remove seats CITROEN C3 DAG 2009 Owners Manual

Page 51 of 207

3
COMFORT
Additional adjustments
Head restraint height adjustment

 To raise the head restraint, pull it for-
wards and upwards at the same time.


To remove the head restraint, press the
lug A and pull the head restraint upwards.

 To put the head restraint back in
place, engage the head restraint
stems in the openings keeping them
in line with the seat back.

 To lower the head restraint, press
the lug A and the head restraint at
the same time. Heated seats control
With the engine running, the front seats
can be heated separately.

 Use the adjustment dial, placed on
the side of each front seat, to switch
on and select the level of heating re-
quired:

0
: Off.

1
: Low.

2
: Medium.

3
: High.
The head restraint is fi tted with
a frame with notches which pre-
vents it from lowering; this is a
safety device in case of impact.

The adjustment is correct
when the upper edge of the
head restraint is level with the
top of the head.
Never drive with the head re-
straints removed; they must be
in place and adjusted correctly.

Page 52 of 207

3
COMFORT
REAR SEATS
Bench seat with fi xed one-piece cush-
ion and split backrest (left hand 2/3,
right hand 1/3) which can be folded in-
dividually to adapt the load space in the
boot.
Rear head restraints
These have a high position (comfort)
and a low position (rear visibility). Folding the backrest

 Move the corresponding front seat
forward if necessary.

 Check that the seat belt is positioned
correctly on the side of the seat back.

 Place the head restraints in the low
position.
Repositioning the seat backrest
When repositioning the rear seat back-
rest:

 Straighten the seat back 2 and se-
cure it.


Check that the red indicator, located next
to the control 1 , is no longer visisble.
They can also be removed.
To remove a head restraint:

 release the backrest using control 1 ,

 tilt the backrest 2 slightly forwards,

 pull the head restraint upwards to
the stop,

 then, press the lug A .
When repositioning the seat
backrest, take care not to trap
the seat belts.
Never drive with the head re-
straints removed; they must be
in place and correctly adjusted.
 Pull control 1 forwards to release
the seat back 2 .


Fold the seat back 2 on to the cushion.