run flat CHRYSLER VOYAGER 2020 Vehicle Warranty
Page 75 of 270
•If an unusual vibration or vehicle handling difficulty arises, stop
driving as soon as safely and reasonably possible. The tire may be
about to suddenly fail. Release the accelerator and gradually reduce
speed. The tire will need to be replaced before proceeding.
• If towing a trailer, stop driving as soon as safely and reasonably
possible. In this condition, it is potentially dangerous to operate a
vehicle/trailer combination. If possible, disconnect the trailer and
proceed as noted above. Do not continue to tow any trailer until proper
tire service or replacement has been performed.
• Do not touch a tire recently run-low or run-flat (it may be very hot).
Allow the tire to cool before handling.
DISTANCE—HOW FAR YOU CAN DRIVE
Factors affecting run-flat or low tire pressure operating distance include
vehicle speed, load, and maneuvering; the amount of inflation pressure
loss; the extent of any tire damage; and ambient temperature.
The tire may be marked on the sidewall with run-flat or low tire pressure
operating speed and/or distance limitations, which vary by tire design
and vehicle application (consult your vehicle owner ’s manual). By
international standard, RFT tires have a baseline limitation in run-flat
mode of the following:
Maximum Speed: 50 mph (80 km/h)
Maximum Distance: 50 miles (80 km)
NOTE:
•Maximum distance values are determined under controlled condi-
tions, which may vary in actual use.
• Your mileage capability may be less, or more, depending on your
specific operating conditions.
• If in doubt, do not exceed the 50 mile (80 km) limitation.
• Seek tire service as soon as possible to minimize tire damage.
BRIDGESTONE® - FIRESTONE®
74
Page 76 of 270
SPECIAL SERVICE AND REPAIR ISSUES
Run-Flat Certified Retailers
Because of the advanced technology and design of RFT tires and the
required tire pressure monitoring systems (TPMS), Bridgestone Firestone
Run-Flat Certified Retailers are specially trained to sell and service RFT
tires.
Run-Flat Certified Retailers have the necessary equipment and are
specially trained to properly mount and demount RFT tires and to handle
TPMS devices.Conventional mounting equipment may irreparably
damage RFT tires and an improper repair is unsafe and will void the
Limited Warranty. Accordingly, it is important to go to a Bridgestone
Firestone Run-Flat Certified Retailer for tire maintenance and replace-
ment.
Call toll-free 1-877-BFS-4RFT or, 877-237-4738 or visit
www.bridgestonetire.comto locate the nearest Bridgestone Firestone
Run-Flat Certified Retailer.
Inspection after Run-Flat or Low Pressure Operation
Following run-flat or low tire pressure operation, or in the event of any
other tire damage or unusual condition, it is very important to obtain a
proper and complete tire evaluation as soon as possible.
Rotation
Follow the vehicle manufacturer ’s recommendations, or rotate every
5,000 miles per the recommendations in this manual (see “Radial Tire
Rotation”). In some cases, TPMS devices require reprogramming with
each tire rotation.
RFT Tire Replacement
Do not replace or mix RFT tires with conventional tires, unless on an
emergency/temporary basis. Conventional tires do not have run-flat
capability and the handling characteristics of the vehicle with these tires
may be different. If a conventional tire is used on an emergency/
temporary basis, verify that its size, load capacity, inflation pressure, and
speed rating specifications meet the requirements of the vehicle. Replace
any conventional tire with the proper RFT tire as soon as possible.
BRIDGESTONE® - FIRESTONE®
75
Page 77 of 270
RFT Tire Damage and Repair
No tire, regardless of its design or quality is indestructible. RFT tires can
be ultimately rendered unusable due to a puncture or other road hazard
as well as from improper run-flat or low tire pressure operation. Some
punctures may be repaired under certain restrictions and prescribed
procedures.
When driven flat or with low pressure, factors affecting reparability
include vehicle speed, load, and maneuvering; the amount of inflation
pressure loss; and ambient temperature. In any situation, the extent and
location of direct damage from a puncturing object or other road hazard
are also critical factors.
RFT tires are not repairable in any of the following situations:
•If the tire was operated with inflation pressure less than 15 psi
(100 kPa).
• Abrasion or other damage is present on the exterior tread, sidewall or
bead areas.
• Abrasion, wrinkling, or separation is present on the tire interior.
• Any condition or damage is present that disqualifies repair of a
conventional tire.
Run-Flat Certified Retailers will fully inspect your tire, inside and out, to
determine if the tire can be repaired. Ti re damage is not always visible
from the outside and the tire must be removed from the wheel for a
complete inspection. For more information, see the section “Tire Repairs”