Citroen C4 2009 1.G Owner's Manual

Page 151 of 279

146
XI
P R A C T I C A L I N F O R M A T I O N
Interior lighting
Interior lamp (1/W 5 W)
Detach the cover of the interior lamp
with a thin screwdriver, close to the
button, to access the faulty bulb.
Map reading lamps (2/W 5 W)
Detach the cover of the interior lamp.
To access the faulty bulb, detach the
partition for the reading lamp con-
cerned, as necessary. Boot lamp (W 5 W)
Detach the unit by pushing it rear-
wards.
Sill lamps (W 5 W)
Detach the lamp to access the bulb. Glove box lamp (W 5 W)
Detach the lamp to access the bulb.

Page 152 of 279

147
XI
P R A C T I C A L I N F O R M A T I O N
CHANGING A FUSE
Procedure for replacing a faulty fuse
with a new fuse to rectify a failure of
the corresponding function.
There are two fuseboxes under the
dashboard, one fusebox in the en-
gine compartment and another on
the battery.
Changing a fuse
Before replacing a fuse, it is essen-
tial to fi nd the cause of the incident
and to have it rectifi ed. The fuse
identifi cation numbers are indicated
inside the fusebox.
Replace a blown fuse with one of the
same rating (the same colour). Use the special tool
A that is pro-
vided in the fuse housing fl ap, which
also contains spare fuses.

Correct Incorrect

Tool A

Access to the fi rst dashboard
fusebox
Fuses under the dashboard
Your vehicle’s electrical
system is designed to oper-
ate with either standard or
optional equipment.
Before installing electrical equipment
or accessories on your vehicle, con-
sult a CITROËN dealer.
CITROËN declines all responsibil-
ity for the consequences and costs
that are caused by faults or repairs
on your vehicle resulting from the
installation of accessories that
are not supplied and/or not rec-
ommended by CITROËN and not
installed according to its instruc-
tions, particularly when the energy
consumption of all of the additional
accessories connected exceeds
10 milliamperes (Ma).

Page 153 of 279

148
XI
P R A C T I C A L I N F O R M A T I O N
Fuses under the dashboard Access to the fuses

 Open the glove box.

 Undo the screw by a quarter turn
and pivot the housing.
Table of fuses

Fuse N° Rating
Functions

F1 15 A Rear screen wipe

F2 30 A Central locking - Deadlocking

F3 5 A Airbags and pretensioners

F4 10 A Diagnostic socket - Brake switch - Photochromic rear view mirror - ESP - Cool
ant level
sensor - Diesel additive - Clutch pedal switch (ESP, cruise control a nd speed limiter)

F5 30 A Front windows, Heated exterior rear view mirrors

F6 30 A Rear windows

F7 5 A Interior lighting

F8 20 A Multifunction screen, radio, steering wheel contro
ls, Displays - Alarm - Front 12 V socket -
Trailer unit - Driving school module

F9 30 A Lighter - Rear 12 V socket

F10 15 A Defl ation detection - Automatic gearbox - STOP switch

F11 15 A Ignition switch - Diagnostic socket - Particle fi lter

F12 15 A Electric seat - Lane departure warning system - Parking assistance

F13 5 A Rain sensor - Brightness sensor - Electronic gearbox system (6-speed) - Engin e relay unit

F14 15 A Air conditioning - Instrument panel - Rev counter - Airbags and p
retensioners - Trailer unit -
Bluetooth ®
telephone

F15 30 A Central locking - Deadlocking

F16 - SHUNT

F17 40 A Heated rear screen

Page 154 of 279

149
XI
P R A C T I C A L I N F O R M A T I O N Fuses in the engine
compartment Access to the fuses

 Detach and remove the cover.

Access to the second dashboard
fusebox

After any operation on the fuses
in the fusebox, check that the
fusebox cover is put back cor-
rectly for their protection. Table of fuses

Fuse N° Rating Functions

F36 30 A Hi-Fi amplifi er

F37 30 A Driver’s electric seat

F39 20 A Heated seats

After any operation, carefully refi t
the cover. If the cover is not cor-
rectly positioned or not properly
closed, this could cause serious
problems on your vehicle. For
the same reason, take care not to
spill any liquid in the fusebox. All work on the maxi-fuses,
which are located in these
fuseboxes and which give
extra protection, must be carried
out by CITROËN technicians.

Page 155 of 279

149
XI
P R A C T I C A L I N F O R M A T I O N Fuses in the engine
compartment Access to the fuses

 Detach and remove the cover.

Access to the second dashboard
fusebox

After any operation on the fuses
in the fusebox, check that the
fusebox cover is put back cor-
rectly for their protection. Table of fuses

Fuse N° Rating Functions

F36 30 A Hi-Fi amplifi er

F37 30 A Driver’s electric seat

F39 20 A Heated seats

After any operation, carefully refi t
the cover. If the cover is not cor-
rectly positioned or not properly
closed, this could cause serious
problems on your vehicle. For
the same reason, take care not to
spill any liquid in the fusebox. All work on the maxi-fuses,
which are located in these
fuseboxes and which give
extra protection, must be carried
out by CITROËN technicians.

Page 156 of 279

150
XI
P R A C T I C A L I N F O R M A T I O N
Table of fuses
Fuse N° Rating
Functions

F1 20 A Engine management control unit - Cooling fan

F2 15 A Horn

F3 10 A Front and rear screen wash

F4 20 A Headlamp wash

F5 15 A Fuel pump

F6 10 A Automatic gearbox - Xenon headlamps - Directional headlamps - Canister discharge electrovalve

F7 10 A ABS control unit/ESP control unit - Power steering

F8 25 A Starter motor

F9 10 A Additional heating unit (Diesel) - Engine coolant level swi tch

F10 30 A Engine electrovalve - Water in diesel sensor - Eng
ine management control unit - Injectors -
Ignition coil - Oxygen sensor - Canister discharge electrovalve (1.4i 16V and 1.6i 16V engines)

F11 40 A Air blower - Air conditioning

F12 30 A Windscreen wipe

F13 40 A Built-in Systems Interface (BSI)

F14 - Not used

F15 10 A Right-hand main beam

F16 10 A Left-hand main beam

F17 15 A Left-hand dipped beam

F18 15 A Right-hand dipped beam

F19 15 A Engine management control unit (1.4i 16V et 1.6i 16V engin es)

F20 10 A Engine electrovalve

F21 5 A Cooling fan relay - Valvetronic

Page 157 of 279

151
XI
P R A C T I C A L I N F O R M A T I O N
Fuses on the battery
After any operation, carefully refi t
the cover. If the cover is not cor-
rectly positioned or not properly
closed, this could cause serious
problems on your vehicle. For
the same reason, take care not to
spill any liquid in the fusebox.
Table of fuses
Fuse N° Rating
Functions

F1 - Not used

F
2 * 30 A Gearbox (electronic system or automatic)

F3 - Not used

F4 - Not used

F5 * 80 A Power steering electropump assembly

F6 * 70 A Heating unit (Diesel)

F7 * 100 A Switching and protection unit

F8 - Not used

F9 * 30 A Electronic gearbox system electropump assembly

F10 *

30 A Valvetronic electric motor
Access to the fuses

 Detach and remove the cover. * The maxi-fuses provide additional
protection for the electrical systems.
All work on these fuses must be car-
ried out by CITROËN technicians.

Page 158 of 279

152
XI
P R A C T I C A L I N F O R M A T I O N
Table of maxi-fuses
Fuse N° Rating
Functions

MF1 * 30 A/50 A Cooling fan

MF2 * 30 A ABS/ESP pump supply

MF3 * 50 A ABS/ESP control unit

MF4 * 80 A Built-in systems interface

MF5 * 80 A Built-in systems interface

MF6 * 80 A Passenger compartment fuse box

MF7 * 20 A Diagnostic socket/PEF additive pump

MF8 * - Not used

Page 159 of 279

153
XI
P R A C T I C A L I N F O R M A T I O N
BATTERY
Procedure for charging your battery
when it is fl at or for starting the en-
gine using another battery.
Access to the battery
The battery is located under the bonnet.
To gain access to it:

 open the bonnet using the inte-
rior lever, then the exterior lever,

 secure the bonnet strut,

 remove the plastic cover to gain
access to the two terminals,

 unclip the fuse box to remove
the battery, if necessary. Charging the battery using a
battery charger

 Disconnect the battery from the
vehicle.

 Follow the instructions for use
provided by the manufacturer of
the charger.

 Reconnect starting with the neg-
ative terminal (-).

 Check that the terminals and
connectors are clean. If they are
covered with sulphate (whitish or
greenish deposit), remove them
and clean them.
Starting using another
battery
The batteries contain harm-
ful substances such as sul-
phuric acid and lead. They
must be disposed of in accordance
with regulations and must not, in
any circumstances, be discarded
with household waste.
Take used remote control batteries
and vehicle batteries to a special
collection point.
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month.

 Connect the red cable to the
positive terminal (+) of the fl at
battery A , then to the positive ter-
minal (+) of the slave battery B .

 Connect one end of the green or
black cable to the negative ter-
minal (-) of the slave battery B .

 Operate the starter, let the en-
gine run.

 Wait until the engine returns to
idle and disconnect the cables.

Page 160 of 279

154
XI
P R A C T I C A L I N F O R M A T I O N
ENERGY ECONOMY MODE
System which manages the duration
of use of certain functions to con-
serve a suffi cient level of charge in
the battery.
After the engine has stopped, you can
still use functions such as the audio
and telematics system, windscreen
wipers, dipped headlamps, courtesy
lights, etc. for a maximum combined
duration of thirty minutes. Switching to economy mode
Once the thirty minutes are over, a
message appears on the multi-func-
tion screen indicating that the vehicle
has switched to economy mode
and the active functions are put on
standby.
Exiting economy mode
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, start the en-
gine and let it run:
- for less than ten minutes to use
the equipment for an equivalent
duration,
- for more than ten minutes to use the equipment for approximately
thirty minutes.
A fl at battery prevents the
engine from starting (refer
to the corresponding para-
graph).
Following reconnection of the
battery
Following reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to permit
initialisation of the electronic sys-
tems. However, if slight diffi culties
are encountered following this oper-
ation, contact a CITROËN dealer.
Referring to the corresponding sec-
tion, you must yourself reinitialise
(depending on equipment):
- the remote control key,
- the one-touch electric windows,
- the settings of the multifunction
screen,
- the audio equipment radio sta- tions,
- the GPS satellite navigation system.
Do not disconnect the ter-
minals while the engine is
running.
Do not charge the batteries without
disconnecting the terminals fi rst.
Do not push the vehicle to start the
engine if it is fi tted with a 6-speed
electronic gearbox system.
Before disconnecting
the battery
Wait 2 minutes after switching off
the ignition before disconnecting
the battery.
Close the windows and the doors
before disconnecting the battery.

Page:   < prev 1-10 ... 111-120 121-130 131-140 141-150 151-160 161-170 171-180 181-190 191-200 ... 280 next >