boot CITROEN C4 2007 Owner's Manual

84
VI
F I T T I N G S
REAR ARMREST
Comfort and storage device for the
rear passengers.

 Lower the rear armrest for a
more comfortable position.

 Raise the cover to gain access
to its storage compartment.
This has a storage tray, two can hol-
ders and two pen holders.
LUGGAGE SECURING RINGS

 Use the 2 rear side fi xings and
the 4 securing rings on the boot
fl oor to secure your luggage.
For safety reasons in the event of
sharp braking, you are advised to
place heavy objects on the fl oor as
close as possible to the back of the
rear seat.

133
XI
P R A C T I C A L I N F O R M A T I O N
CHANGING A WHEEL
Access to the tools
The tools are located in the spare
wheel, under the boot fl oor.
To gain access to them:

 open the boot,

 lift the fl oor,

 unclip and remove the box contai-
ning the tools. List of tools
All of these tools are specifi c to your
vehicle. Do not use them for other
purposes.

1. Wheelbrace *

2. Jack with handle *

3. Aluminium wheel central embel-
lisher removal tool *

4. Socket for anti-theft bolts (located
in the glove box)
Fits the wheelbrace.

5. Removable towing eye
Access to the spare wheel
The spare wheel is installed in the
boot, under the fl oor.
Removing the wheel

 Undo the yellow central screw by
a quarter turn.

 Raise the spare wheel towards
you rearwards.

 Remove the wheel from the boot
space.
* Only where the vehicle has a spare wheel.

136
XI
P R A C T I C A L I N F O R M A T I O N
This repair kit is available from
CITROËN dealers.
It is designed to repair most punc-
tures which could affect the tyre, lo-
cated on the tyre tread or shoulder.
Avoid removing any foreign bodies
which have penetrated the tyre.
TEMPORARY PUNCTURE
REPAIR KIT
Complete system consisting of a
compressor and an incorporated
sealant cartridge which permits
tem-
porary repair of the tyre so that you
can drive to the nearest garage.
The kit is stowed in the boot below the
fl oor. It is fi tted in the tool box, located
below the storage compartment. Using the kit
This procedure, comprising several
steps, must be carried out in full.

 Switch off the ignition.

 Turn the selector A to the
"SEALANT" position.

 Check that the switch B is in po-
sition "0" .

 Connect the white pipe C to the
valve of the tyre to be repaired.

 Connect the compressor's electric
plug to the vehicle's 12 V socket.

 Affi x the speed limitation sticker
to the vehicle's steering wheel
to remind you that a wheel is in
temporary use.

 Start the vehicle and leave the
engine running.
Access to the kit