warning Citroen C1 2008.5 1.G Owner's Manual

Page 5 of 99

8
FAMILIARISATION
1. Driver's exterior mirror control

2. Instrument panel

3. Wiper stalk

4. Steering lock and ignition

5. Hazard warning lamps

6. Storage compartments

7. Diffusion grille

8. Windscreen demisting and
defrosting vent

9. Passenger's front airbag

10. Adjustable and closing side vent

11. Storage box

12. Audio equipment

13. Ventilation, heating or air
conditioning controls

14. Storage compartments

15. 12 V socket (120 W max)

16. Parking brake

17. Driver's electric window control
INSTRUMENTS AND CONTROLS

Page 11 of 99

14
FAMILIARISATION When the ignition is on, the orange
and red warning lamps come on.
When the engine is running, these
warning lamps should switch off.
If warning lamps remain on, refer to
the page concerned.

 18

A. Rev counter

B. Screen

C. Fuel gauge

 17 The dynamic stability control system
(ASR/ESP) optimises the vehicle's
road holding.
For correct operation of the system,
refer to the page concerned.

 56
Instrument panel Warning lamps ASR/ESP option

Page 12 of 99

15
Your vehicle has been approved in
accordance with the new ISOFIX
regulation.
The rear seats are fi tted with regula-
tion ISOFIX mountings.
These are three rings for each seat:
- two lower rings A , located
between the vehicle's seat back
and cushion,
- an upper ring B , referred to as
the TOP TETHER, located at
the rear of the seat back at the
bottom. The
ISOFIX child seats are fi tted
with two locks and/or a strap which
are secured easily on these rings,
indicated by labels or a mark on the
rear seat back panel.

 42
Passenger air bag deactivated

 60 If the passenger air bag is de-
activated, this warning lamp
remains on until the passen-
ger air bag is reactivated. Driver's seat belt not fastened
warning lamp

1. Insert the key.

2. Select the "OFF" position

3. Remove the key in the OFF
position. When the ignition is switched
on, the warning lamp fl ashes
until the driver fastens their
seat belt.
Above a speed of approximately
10 mph (15 km/h), the warning lamp
fl ashes accompanied by an audible
signal until the driver fastens their
seat belt.
Passenger air bag
deactivation "ISOFIX" mountings

Page 14 of 99

1
17
INSTRUMENTS and CONTROLS
INSTRUMENT PANEL

1. Total/trip distance recorder zero
reset button

2. Warning lamps and indicators
display

3. Direction indicators

4. Speedometer

5. Fuel gauge
6. Total/trip distance recorder

7. Rear foglamp indicator lamp

8. Main beam headlamps indicator
lamp

9. Dipped headlamps indicator
lamp
REV COUNTER
Approaching the maximum engine
speed, when the rev counter needle
crosses into the red zone, you must
change up.

10. " SensoDrive" gearbox gear and
gear lever positions indicator

Page 15 of 99

1
18
INSTRUMENTS and CONTROLS
WARNING LAMPS AND INDICATORS
Central STOP
warning lamp
This fl ashes for a few
seconds each time the ignition is
switched on. It is linked with the
warnings for:
- "engine oil pressure",
- "coolant temperature",

Stop immediately if this lamp
comes on with the engine running.
Consult a CITROËN dealer.
Engine oil pressure
warning lamp
This comes on each time the
ignition is switched on until
the engine is started.
If it comes on linked with the STOP
warning lamp, with the engine run-
ning, this indicates that the oil pres-
sure is too low.

Stop immediately.
Consult a CITROËN dealer.
Coolant temperature
warning lamp
This comes on for a few
seconds each time the ignition is
switched on. Anti-lock braking
system (ABS) warning
lamp
This comes on for a few seconds
each time the ignition is switched
on.
Fixed lighting indicates a malfunction
of the ABS.
However, the vehicle retains conven-
tional braking with servo-assistance.
Consult a CITROËN dealer.
Parking brake, low
brake fluid level
and braking system
warning lamp
This comes on each time the ignition
is switched on until the parking brake
is released. Electric power steering
warning lamp
This comes on for a few sec-
onds each time the ignition is
switched on.
Fixed lighting, when the vehicle is
moving, indicates a malfunction of
the electric steering system.
Consult a CITROËN dealer.
If this warning lampcomes on, with
the engine running, this indicates
an abnormal increase in the coolant
temperature.

Stop immediately .
Check the coolant level.
To do this, wait until the engine has
cooled before topping up the level.
The cooling system is pressurised.
When checking the level, and
to avoid any risk of scald-
ing, unscrew the cap 1/4 of
a turn to allow the pressure
to drop.
When the pressure has dropped, re-
move the cap.
Then:

1. top up, if necessary (see
"Levels").

2. or, if the level is satisfactory,
contact a CITROËN dealer. Fixed lighting, with the engine run-
ning, indicates one of the following:
- that the parking brake is applied
or has not been released fully,
when the vehicle is moving,
- an excessive drop in the brake fl uid level (if the warning lamp
remains on even with the parking
brake released),
- a braking system fault.

Stop immediately.
Consult a CITROËN dealer.

Page 16 of 99

1
19
INSTRUMENTS and CONTROLS
Battery charge warning
lamp
This comes on each time the
ignition is switched on until
the engine is started.
Fixed lighting, with the engine run-
ning, indicates a malfunction.
Consult a CITROËN dealer.
Driver’s seat belt not
fastened warning lamp *
When the ignition is switched
on, the warning lamp fl ashes until the
driver fastens his seat belt.
Above a speed of approximately
10 mph (15 km/h), the warning lamp
fl ashes accompanied by an audible
signal until the driver fastens their
seat belt.
The driver must ensure that all pas-
sengers have fastened their seat belt
correctly.
Airbags warning lamp
This comes on for a few sec-
onds each time the ignition is
switched on.
Flashing of this warning lamp indi-
cates a malfunction of the airbags.
They may no longer be triggered in
the event of a serious impact.
Consult a CITROËN dealer. Passenger airbag deactivated
If the passenger air bag is disarmed,
the warning lamp remains on.
SensoDrive gearbox
warning lamp
Fixed lighting of this warn-
ing lamp, with the engine running,
indicates a malfunction of the Senso-
Drive gearbox.
Emission control
system warning lamp
This comes on each time the
ignition is switched on until
the engine is started.
Fixed lighting, with the engine run-
ning, indicates an emission control
system fault.
Consult a CITROËN dealer. Diesel engine pre-heat
warning lamp
Wait until the warning lamp is
switched off before starting.
If the temperature is suffi cient, the
warning light comes on briefl y, you
can start without waiting.
Water in diesel filter
warning lamp **
This comes on for a few
seconds each time the ignition is
switched on.
Fixed lighting, with the engine run-
ning, indicates a risk of damage to
the engine.
Consult a CITROËN dealer.
* According to version.
Note: it may also come on if
you run out of fuel (see "Run-
ning out of fuel").
** According to country.
Dynamic stability
control system
(ASR/ESP) activation
warning lamp
This comes on for a few seconds each
time the ignition is switched on.
With the engine running and the ve-
hicle moving, it comes on if the sys-
tem is activated. Dynamic stability
control system
(ASR/ESP) fault
warning lamp
This comes on for a few seconds each
time the ignition is switched on.
If this warning lamp comes on, with
the engine running, this indicates a
fault in the system.
Consult a CITROËN dealer.

Page 19 of 99

1
21
INSTRUMENTS and CONTROLS
Operating mode:

1st gear

2nd gear

3rd gear

4th gear

5th gear
If this warning lamp comes
on, with the engine running,
this indicates a malfunction of
the "
SensoDrive
" gearbox. Fuel gauge
This indicates the quantity of fuel
available:
-
1/1 and six segments, the fuel
tank is full.
- R and one segment fl ashing, the
fuel tank is on the reserve.
Low fuel level
When the minimum level in the fuel tank
is reached, the last segment fl ashes ac-
companied by an audible signal.
In certain driving conditions and depend-
ing on the engine, the distance which
can be travelled with the fuel remaining
may be less than 30 miles (50 km).

You have approximately 5 litres remaining.
When the frequency of the fl ashing in-
creases, you have approximately 3 litres
remaining .
At least 5 litres must be added
after running out of fuel. Running out of diesel fuel
After running out of fuel, you
can travel a short distance
after 10 pump repriming op-
erations (see corresponding
section).
After fi lling the fuel tank (mini-
mum 5 litres), operate the repriming
pump at least 10 times (see corre-
sponding section).

"!" warning
lamp
Consult a CITROËN dealer.

Page 55 of 99

4
51
ACCESS
FILLING THE FUEL TANK

 Open the fuel fi ller fl ap.

 Insert the key, turn it slightly to the
left then return to the right. The
key returns to its initial position
and the cap is unlocked.
Low fuel level
When the fuel tank minimum
level is reached, the last
segment fl ashes, accompanied
by an audible signal.

You have approximately 5 litres
remaining.
In certain driving conditions and depending
on the engine, the distance which can be
travelled with the fuel remaining may be
less than 30 miles (50 km).
When the frequency of the fl ashing
increases, you have approximately
3 litres remaining .
 Unscrew the cap and hook it onto
the clip located on the inside of
the fl ap.
A label affi xed on the inside of the
fl ap reminds you which type of fuel
to use.
When you fi ll the fuel tank, do not
continue after the 3rd cut-off of the
pump. This could cause malfunctions.

 Remove the key.

Note : if you run out of fuel,
the emission control system
warning lamp may come on
on the instrument panel. It
will switch off automatically after the
engine has been started a few times.
The fuel tank must be fi lled

with the engine switched
off .
The capacity of the fuel tank is
approximately 35 litres.

 After fi lling the fuel tank, screw
the cap back on fully to the right
until it clicks and close the fl ap.

Page 59 of 99

6
55
SAFETY
HORN
Press one of the spokes of the
steering wheel.
HAZARD WARNING LAMPS
Press the button, the direction
indicators fl ash.
They can operate with the ignition
off.
ANTI-LOCK BRAKING SYSTEM (ABS) AND EBFD AND CSC * BRAKING SYSTEMS
The ABS, in conjunction with
the EBFD and CSC * braking
systems, increases the stability
and manoeuvrability of your vehicle
on braking and provides improved
control, in particular on poor or
slippery road surfaces.
The ABS prevents wheel lock in the
event of emergency braking.
The EBFD and CSC * systems
provide full control of the braking
pressure wheel by wheel. A
distribution between:
- the front and the rear in the case of the EBFD (Electronic Brake
Force Distribution),
- the left and the right in the case of the CSC * (Cornering Stability
Control).
When the vehicle is being
driven, illumination of this
warning lamp indicates that
the parking brake is still on
or has not been properly
released.

When parking on a slope,
direct your wheels towards
the pavement and pull the

parking brake
.
PARKING BRAKE
Applying
Pull the parking brake to immobilise
your vehicle.

Note: when changing wheels
(tyres), make sure that these
are approved.
The anti-lock braking system
comes into operation automatically
when there is a risk of wheel lock.
* The CSC system is linked with the EBFD on vehicles which are not
fi tted with ASR/ESP systems.
Releasing
Pull on the handle and press the
button to release the parking brake.

Page 60 of 99

6
55
SAFETY
HORN
Press one of the spokes of the
steering wheel.
HAZARD WARNING LAMPS
Press the button, the direction
indicators fl ash.
They can operate with the ignition
off.
ANTI-LOCK BRAKING SYSTEM (ABS) AND EBFD AND CSC * BRAKING SYSTEMS
The ABS, in conjunction with
the EBFD and CSC * braking
systems, increases the stability
and manoeuvrability of your vehicle
on braking and provides improved
control, in particular on poor or
slippery road surfaces.
The ABS prevents wheel lock in the
event of emergency braking.
The EBFD and CSC * systems
provide full control of the braking
pressure wheel by wheel. A
distribution between:
- the front and the rear in the case of the EBFD (Electronic Brake
Force Distribution),
- the left and the right in the case of the CSC * (Cornering Stability
Control).
When the vehicle is being
driven, illumination of this
warning lamp indicates that
the parking brake is still on
or has not been properly
released.

When parking on a slope,
direct your wheels towards
the pavement and pull the

parking brake
.
PARKING BRAKE
Applying
Pull the parking brake to immobilise
your vehicle.

Note: when changing wheels
(tyres), make sure that these
are approved.
The anti-lock braking system
comes into operation automatically
when there is a risk of wheel lock.
* The CSC system is linked with the EBFD on vehicles which are not
fi tted with ASR/ESP systems.
Releasing
Pull on the handle and press the
button to release the parking brake.

Page:   1-10 11-20 next >