CHEVROLET KODIAK 2007 Owners Manual

•SAE 5W-30
As shown in the viscosity chart, SAE 5W-30 is
best for your vehicle.
These numbers on an oil container show its
viscosity, or thickness. Do not use other
viscosity oils such as SAE 20W-50.
Oils meeting these
requirements should
also have the starburst
symbol on the
container. This symbol
indicates that the oil
has been certified by the
American Petroleum
Institute (API).
You should look for this information on the oil
container, and use only those oils that are
identified as meeting GM Standard GM6094M and
have the starburst symbol on the front of the oil
container.Notice:Use only engine oil identied as
meeting GM Standard GM6094M and showing
the American Petroleum Institute Certied
For Gasoline Engines starburst symbol. Failure
to use the recommended oil can result in
engine damage not covered by your warranty.
GM Goodwrench
®oil meets all the requirements
for your vehicle.
If you are in an area of extreme cold, where the
temperature falls below−20°F (−29°C), it is
recommended that you use either an SAE 5W-30
synthetic oil or an SAE 0W-30 oil. Both will
provide easier cold starting and better protection
for the engine at extremely low temperatures.
Engine Oil Additives
Do not add anything to the oil. The recommended
oils with the API service symbol are all you will
need for good performance and engine protection.
271

Engine Oil (DURAMAX®/Isuzu Diesel
Engine)
Checking Engine Oil
It is a good idea to check the engine oil level
every time you get fuel.
The engine oil dipstick
is located in the engine
compartment on the
driver’s side of the
vehicle.In order to get an accurate reading, the engine
should be at normal operating temperature, so
that the oil is warm, and the vehicle must be
on level ground.
1. If the engine is at normal operating
temperature and the oil is warm, turn off the
engine and allow at least five minutes for
the oil to drain back into the oil pan. If you do
not do this, the oil dipstick might not show
the actual level.
If the engine has not been run long enough to
bring it up to normal operating temperature
and the oil is cool, turn off the engine and allow
30 minutes for the oil to drain back into the
oil pan. If you do not do this, the oil dipstick
might not show the actual level.
2. Pull out the dipstick and clean it with a
paper towel or a cloth, then push it back
in all the way.
272

3. Remove the dipstick again, keeping the tip
down, and check the oil level.When to Add Engine Oil
If the oil is below the cross-hatched area at
the tip of the dipstick for the 6.6L V8 DURAMAX®
engine, you will need to add at least
two quarts/liters of oil. If the oil is below the
lower hole at the tip of the dipstick for the Isuzu
6H engine, you will need to add at least one
quart/liter of oil. But you must use the right kind.
This section explains what kind of oil to use.
For engine oil crankcase capacity, seeCapacities
and Specications on page 347.
Notice:Do not add too much oil. If the engine
has so much oil that the oil level gets above the
cross-hatched area for the 6.6L V8 (LLY) engine
or above the upper hole that shows the proper
operating range for the 7.8L L6 (LG4) engine,
the engine could be damaged.
6.6L V8 DURAMAX®Engine
Isuzu 6H Engine
273

Add oil at the engine oil
fill cap in the engine
compartment. Install and
fully tighten the fill
cap when you
are through.
Be sure to add enough oil to put the level
somewhere in the proper operating range. Push
the dipstick all the way back in when you are
through.What Kind of Engine Oil to Use
Look for these two things:
•CJ-4 or CI-4
Oils designated as API CJ-4 or CI-4 are
recommended for your vehicle. The CJ-4 or
CI-4 designations may appear either
alone, together, or in combination with other
API designations, such as API CJ-4/SM.
These letters show American Petroleum
Institute (API) levels of quality.
Notice:Use only engine oils that have one of
these designations, CJ-4 or CI-4, for the
diesel engine. Failure to use the recommended
oils can result in engine damage not covered
by your warranty.
274

•SAE 15W-40
As shown in the viscosity chart, SAE 15W-40
is best for your vehicle. However, you can
use SAE 10W-30 at temperatures above 0°F
(−18°C). When it is very cold, below 0°F
(−18°C), you should use SAE 5W-40 to
improve cold starting. 5W-40 is not
recommended for use at high temperatures,
above 100°F (38°C).
These numbers on the oil container show its
viscosity, or thickness. Do not use other
viscosity oils such as SAE 10W-40 or
SAE 20W-50.
This doughnut-shaped
logo (symbol) is used on
most oil containers to
help you select the
correct oil. It means that
the oil has been certified
by the American
Petroleum Institute.
You should look for this on the oil container, and
use only those oils that display this logo.
275

GM Goodwrench®oil of the recommended
viscosity grades meets all the requirements for
your vehicle.
Engine Oil Additives
Do not add anything to the oil. The recommended
oils with the API service symbol are all you will
need for good performance and engine protection.
When to Change Engine Oil (Vehicles
Without the Engine Oil Life System)
If you have the 6.6L V8 DURAMAX®Engine:
Change engine oil and filter every 15,000 miles
(24 000 km), or every 12 months, or every
750 hours of engine operation, whichever occurs
first. If you have the Isuzu 6H Engine: Change
engine oil and filter every 12,000 miles
(20 000 km), or every 12 months, or every
600 hours of engine operation, whichever occurs
first. SeeScheduled Maintenance on page 363.
Engine Oil Life System
(Gasoline Engine)
When to Change Engine Oil
Your vehicle has a computer system that lets you
know when to change the engine oil and filter.
This is based on engine revolutions and engine
temperature, and not on mileage. Based on driving
conditions, the mileage at which an oil change
will be indicated can vary considerably. For the oil
life system to work properly, you must reset the
system every time the oil is changed.
When the system has calculated that oil life has
been diminished, it will indicate that an oil change is
necessary. A change engine oil light will come on.
SeeChange Engine Oil Light on page 176. Change
your oil as soon as possible within the next
600 miles (1 000 km). It is possible that, if you are
driving under the best conditions, the oil life system
may not indicate that an oil change is necessary for
over a year. However, your engine oil and filter
must be changed at least once a year and at this
time the system must be reset. Your dealer has
GM-trained service people who will perform this
work using genuine GM parts and reset the system.
It is also important to check your oil regularly and
keep it at the proper level.
276

If the system is ever reset accidentally, you must
change your oil at 3,000 miles (5 000 km)
since your last oil change. Remember to reset the
oil life system whenever the oil is changed.
How to Reset the Engine Oil Life
System
The Engine Oil Life System calculates when to
change your engine oil and filter based on vehicle
use. Anytime your oil is changed, reset the
system so it can calculate when the next oil
change is required. If a situation occurs where you
change your oil prior to a change engine oil light
being turned on, reset the system.
To reset the change engine oil light, do the
following:
1. Turn the ignition key to RUN with the
engine off.
2. Fully press and release the accelerator pedal
slowly three times within 10 seconds.
If the change engine oil light flashes for
five seconds, the system is resetting.
3. Turn the key to OFF.
If the change engine oil light comes back on when
you start your vehicle, the engine oil life system
has not reset. Repeat the procedure.
What to Do with Used Oil
Used engine oil contains certain elements that may
be unhealthy for your skin and could even cause
cancer. Do not let used oil stay on your skin for very
long. Clean your skin and nails with soap and
water, or a good hand cleaner. Wash or properly
dispose of clothing or rags containing used engine
oil. See the manufacturer’s warnings about the use
and disposal of oil products.
Used oil can be a threat to the environment. If you
change your own oil, be sure to drain all the oil from
the filter before disposal. Never dispose of oil by
putting it in the trash, pouring it on the ground, into
sewers, or into streams or bodies of water. Instead,
recycle it by taking it to a place that collects used
oil. If you have a problem properly disposing of your
used oil, ask your dealer, a service station or a local
recycling center for help.
277

Engine Oil Life System
(DURAMAX
®Diesel)
When to Change Engine Oil
If your vehicle has the Engine Oil Life System, it
has a computer system that lets you know when to
change the engine oil and filter. This is based
on injection timing, engine load and engine
temperature, and not on mileage. Based on driving
conditions, the mileage at which an oil change
will be indicated can vary considerably. For the oil
life system to work properly, you must reset the
system every time the oil is changed.
When the system has calculated that oil life has
been diminished, it will indicate that an oil change
is necessary. A change engine oil light will
come on. SeeChange Engine Oil Light on
page 176. Change your oil as soon as possible
within the next 600 miles (1 000 km) or 30 hours of
engine operation, whichever occurs first. It is
possible that, if you are driving under the best
conditions, the oil life system may not indicate that
an oil change is necessary for over a year.However, your engine oil and filter must be
changed at least once a year and at this time the
system must be reset. Your dealer has
GM-trained service people who will perform this
work using genuine GM parts and reset the
system. It is also important to check your oil
regularly and keep it at the proper level.
If the system is ever reset accidentally, you must
change your oil at 15,000 miles (24 000 km),
or 150 hours of engine operation, whichever
occurs first, since your last oil change. Remember
to reset the oil life system whenever the oil is
changed.
How to Reset the Engine Oil Life
System
The Engine Oil Life System calculates when to
change your engine oil and filter based on vehicle
use. Anytime your oil is changed, reset the
system so it can calculate when the next oil
change is required. If a situation occurs where you
change your oil prior to a change engine oil light
being turned on, reset the system.
278

To reset the Engine Oil Life System, do the
following:
1. Turn the ignition key to RUN with the
engine off.
2. Fully press and release the accelerator pedal
slowly three times within 10 seconds.
If the change engine oil light flashes for
five seconds, the system is resetting.
3. Turn the key to OFF.
If the change engine oil light comes back on when
you start your vehicle, the Engine Oil Life
System has not reset. Repeat the procedure.
What to Do with Used Oil
Used engine oil contains certain elements that may
be unhealthy for your skin and could even cause
cancer. Do not let used oil stay on your skin for very
long. Clean your skin and nails with soap and
water, or a good hand cleaner. Wash or properly
dispose of clothing or rags containing used engine
oil. See the manufacturer’s warnings about the use
and disposal of oil products.Used oil can be a threat to the environment. If you
change your own oil, be sure to drain all the oil
from the filter before disposal. Never dispose of oil
by putting it in the trash, pouring it on the
ground, into sewers, or into streams or bodies of
water. Instead, recycle it by taking it to a place
that collects used oil. If you have a problem
properly disposing of your used oil, ask your
dealer, a service station, or a local recycling
center for help.
Engine Oil Life System
(Caterpillar
®Diesel Engine)
How to Reset the Engine Oil Life
System
The Engine Oil Life System calculates when to
change your engine oil and filter based on vehicle
use. Anytime your oil is changed, reset the
system so it can calculate when the next oil
change is required. If a situation occurs where you
change your oil prior to a change engine oil light
being turned on, reset the system.
279

To reset the Engine Oil Life System, do the
following:
1. Turn the ignition key to RUN with the
engine off.
2. Fully apply and hold the brake pedal while
you fully press and release the accelerator
pedal, pausing slightly at each press and each
release, three times within five seconds.
3. Turn the key to OFF.
If the change engine oil light comes back on when
you start your vehicle, the Engine Oil Life
System has not reset. Repeat the procedure.
Engine Air Cleaner/Filter
The engine air
cleaner/filter is located
in the center of the
engine compartment.
When to Inspect the Engine Air
Cleaner/Filter
If your vehicle has an
air cleaner/filter change
indicator, inspect the
indicator at every
oil change and replace
the filter when the
indicator tells you to.
For vehicles without a change indicator, inspect
the air cleaner/filter at every oil change and
replace the filter at the first oil change after
25,000 miles (40 000 km).
How to Inspect the Engine Air
Cleaner/Filter
Locate the filter change indicator. When the
change indicator turns black or is in the red/orange
change area, replace the filter and reset the
indicator.
280