Lock indicator Citroen C3 PICASSO 2013 1.G Owner's Manual

Page 4 of 284

.
.
Contents
Conventional child seats 104
Isofi x child seats 110
Child lock 113
Child safety
Instrument panel 22
Indicator and warning lamps 23
Indicators 31
Adjustment buttons 34
Monitoring Familiarisation
Screen without audio equipment 35
Screen with audio equipment 37
Tr i p c o m p u t e r 47
Multifunction screens
Ventilation 50
Rear screen demist/defrost 52
Heating 53
Manual air conditioning 53
Dual-zone digital air conditioning 55
Scented air freshener 58
Front seats 59
Rear seats 62
Mirrors 64
Steering wheel adjustment 65
Comfort
Remote control key 66
Window controls 70
Doors 72
Boot 75
Panoramic sunroof 76
Fuel tank 77
Misfuel prevention (Diesel) 79
Access
Lighting controls 80
LED lamps 84
Cornering lighting 85
Headlamp adjustment 86
Wiper controls 87
Courtesy lamps 90
Boot lamp 92
Visibility
Front fi ttings 93
Rear fi ttings 97
Boot fi ttings 100
Fittings Eco-driving

Page 7 of 284

.Familiarisation
5

Remote control key
A.Unfolding / Folding the key.
Lockin
g(press; fixed lighting of the direction
indicators).

Panoramic glass sunroof

Lift the handle of the blind concerned andrelease.
Each blind is fitted with a roller in which it isstored when you release it.
Unlockin
g of the vehicle (rapid flashing of the direction
indicators).
6
6
76

Fuel t ank
77
1.
Opening the fuel filler flap. 2.Opening and hooking the fuel filler cap.

Capacity of the tank:


- approximately 50 litres (petrol),

- approximately 48 litres (Diesel),

- (depending on version: approximately 30 litres (petrol or Diesel), approximately33 litres (LPG)).

Opening

Page 17 of 284

.Familiarisation
15

Tr a n s l u c e n t d igital
instrument panel


Switch panels

If the levels are not correct, top up the levels
which are low.A.With the ignition on, the level of fuelremaining is displayed in the digitalinstrument panel B. With the ignition on, the oil level indicator should display "OIL OK"for a few seconds. Li
ghting of the indicator lamp indicates the status of the corresponding function.A.Deactivation of the ESP/ASR system. With the i
gnition on, the orange and red
warning lamps come on.
With the engine running, these warning lampsshould go off almost immediately, with theexception of the warning lamp C(passenger's front airbag activated) which goes off after
approximately one minute.
I
f warning lamps remain on, refer to the
relevant page.

Warning lamps

Monitoring
2223117
141
73
134
B. Deactivation of the rear parking sensors.
C.
Central locking.
D.Deactivation of Stop & Start.

Page 24 of 284

Monitoring
22

















Petrol - Diesel instrument panel
Panel grouping together the digital indicator, the multifunction screen and the vehicle operation
indicator lamps.
1.Rev counter.Indicates the speed of rotation of the
engine (x 1000 rpm). 2. Rev counter zone indicating that you must change up a gear.
3.Speed limiterror

Cruise control.(mph or km/h) 4.Electric child lock indicator lamp.Indicates, for a few seconds, the activation
of the electric child lock (deactivation of the rear windows and doors).
Tr a n s l u c e n t d igital instrument panel
This screen groups together the warning and
information messages.

Multifunction screen

Indicator lamps display zone
This zone groups together the vehicle operation indicator lamps.


Display zero reset button

This permits resetting of the function selected
to zero (trip distance recorder or ser vice
indicator).

Instrument panel lighting button

This adjusts the brightness of the lighting of theinstruments and controls. 5
.Fuel level. Indicates the quantity of fuel remaining in
the tank.
6. Vehicle speed. Indicates the current speed of the moving
vehicle (mph or km/h). 7.Trip distance recorder. (miles or km) 8.Service indicator. (miles or km) then,
Distance recorder. (miles or km) 9.Engine oil level indicator.
For more information, refer to the paragraph relating to the button or function and its associated display.

Page 30 of 284

Monitoring
28
Warning lampis onCauseAction / Observations
Anti-lockBraking System(ABS)
fixed. The anti-lock braking system has a
fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a CITROËN dealer or a qualified workshop without
delay.
Dynamic stability control(ESP/ASR)
flashing. The ESP/ASR regulation is active. The system optimises traction and improves the
directional stability of the vehicle.
fixed. Unless it has been deactivated(button pressed and its indicator lamp
on) the ESP/ASR system has a fault. Have it checked b
y a CITROËN dealer or a qualified
workshop.
Engine autodiagnosis system
flashing.The engine management system hasa fault. Risk of destruction of the catalytic conver ter.
Have it checked by a CITROËN dealer or a qualified
workshop.
fix
ed. The emission control system has a
f
ault.
The warning lamp should go off when the engine is started.
If it does not
go off, contact a CITROËN dealer or qualified
workshop without delay.
Brakingfixed, associated with
the STOP warning
lamp. The braking system fluid level is too
low.You must stop as soon as it is safe to do so.
Top up with brake fluid recommended by CITROËN.
If the problem persists, have the system checked by a
CITROËN dealer or a qualified workshop.

+ fixed, associated with
the
STOP and ABS
warning lamp.Th
e electronic brake force distribution(EBFD) system has a fault.You must stop as soon as it is safe to do so.
Have it checked by a CITROËN dealer or a qualified
workshop.

Page 34 of 284

Monitoring
32
Service indicator zero reset
After each ser vice, the ser vice indicator mustbe reset to zero.
The procedure for resetting to zero is asfollows: )
switch off the ignition,)
press and hold the trip distance recorder
zero reset button,
) switch on the ignition; the distance recorder
display begins a countdown, ) when the display indicates "=0", release
the button; the spanner disappears.
Service overdue
A few seconds after the ignition is switched
on, the distance recorder resumes its normaloperation. The spanner remains on.

Retrieving the serviceinformation

You can access the ser vice information at anytime. )Press the trip distance recorder zero reset button.
The ser vice information is displayed for afew seconds, then disappears.
The distance remaining may be weighted by the time factor, dependingon the type of driving.
Therefore, the spanner may also comeon if you have exceeded the time interval since the last service, indicatedin the ser vicing and warranty booklet.

Following this operation, if you wish todisconnect the battery, lock the vehicleand wait at least five minutes for thezero reset to be taken into account. For a
few seconds after the ignition is switchedon,the spanner flashes to indicate that the
ser vice must be carried out as soon as possible. Example:the ser vice is overdue by 180 miles(300 km).
For a few seconds after the ignition is switched
on, the display indicates:

Page 68 of 284

Access
66















Remote control key
System which permits central unlocking or locking of the vehicle using the lock or from a distance. It is also used to locate and start the vehicle, as well as providing protection against theft.
Unfolding the key
)First press this button to unfold the key.

Unlocking the vehicle
)
Press the open padlock to unlock
the vehicle.

Unlocking using the key
)
Turn the key to the left in the driver's door lock to unlock the vehicle.
Unlocking is confirmed by rapid flashing of
the direction indicators for approximately twoseconds.
According to version, the door mirrors unfold at
the same time.
Unlocking using the remote control
Locking the vehicle
)Press the closed padlock to lock
the vehicle.



Locking using the key
)
Turn the key to the right in the driver's door lock to lock the vehicle completely.


Locking using the remote control

If one of the doors or the boot is stillopen, the central locking does not takeplace.
When the vehicle is locked, if it isunlocked inadvertently, it will relock automatically after thir ty secondsunless a door or the boot is open.

The folding and unfolding of the door mirrors using the remote control can bedeactivated by a CITROËN dealer or a qualified workshop.
Lockin
g is confirmed by fixed lighting of
the direction indicators for approximatelytwo seconds.
According to version, the door mirrors fold at
the same time.

Page 69 of 284

4
Access
67
Locating your vehicle
)Press the closed padlock to locate your locked vehicle in a car park.
This is indicated by lighting of the cour tesylamps and flashing of the direction indicators for a few seconds.
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched
on, this code must be recognised in order for
starting to be possible.
This electronic engine immobiliser locks the
engine management system a few minutes after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
Anti-theft protection
In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.

Folding the key
)First press this button to fold the key.
If you do not press the button when foldingthe key, there is a risk of damage to themechanism.

Ignition switch



- Position 1: Stop

- Position 2: Ignition

- Position 3: Starting


Starting the vehicle

)
Inser t the key in the ignition switch.
The system recognises the star ting code.) Turn the key fully towards the dashboard toposition 3 (Starting).)
When the engine starts, release the key.
In this case,
your vehicle will not start; contact a CITROËN dealer as soon as possible.
Keep safely the label attached to the keys given
to you on acquisition of the vehicle.

Page 73 of 284

4
Access
71

Reinitialisation
Deactivating the rear window and door controls
)For the safety of your children, pressswitch 5to prevent operation of the rear windows irrespective of their position.
With the indicator lamp on, the rear controls aredeactivated.
With the indicator lamp off, the rear controls are
activated.
When the
function is activated,
this warning lamp lights up on the
instrument panel for a few seconds.
This control also deactivates the interior rear door controls (see "Child safety - Electric child lock" section).


In the event of contact during operationof the windows, you must reverse themovement of the window. To do this, pressthe switch concerned.
When the driver operates the passenger
electric window switches, they must ensure that no one is preventing correct closing of the windows.
The driver must ensure that the passengers use the electric windows correctly.
Be aware of children when operating thewindows.


Safety anti-pinch

The one-touch electric windows are fitted with
a safety anti-pinch function.
When the window rises and meets an obstacle, it stops and partially lowers again.
In the event of unwanted opening of the window on closing (for example in the presence of frost): )
press the switch until it openscompletely, )
then pull it immediately until itcloses, )
continue to hold the switch for approximately one second after thewindow has closed.
The safety anti-pinch function is not active during these operations.

In the event of a malfunction you must reinitialise
the o
peration of the electric windows: ) release the switch and pull it again until the
window closes completely, ) hold the switch for approximately onesecond after closing,
)
press the switch to lower the window
automatically.
The safety anti-pinch function is not active
during these operations. Always remove the key from the ignition when
leaving the vehicle, even for a shor t time.

Page 75 of 284

4
Access
73
Manual centralised control

Locking
)Press button Ato lock the vehicle.
The red indicator lamp on the button comes on.


Automatic centralised
control

Unlocking
)
Above 6 mph (10 km/h), press button Ato
unlock the doors and the boot temporarily.
Unlocking
) Press button A
again to unlock the vehicle.
The red indicator lamp on the button switches
off.

Locking

When the speed exceeds 6 mph (10 km/h), the doors and the boot lock automatically.
If the vehicle is locked from the outside,the red indicator lamp flashes andbutton A
is inactive.)In this case, use the remote control or the key to unlock the vehicle.



If one of the doors is open, central locking from the inside does not take place.

If one of the doors is open, theautomatic central locking does not take place.
If the boot is open, the automatic central locking of the doors is active.
System which provides full manual locking or
unlocking o
f the doors from the inside.
System which provides full automatic locking
or unlocking of the doors and the boot while
driving.
You can activate or deactivate this function.

Page:   1-10 11-20 next >