. Once you have loaded' the
discs in the magazine, slide
open the door
of the compact disc (CD) changer. Push
the magazine into the changer in the direction
of the
arrow marked
on top of the magazine.
3-22
Page 182 of 370
Downloaded from www.Manualslib.com manuals search engine c
Close the door by sliding it all the way to the left. If the
door is left partially open? the changer will not operate
and an error will occur. When the door
is closed, the
changer
will begin checking for discs in the magazine.
This will continue for
up to one and a half minutes,
depending
on the number of discs loaded.
To eject the magazine from the player, slide the CD
changer door
all the way open. The magazine will
automatically eject. Remember to keep the door closed
whenever possible to keep dirt and dust from getting
inside the changer. Whenever
a CD
magazine with discs is loaded in the
changer, the CD symbol will appear
on the radio display.
If the CD changer is checking the magazine
for CDs, the
CD symbol will flash on the display until the changer
is
ready to play. When a CD begins playing, a disc and
track number will be displayed. The disc numbers are
listed on the front
of the magazine.
All of the CD functions are controlled by the radio
buttons, except for ejecting the CD magazine.
PUSHBUTTONS: Press buttons one through six to go
from one compact disc to another that is loaded in the
changer. Press and hold one
of the six pushbuttons until
a beep sounds to
use pushbuttons 7 through 12. These
pushbuttons represent the order of the discs loaded in
the changer.
DSPL: Press and hold this button to see the track
elapsed time (available on all radios). Press DSPL again
within five seconds
to see how many compact discs are
loaded in the changer and where they are loaded
(not
available on the standard AM-FM Stereo radio).
REV: Press and hold this button to reverse quickly
through a track selection.
FF: Press and hold this button to advance quickly
through a track selection.
3-23
Page 183 of 370
Downloaded from www.Manualslib.com manuals search engine Y
SEEK-TUNE: Press the right arrow to seek to the next
selection. Press the left arrow to search
for the previous
track selection. The sound will mute while seeking.
SCAN: When you press SCAN while playing a CD, you
will hear the first few seconds of each track on a disc.
Press SCAN again to stop on
a CD. The CD will mute
while scanning and SCAN will appear on the display.
RDM: Press this button to hear the tracks in random,
rather than sequential, order.
RDM will appear on the
display.
Press SEEK-TUNE while RDM is on the
display to randomly seek through discs and tracks. Press
RDM again to turn off random play. (This button is not
available on the standard AM-FM Stereo radio.)
SIDE: Press this button to select the next disc in the
changer. Each time you press this button, DISC
LOADING will appear on the display (does not appear on
the standard AM-FM Stereo radio) and the disc number on
the radio display will move to the next available CD.
SOURCE: Press this button if you have a disc loaded in
the changer and the radio is
on, to play a compact disc.
To return to playing the radio, press BAND. Pressing
SOURCE also switches between a tape or compact disc
if both are loaded.
EJECT Slide the CD changer door all the way open
and the disc holder will automatically eject. If ERR
or ERROR appears
on the display, an error has
occurred and the compact disc temporarily cannot play.
CD
CHANGER ERROR could be displayed for
the following:
The road is too rough. The disc should play when the
road is smoother.
0 The disc is dirty, scratched, wet or loaded label side up.
The air is very humid. If so, wait about an hour and
try again.
CHEK DOOR or CD CHANGER
DOOR OPEN is
displayed when the CD changer door is left open.
Completely close the changer door to restore
normal operation.
CD CHANGER NO DISCS
is displayed when an empty
magazine is inserted in
the CD changer. Try the
magazine again with a disc loaded
on one of the trays.
(This message does not appear in the display
on the
standard AM-FM Stereo radios.)
If any error occurs repeatedly or
if an error cannot be
corrected, please contact your dealer.
If your radio
displays an error number? write
it down and provide it to
your dealer when reporting the problem.
Page 184 of 370
Downloaded from www.Manualslib.com manuals search engine c
c1
c
P
With this feature, your vehicle will recall the latest radio
settings as adjusted the last time your vehicle was
operated. This feature allows two different drivers
to
store and recall their own radio settings. The settings
recalled by the radio are determined by which
RKE
transmitter (“1” or “2’’) was used to enter the vehicle.
The number on the back
of the RKE transmitter
corresponds
to driver 1 or to driver 2. After the unlock
button is pressed
on the RKE transmitter or the ignition
key
is placed in the ignition, the radio settings will
automatically adjust to where they were last
set. The
settings can also be changed
by briefly pressing the
memory seat buttons 1 or
2 located on the driver’s door.
Your Cadillac has
a “built-in“ theft-deterrent feature on
each radio that is automatic -- there is no programming
required. The radio in your Cadillac cannot be used in
any other vehicle besides another Cadillac if it were to
be removed.
VOLUME: Press the up
arrow lever to increase
volume and the down arrow
lever to decrease volume.
SELECT: When listening to the radio, press the up or
down arrow lever
to tune to the next or previous preset
radio station (factory presets which have not been
reprogrammed with your stations will be ignored).
When listening to a cassette tape, the up
or clown arrow
lever
can be used to SEEK forward and rearward
through the tape. Pressing the up or down arrow lever
when listening to a
CD will cause the player to go to the
next or previous selection.
3-2
Page 185 of 370
Downloaded from www.Manualslib.com manuals search engine FM stereo will give you the best sound. But FM signals
will reach only about
10 to 40 miles (16 to 65 km). Tall
buildings or hills can interfere with
FM signals, causing
the sound to come
and go.
The range for most AM stations IS greater than for FM,
especially at night. The longer range, however, can
cause stations to interfere with each other.
AM can pick
up noise from things like storms and power lines. Try
reducing the treble
to reduce this noise if you ever get it.
Hearing damage from loud noise is almost undetectable
until it
is too late. Your hearing can adapt to higher
volumes of sound. Sound that seems normal can be loud
and harmful to your hearing. Take precautions by
adjusting the volume control
on your radio to a safe
sound level before your hearing adapts to
it.
To help avoid hearing loss or damage:
Adjust the volume control to the lowest setting.
Increase volume slowly until you hear comfortably
and clearly.
NOTICE:
Before you add any sound equipment to your
vehicle -- like a tape player, CB radio, mobile
telephone or two-way radio
-- be sure you can add
what you want. If you can, it’s very important to
do it properly. Added sound equipment may
interfere with the operation
of your vehicle’s
engine, Cadillac radio
or other systems, and even
damage them. Your vehicle’s systems may interfere
with the operation
of sound equipment that has
been added improperly.
So, before adding sound equipment, check with
your dealer and be sure to check Federal rules
covering mobile radio and telephone units.
1
Page 186 of 370
Downloaded from www.Manualslib.com manuals search engine P
II
c
L
c
c
A tape player that is not cleaned regularly can cause
reduced sound quality, ruined cassettes
or a damaged
mechanism. Cassette tapes should be stored in their
cases away from contaminants. direct sunlight and
extreme heat. If they aren't, they may not operate
properly
or may cause failure of the tape player.
Your tape player should be cleaned regularly after every
50 hours of use. Your radio may display CLN or CLEAN
TAPE to indicate that you have used your tape player for
50 hours without resetting the tape clean timer. Each time
the cassette is cleaned, the
50 hour cassette timer should be
reset.
This is done by holding down the eject button for
three seconds until the
TME CLEAN message is
displayed. If you notice a reduction in sound quality, tly a
known good cassette to see
if it is the tape or the tape
player at fault.
If this other cassette has no improvement in
sound quality, clean the tape player.
Cleaning may be done
with a scrubbing action,
non-abrasive cleaning cassette with pads which scrub
the
tape head as the hubs of the cleaner cassette turn. It is
normal for the cassette to eject while cleaning. Insert the
cassette at least six times to ensure thorough cleaning. Some cleaning cassettes or
CD adapter
kits may appear
as a broken tape.
If the cleaning cassette is ejected
immediately from the tape player.
follow these steps for
the TAPE CLEAN
OVERRIDE teatur-e:
1. Turn the ignition to RUN or ACC
2. Turn the radio off.
3. Press and hold the SOL!KCE button l'or three
seconds. After three
scconds. thc tapc icon will flash
indicating the
cut tape feature is 1.10n. turned off.
4. Turn the radio on and insert the clcming cassette (or
the CD adapter kit ).
5. Eject the tape after the tape player has been cleaned.
When the cleaning cassetIe has been ejected, the broken
tape detection feature is active again.
You may also choose
a non-scrubbing action. wet-type
cleaner which uses
a cassette with a fabric belt to clean
the tape head. This type
of cleaning cassette will not
eject and, it may not clean as thoroughly
as the
scrubbing type cleaner.
Cassettes are subject
to wear and the sound quality
may degrade over time. Always make sure
the cassette
tape is
in good condition before you have your tape
player serviced.
Page 187 of 370
Downloaded from www.Manualslib.com manuals search engine Handle discs carefully. Store them in their original cases
or other protective cases and away from direct sunlight
and dust.
If the surface of a disc is soiled, dampen a
clean, soft cloth in a mild, neutral detergent solution and
clean it, wiping from the
center to the edge.
Be sure never
to touch the signal surface when handling
disc-s. Pick up discs by grasping the outer edge.s or the
edge of the hole and
the outer edge.
Your power antenna will
look its best and work
well
if it’s cleaned from time to time. To clean the
antenna mast:
1.
2.
3.
4.
5.
Turn on the ignition and radio to raise the antenna.
Dampen a clean cloth with mineral spirits
or
equivalent solvent.
Wipe the cloth over the mast sections, removing
any dirt.
Make the antenna go up and down by turning the
radio or ignition off and
on.
Repeat if necessary.
I NOTICE:
Don’t lubricate the power antenna. Lubrication
could damage it.
NOTICE:
Before entering an automatic car wash, turn off
your radio to make the power antenna
go down.
This will prevent the mast from possibly getting
damaged.
If the antenna does not go down when
you turn the radio
off, it may be damaged or
need to be cleaned. In either case, lower the
antenna by hand by carefully pressing the
antenna down.
If the mast portion of your antenna is damaged, you can
easily replace
it. See your dealer for a replacement kit
and follow
the instructions in the kit.
Page 188 of 370
Downloaded from www.Manualslib.com manuals search engine c
Page 189 of 370
Downloaded from www.Manualslib.com manuals search engine 3-3
Page 190 of 370
Downloaded from www.Manualslib.com manuals search engine c