fuse Citroen C3 PICASSO 2008.5 1.G User Guide

126
PRACTICAL INFORMATION
Engine compartment fuses
The fuse box is placed in the engine
compartment near the battery (left-hand
side).
Access to the fuses

 Unclip the cover.

 Change the fuse (see correspond-
ing paragraph).

 When you have fi nished, close the
cover carefully to guarantee the
sealing of the fuse box. Fuse table

Fuse N° Rating Functions

F1 20 A Engine control unit supply, cooling fan unit control,
multifunction engine control main relay.

F2 15 A Horn.

F3 10 A Front/rear wash-wipe.

F4 20 A Daytime running lamps.

F5 15 A Diesel heater (diesel engine), fuel pump (petrol
engine).

F6 10 A ABS/ESP control unit, ABS/ESP cut-off relay,
secondary stop switch.

F7 10 A Electrical power steering.

F8 25 A Starter control.

F9 10 A Switching and protection unit.

F10 30 A Diesel engine injection pump valve, injectors and
ignition coils (petrol engine).

F11 40 A Air conditioning blower.

127
PRACTICAL INFORMATION

Fuse N° Rating Functions

F12 30 A Windscreen wipers slow/fast speed.

F13 40 A Built-in systems interface supply (ignition positive).

F14 30 A Valvetronic supply (petrol).

F15 10 A Right-hand main beam headlamp.

F16 10 A Left-hand main beam headlamp.

F17 15 A Left-hand dipped headlamp.

F18 15 A Right-hand dipped headlamp.

F19 15 A Multifunction engine control supply (petrol engine),
air cooling solenoid valves (Diesel).

F20 10 A Multifunction engine control supply (petrol engine),
Turbo pressure regulation valve (Diesel), engine
coolant level detector (Diesel).

F21 5 A Fan assembly control supply, APC, ABS ESP
relays.

128
PRACTICAL INFORMATION
Table of maxi-fuses

Fuse N° Rating
Functions

MF1 * 60 A Fan assembly.

MF2 * 30 A ABS/ESP control unit.

MF3 * 30 A ABS/ESP control unit.

MF4 * 60 A Built-in Systems Interface (BSI) supply.

MF5 * 60 A Built-in Systems Interface (BSI) supply.

MF6 * - Not used.

MF7 * - Passenger compartment fusebox.

MF8 * - Not used.
* The maxi-fuses provide additional protection for the e lectrical systems. All work on the maxi-fuses must be carried out by a
CITROËN dealer.

129
PRACTICAL INFORMATION
BATTERY
Procedure for charging your battery
when it is fl at or for starting the engine
using another battery.
Access to the battery Starting using another battery

 Connect the red cable to the posi-
tive terminal (+) of the fl at battery A ,
then to the positive terminal (+) of
the slave battery B .

 Connect one end of the green or black
cable to the negative terminal (-) of
the slave battery B .

 Connect the other end of the green or
black cable to the negative terminal (-)
of the fl at battery A .

 Start the slave vehicle.

 Operate the starter of the broken
down vehicle and let the engine
run.

 Wait until the engine returns to idle
and disconnect the cables.
The battery is located under the bonnet.
To gain access to it:

 open the bonnet using the interior
lever, then the exterior lever,

 secure the bonnet strut,

 remove the plastic cover to gain
access to the two terminals,

 unclip the fuse box to remove the
battery, if necessary.