battery Citroen C3 RHD 2017 2.G Owner's Manual

Page 5 of 442

.
Driving recommendations 147
Starting / Switching off the engine with the key

1
49
Starting / Switching off the engine with Keyless Entry and Starting

1
52
Parking brake

1
55
5 -speed manual gearbox

1
56
Automatic gearbox (EAT6)

1
57
Gear ef ficiency indicator

1
61
Hill start assist

1
62
Stop & Start

1
63
Memorising speeds

1
66
Speed limit recognition

1
67
Speed limiter

1
71
Cruise control

1
74
Fatigue detection system

1
78
Lane Departure Warning System

1
79
Blind Spot Monitoring System

1
80
Parking sensors

1
83
Reversing camera

1
85
Under-inflation detection
1

86
ConnectedCAM C
ITROËN
™ 18
9
Driving
Fuel tank 192
Misfuel prevention (Diesel)
1
94
Snow chains

1
96
Towing a trailer

1
97
Energy economy mode

1
98
Changing a wiper blade

1
99
Roof bars

2
00
Bonnet
20

1
Petrol engines

2
02
Diesel engines

2
03
Checking levels

2
04
Checking components
20

8
AdBlue
® and SCR system
(BlueHDi Diesel) 2 10
AIRBUMP
® protectors 2 14
Practical information
Warning triangle 2 15
Running out of fuel (Diesel)
2
15
Temporary puncture repair kit

2
16
Spare wheel

2
21
Changing a bulb

2
29
Changing a fuse

2
36
12 V battery

2
43
To w i n g
2

47
In the event of a breakdown
Engines 249
Weights
2
49
Dimensions
2

52
Identification markings
2

53
Technical data
Alphabetical index
For the audio and telematic systems,
refer to the supplement to the handbook
or go to the following internet address:
http://service.citroen.com/ddb/
Contents

Page 10 of 442

8
Running out of fuel, Diesel (priming pump) 2 15
AdBlue
® and SCR system
(BlueHDi Diesel) 2 10 -213
Maintenance - Technical data
Checking levels 20 4-207
- o il
-

b
rake fluid
-
c

oolant
-

s
creenwash fluid
-

a
dditive (Diesel with particle filter)
Checking components
20

8-209
-
b

attery
-

a
ir / passenger compartment filter
-

o
il filter
-

p
article filter (Diesel)
-

b
rake pads / discs Changing bulbs
2

29-235
-

f
ront lamps
-

r
ear lamps
-
i

nterior lighting
Petrol engines

2
50
Diesel engines
2
51
Dimensions
2
52
Identification markings
2
53
Opening the bonnet
2
01
Under the bonnet, petrol

2
02
Under the bonnet, Diesel

2
03
12 V battery

2
43 -246
Load reduction, economy mode
1
98
Engine compartment
fuses
2
36 -237, 241-242
Over view

Page 28 of 442

26
Engine oil
pressurefixed.
There is a fault with the engine
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a CITROËN
dealer or a qualified workshop.
Battery charge
fixed. The battery charging circuit has a
fault (dirty or loose terminals, slack or
cut alternator belt, ...).
The warning lamp should go off when the engine is
started.
If it does not go off, contact a CITROËN dealer or a
qualified workshop.
Maximum
coolant
temperature fixed.
The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping-
up the level, if necessary.
If the problem persists, contact a CITROËN dealer or
qualified workshop.
Warning / indicator lamp
StateCause Action / Observations
Airbags on temporarily. This warning lamp comes on for a
few seconds when you turn on the
ignition, then goes off.
This warning lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified
workshop.
fixed.One of the airbag or seat belt
pretensioner systems has a fault. Have them checked by a CITROËN dealer or a
qualified workshop.
Instruments

Page 33 of 442

31
Resetting the service indicator
If you have to disconnect the battery
following this operation, lock the vehicle
and wait at least five minutes for the
reset to be registered.
Retrieving the service
information
After each service, the service indicator must
be reset to zero.
If you have carried out the service on your
vehicle yourself, switch off the ignition:
F
P
ress and hold this button,
F

S
witch on the ignition; the distance
recorder display begins a countdown,
F

W
hen the display indicates "=0" , release
the button; the spanner disappears. You can access the service information at any
time.
F

P
ress this button.
The service information is displayed for a few
seconds, then disappears.
1
Instruments

Page 59 of 442

57
As a safety measure (children on
board), never leave the vehicle without
taking the electronic key for the Keyless
Entry and Starting system with you,
even for a short period.
Be aware of the risk of theft when the
electronic key for the Keyless Entry and
Starting system is in one of the defined
zones with the vehicle unlocked.
If one of the doors or the boot is still
open or if the electronic key for the
Keyless Entry and Starting system has
been left inside the vehicle, the central
locking does not take place.
However, the alarm (if fitted) will be fully
activated after about 45 seconds.
If the vehicle is unlocked by mistake
and with no action on the doors or boot,
the vehicle will lock again automatically
after about 30 seconds.
If fitted to your vehicle, the alarm will
also be reactivated automatically.
In order to preserve the battery in the
electronic key and the vehicle's battery,
the "hands-free" functions are put into
long-term standby after 21 days without
use. To restore these functions, press
one of the remote control buttons or
start the engine with the electronic key
in the reader.
For more information on Starting with

Keyless Entr y and Star ting , refer to
the corresponding section.
2
Access

Page 63 of 442

61
Back-up procedures
Total unlocking / locking of the vehicle with the key
UnlockingNormal locking
If the alarm is activated, the siren
sounds on opening the door; switch on
the ignition to stop it. If your vehicle is fitted with an alarm,
this function will not be activated when
locking with the key.
These procedures should be used in the
following cases:
-

r

emote control battery flat,
-

r

emote control fault,
-

v

ehicle in an area subject to strong
electromagnetic interference.
In the first case, you can also replace the
remote control battery.
Refer to the corresponding section.
In the second case, you can also reinitialise the
remote control.
Refer to the corresponding section.
F
I
nsert the key in the door lock barrel.
F
T
urn the key towards the rear of the
vehicle.
For versions without alarm, the locking is
confirmed by flashing of the direction indicators
for a few seconds.
F

I

nsert the key in the door lock barrel.
F

T

urn the key towards the front of the
vehicle.
For versions without alarm, the unlocking is
confirmed by flashing of the direction indicators
for a few seconds.
2
Access

Page 65 of 442

63
Changing the battery
A message appears in the instrument panel screen when replacement of the battery is needed.
Version without Keyless Entr y and
Starting
Batter y type: CR1620 / 3 volts.
F
U
nclip the cover using a small screwdriver
at the cut-out.
F

L
ift off the cover.
F

R
emove the discharged battery from its
housing. Version with Keyless Entr y and
Starting
Batter y type: CR2032 / 3 volts.
The remote control must be reinitialised after
replacing the battery.
For more information on reinitialising the
remote control, refer to the corresponding
section. F

F
it the new battery into its housing
observing the polarity.
F

C
lip the cover onto the casing.
2
Access

Page 66 of 442

64
Reinitialising the remote control
Following replacement of the battery or in the event of a remote control fault, it may be necessary to reinitialise the remote control.
F
S
witch off the ignition.
F

T
urn the key to position 2 ( ignition on).
F

P
ress the closed padlock button for a few
seconds.
F

S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again. F

P
lace the electronic key against the back-
up reader on the steering column and hold
it there until the ignition is switched on. F

I
f your vehicle has a manual gearbox, place
the gear lever in neutral then fully depress
the clutch pedal.
F

I
f your vehicle has an automatic gearbox,
select position P then press the brake
pedal firmly.
Version without Keyless
Entry and Starting Version with Keyless Entry and
Starting
F Switch on the ignition by pressing
the "START/STOP" button.
The electronic key is now fully operational
again.
If the fault persists after reinitialisation, contact
a CITROËN dealer or a qualified workshop
without delay.
Access

Page 68 of 442

66
Boot
F With the vehicle unlocked or with the Keyless Entry and Starting electronic key
in the recognition zone, press the tailgate
central control.
F

Ra
ise the tailgate.
Closing
F Lower the tailgate using one of the interior grab handles.
If the tailgate is not closed correctly:
-

w
hen the engine is running ,
this warning lamp comes on,
accompanied by a message for a
few seconds,
Back-up release
To manually unlock the boot in the event of a
battery or central locking failure.
Unlocking
F Fold back the rear seats to gain access to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
F

M
ove the latch to the left.
Locking after closing
If the fault persists after closing again, the boot
will remain locked.
Opening
- when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp
comes on, accompanied by an audible
signal and a message for a few seconds.
Access

Page 71 of 442

69
* Depending on the country of sale.
Alarm*
System which protects and provides a deterrent
against theft and break-ins. It provides the
following type of monitoring:
- exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet, etc.
Self-protection function
The system checks for the putting out of
service of its components.
The alarm is triggered if the battery, the central
control or the siren wiring are put out of service
or damaged.For all work on the alarm system,
contact a CITROËN dealer or a
qualified workshop. Following an instruction to lock
the vehicle, the exterior perimeter
monitoring is activated after a delay of
5 seconds.
If an opening (door, boot, etc.) is not
fully closed, the vehicle is not locked but
the exterior perimeter monitoring will be
activated after a delay of 45 seconds.
Locking the vehicle with alarm system
Activation
F Switch off the ignition and get out of the
vehicle.
F

L
ock the vehicle with the remote control
or with the "Keyless Entry and Starting"
system.
The monitoring system is active: the indicator
lamp in the locking button on the dashboard
flashes once per second and the direction
indicators come on for about 2 seconds.
Deactivation
F Unlock the vehicle with the "Keyless Entry and Starting" system.
The monitoring system is deactivated: the
indicator lamp in the locking button goes off
and the direction indicators flash for about
2
seconds.
If the vehicle automatically locks itself
again (as happens if a door or boot
is not opened within 30 seconds of
unlocking), the monitoring system is
also reactivated automatically.
2
Access

Page:   1-10 11-20 21-30 31-40 40 next >