boot Citroen C1 2008.5 1.G Owner's Manual

3
37
COMFORT
Returning the back of the
bench seat to its initial
position:
- fold the seat back rearwards and secure it on the mounting B .

Take care not to trap the seat belts,
in particular between the seat back
and the mounting B.
- check that the back of the bench seat is secured correctly.
REAR HEAD RESTRAINTS *
The rear head restraints can be
removed and have two positions:
- high, position for use.
- low, storage position.
To raise the head restraint, pull it
upwards.
To lower it, press lug A then the head
restraint.
To remove it:
- tilt the seat back slightly,
- move the head restraint to the high position,
- press lug A pulling the head
restraint upwards at the same
time.
To refi t it:
- tilt the seat back slightly,
- engage the rods of the head restraint in the openings.
To reach the low position, press lug A .
Folding the back of the bench
seat:
The seat back is folded from the rear
of the vehicle, with the boot open:
- check that the seat belt is positioned
correctly on the side of the seat
back to avoid damaging it,
- place the head restraints in the low position (see "rear head
restraints"),
- while folding the seat back, pull the strap(s) A , located behind the
seat back.
* According to version.

4
46
ACCESS
KEYS/REMOTE CONTROL
Remote control
This carries out the vehicle locking - unlocking and locating functions at a distance.
Keys
The keys allow you to switch on the
ignition and operate the locks on the
front doors, the boot, the fuel tank cap,
the steering lock and the passenger
air bag deactivation switch.
Locking
Press button A to lock the vehicle from Aa distance. This is confi rmed by brief lighting of the direction indicators.
Central locking and unlocking
From the driver's door, the keys allow
you to lock and unlock the doors and
boot simultaneously.
Unlocking
Press button B to unlock the vehicle.
This is confi rmed by two successive fl ashes of the direction indicators.
Locating the vehicle
To locate your vehicle in a car park, if
you have locked it:

 press button A , the direction
indicators come on briefl y.
Note: after locking, if you notice that a door is not closed properly, close it then lock the vehicle again.
The set of keys or remote
controls, supplied with your
vehicle, enable you to obtain
a maximum of three new
keys.
If all of the keys in your possession
are lost, a major operation will have
to be carried out on your vehicle.
Consult a CITROËN dealer.

4
48
ACCESS ELECTRIC WINDOWS
The driver and front passenger each
have an electric window.
After the ignition has been switched
on, press or pull control 1 . The window
stops when you release the control.
Always remove the key from
the ignition when leaving
the vehicle, even for a short
time.
The driver must ensure that the front
passenger uses his electric window
correctly.
Be aware of children when operating
the windows.
DOORS

Simultaneous central locking/
unlocking of the doors and boot.
To lock/unlock the vehicle, press/pull
button A on the driver's door.
For the other doors, carry out the
same operation as for normal locking/
unlocking.
Driver's door open
If the driver's door is open,
the courtesy lamp remains
on if the button is in this
position.
Locking/unlocking a door
from the inside

Normal locking/unlocking: the
doors lock/unlock independently.
To lock/unlock a door, press/pull
button A .

Note: operating the handle does
not unlock the door, pull button A to
unlock.

4
49
ACCESS
CHILD LOCK
This prevents the opening of each of
the rear doors from the inside.
Push control 1 towards the outside of
the vehicle.
LOCKING/UNLOCKINGTHE BOOT USING THE KEY*
To open, operate the lock B using the
key and raise the tailgate.
LOCKING/UNLOCKINGTHE BOOT USING THE REMOTE CONTROL *
The boot is locked/unlocked using
the buttons on the remote control.
Then, to open, press button C and raise
the tailgate.

Note: the boot can be locked/unlocked
using control A on the driver's door.
REAR WINDOWS(5-DOOR)
To partially open the rear windows,
pull the lever then push the window.
To close the window, pull then press
the lever to lock the window.
Check the status of this safety
device before switching on
the ignition.
This system is independent
of the central locking.
Always remove the key from the ignition
when leaving the vehicle. * According to version.

4
49
ACCESS
CHILD LOCK
This prevents the opening of each of
the rear doors from the inside.
Push control 1 towards the outside of
the vehicle.
LOCKING/UNLOCKINGTHE BOOT USING THE KEY*
To open, operate the lock B using the
key and raise the tailgate.
LOCKING/UNLOCKINGTHE BOOT USING THE REMOTE CONTROL *
The boot is locked/unlocked using
the buttons on the remote control.
Then, to open, press button C and raise
the tailgate.

Note: the boot can be locked/unlocked
using control A on the driver's door.
REAR WINDOWS(5-DOOR)
To partially open the rear windows,
pull the lever then push the window.
To close the window, pull then press
the lever to lock the window.
Check the status of this safety
device before switching on
the ignition.
This system is independent
of the central locking.
Always remove the key from the ignition
when leaving the vehicle. * According to version.

4
50
ACCESS
BOOT
2. Spare wheel/Additional storage compartments
Located under the carpet and a
plastic cover, this contains the tools
for wheel changing and towing.
There are two shelf storage options:
- either behind the rear seats,
- or fl at in the boot.
1. Rear shelf
To remove the shelf:
- unhook the shelf from its fi xing
A ,
- pull upwards on each side to detach it from its fi xings,
- raise then tilt the shelf slightly to remove it. In order to obtain additional
space, the spare wheel can be
removed temporarily (boot tray
available as an accessory).

9
69
PRACTICAL INFORMATION
Parking the vehicle

 As far as possible, immobilise
the vehicle on level, stable, non-
slippery ground.

 Apply the parking brake, switch
off the ignition and engage fi rst
gear or reverse for the manual
gearbox, position N for the
"SensoDrive" gearbox. Tools
The following tools are installed in a
carrier, located in the centre of the
spare wheel:

1. Wheelbrace

2. Jack with handle

3. Removable towing eye
Access to the spare wheel and
the jack in the boot

 Remove the carpet then the
plastic cover using the handle. Tyre pressures
These are indicated on the label
positioned on the inner pillar of the
left door, see "Identifi cation".
CHANGING A WHEEL

 If necessary, chock the wheel
diagonally opposite the wheel to
be changed.

 It is imperative that you ensure that
the occupants get out of the vehicle
and wait in a safe location.

9
71
PRACTICAL INFORMATION
CHANGING A BULB
1. Sidelamps (W 5 W)

 Turn the bulb holder A one quarter
of a turn and remove it.

 Remove the bulb and change it.
2. Direction indicators (PY 21 W amber)


Turn the bulb holder B one quarter
of a turn and remove it.

 Turn the bulb one quarter of a
turn.

 Remove the bulb and change it.
If you encounter any diffi culties,
contact a CITROËN dealer.
Note: in certain climatic con-
ditions (low temperatures,
humidity), the presence of
condensation on the inter-
nal face of the headlamps is normal ;
it disappears a few minutes after the
lights are switched on.
Never go underneath a
vehicle supported only by a
jack (use an axle stand).

4. Fold the jack 2 and detach it.

5. Tighten the wheel bolts using the
wheelbrace 1 .

6. Refi t the trim.

7. Store the tools and the wheel in
the boot.
The jack and the tool kit are specifi c
to your vehicle. Do not use them for
other purposes.
After changing a wheel:
- have the tighteness of the bolts and the pressure of the spare wheel
checked as soon as possible,
- have the punctured wheel repaired and refi t it on the vehicle
as soon as possible.
Consult a CITROËN dealer. Front lamps

1. Sidelamps

2. Direction indicators

3. Dipped headlamps/Main beam
headlamps

9
71
PRACTICAL INFORMATION
CHANGING A BULB
1. Sidelamps (W 5 W)

 Turn the bulb holder A one quarter
of a turn and remove it.

 Remove the bulb and change it.
2. Direction indicators (PY 21 W amber)


Turn the bulb holder B one quarter
of a turn and remove it.

 Turn the bulb one quarter of a
turn.

 Remove the bulb and change it.
If you encounter any diffi culties,
contact a CITROËN dealer.
Note: in certain climatic con-
ditions (low temperatures,
humidity), the presence of
condensation on the inter-
nal face of the headlamps is normal ;
it disappears a few minutes after the
lights are switched on.
Never go underneath a
vehicle supported only by a
jack (use an axle stand).

4. Fold the jack 2 and detach it.

5. Tighten the wheel bolts using the
wheelbrace 1 .

6. Refi t the trim.

7. Store the tools and the wheel in
the boot.
The jack and the tool kit are specifi c
to your vehicle. Do not use them for
other purposes.
After changing a wheel:
- have the tighteness of the bolts and the pressure of the spare wheel
checked as soon as possible,
- have the punctured wheel repaired and refi t it on the vehicle
as soon as possible.
Consult a CITROËN dealer. Front lamps

1. Sidelamps

2. Direction indicators

3. Dipped headlamps/Main beam
headlamps

9
72
PRACTICAL INFORMATION
3. Dipped headlamps/Main beam headlamps (H4 - 60/55 W)

 Disconnect the connector.

 Remove the rubber cap C .

 Push the side of the tongue D .

 Remove the bulb holder and
change the bulb.

 Refi t the bulb holder, the tongue
then the rubber cap.
If you encounter any diffi culties,
contact a CITROËN dealer.
Rear lamps

1. Brake/side
lamps
(P21/5 W)

2. Direction indicators (P21 W)

3. Reversing
lamp (P21 W),
left-
hand side
Foglamp (P21 W),
right-hand
side These 3 bulbs are changed by
removing the lamp unit:

 open the boot,

 unscrew the two lamp unit fi xing
nuts A ,

 remove the lamp unit by pulling
outwards,

 unclip the harness,