boot CHEVROLET CAMARO 1967 1.G Chassis Owner's Manual

ACCESSORIES 15-16

Fig.
17 - Compressor, Regulator and Reservoir - Exploded View

1.
Regulator Assembly

2.
Adapter Assembly

3. Boot

4.
Sleeve

5. Piston

6. Spring

7. Retainer

8. "O" Ring

9. Valve Core

10..
Retainer, Screen

11.
Screen, Filter

12.
Adapter Assembly

13.
Adapter

14.
Valve Core

15.
"O" Ring

16..
Cap

17.
Screw, Regulator Retaining

18.
"O" Ring, Regulator to

Compressor
19.
Reservoir

20.
"O" Ring, Reservoir to

Compressor

21.
Thru Bolt, Reservoir

Retaining

22.,
Nut, Thru .Bolt Reservoir

23.
Thru Bolt, Compressor

Retaining

24.
Nut, Thru Bolt Compressor

25.
Compressor Assembly

26.
Housing, 2nd Stage

27.
Check Valve

28.
Spring

29.
Expansion Plug Retainer

30.
Housing 1st Stage

31.
Arm, Swivel

32.
Bushing

33.
Arm, Rocker .

34.
Pin, Rocker Arm Retaining
35.
Intake Valve

36,
Washer

37.
Spring, Intake Valve

Retaining

38.
Pin, Bushing

Retaining

39.
Piston Assembly

40.
Plate, Diaphragm

41.
Diaphragm

42.
Washer (.760-.765 I.D.)

43.
Retainer, Diaphragm

44.
Check Valve

45.
Spring

46.
Expansion Plug Retainer

47.
"O" Ring (.357-.367 I.D.)

48.
Seal (.569-.571)

49.
"O" Ring (.732-.742 I.D.)

50.
Seal (.943-.945)

51.
Piston
52.
Distributor Valve

53.
Bushing, Distributor Valve

54.
Washer (.160-. 163 I.D.)

55. Arm Assembly, Distributor

56. Screw

57. Spring, Valve Tension

58.
Bushing, Distributor Valve

Stop

59. Bussing, Arm Assembly

Stop

60.
Arm Actuating

61.
Spring, Arm Tension

62.
Screw, Arm Pivot

63.
Cover

64.
Gasket

65. Screw, Cover Retaining

66. Gasket, Cover

67. Mount, Flexible

68.
Adapter

NOTE: Position diaphragm retainer securely

to effect air tight seal against corprene washer.

Seals

1.
Inspect seals for evidence of excessive wear or

coring. If necessary replace seals and O-rings.

2.
Remove seals and O-rings from piston.

3.
Install new O-rings by rolling into groove. Relieve

any resulting twist.

4.
Install new seals using a piece of .020" shim stock,

(fig. 19). Make sure shim stock has no sharp edges

that may cut seal. Do not stretch seal more than
necessary to install. Seals should be installed so

they are not twisted.

Distributor Valve Mechanism and

Intake Valve (First Stage Housing)

NOTE: Actuate distributor valve with finger.

' Valve tension spring should press against dis-

tributor valve, holding it against either stop. If

valve action is not free and positive, it will be

necessary to rebuild using new parts in Distrib-

utor Valve and Arm Package. If action is free

CHEVROLET CHASSIS SERVICE MANUAL