engine specification Citroen C4 2016 2.G Owner's Manual

227
C4-2_en_Chap07_infos-pratiques_ed02-2015
Topping-up the engine oil level
F Locate  the   oil   filler   cap   in   the   engine  c
ompartment   of   your   vehicle.
For
  more   information   on   the   petrol   or   Diesel  
e

ngine,   refer   to   the   corresponding   section.
F
 
U
nscrew   the   oil   filler   cap   to   reveal   the   filler  
a

perture.
F
 
A
dd   oil   in   small   quantities,   avoiding   any  
s

pills   on   engine   components   (risk   of   fire).
F
 
W
ait   a   few   minutes   before   checking   the  
l

evel   again   using   the   dipstick.
F
 
A
dd   more   oil   if   necessary.
F
 
A
fter   checking   the   level,   carefully   refit   the  
o

il   filler   cap   and   the   dipstick   in   its   tube.
After
  topping-up   the   oil,   the   check   when  
s

witching   on   the   ignition   with   the   oil   level  
i

ndicator   in   the   instrument   panel   is   not   valid  
d

uring   the   30   minutes   after   topping   up.
Engine oil change
Refer to the manufacturer's service schedule for   details   of   the   interval   for   this   operation.
In
  order   to   maintain   the   reliability   of   the   engine  
a

nd   emission   control   system,   never   use  
a

dditives   in   the   engine   oil.
Brake fluid level
Changing the fluid
Refer to the manufacturer's service schedule for   details   of   the   interval   for   this   operation.
Fluid specification
The brake fluid must conform to the manufacturer's r ecommendations.
The
  brake   fluid   level   should   be   close  
t

o   the   "MA X"   mark.   If   it   is   not,   check  
t

he   brake   pad   wear.
Power steering
fluid level
The power steering fluid level should b
e   close   to   the   "MA X"   mark.   With  
t

he   engine   cold,   unscrew   the   cap   to  
c

heck   the   level.
7
Practical information

228
C4-2_en_Chap07_infos-pratiques_ed02-2015
Screenwash / headlamp
wash fluid level
Specification of the fluid
To ensure optimum cleaning and to avoid freezing,   the   fluid   should   never   be   topped   up   or r

eplaced   by   plain   water.
In wintry conditions, the use of a fluid
with
  an   ethyl   alcohol   or   methanol   base   is  
re

commended.
To
 
check
 
the
 
level
 
or
 
top
 
up
 
the
 
f

luid
 
on
 
vehicle
 
fitted
 
with
 
headlamp
 
w

ashers,
 
immobilise
 
the
 
vehicle
 
and
 
s

witch
 
of
 
the
 
engine.
F

O

pen the bonnet and secure it with the
st ay.
F
 
O

pen
 
the
 
screenwash
 
reservoir
 
filler
 
cap.
F
 
T

ake
 
and
 
pinch
 
the
 
level
 
gauge
 
to
 
block
 
its
 
b

reather.
F
 
R

emove
 
the
 
gauge
 
completely
 
from
 
t

he reservoir to read the level in the
transparent
 s

ection.
Coolant level
The coolant level should be close
to   the   "MA X"   mark   but   should   never  
e

xceed   it.
Fluid specification
The coolant must conform to the manufacturer's r ecommendations.
The cooling fan may star t after
switching off the engine: take care
with articles and clothing that might
be caught by the fan blades.
When
  the   engine   is   warm,   the   temperature   of  
t

he   coolant   is   regulated   by   the   fan.
In   addition,   as   the   cooling   system   is  
p

ressurised, wait at least one hour after
switching   off   the   engine   before   carrying   out  
any   work.
To   avoid   any   risk   of   scalding,   unscrew   the   cap  
b

y   two   turns   to   allow   the   pressure   to   drop.  
W

hen   the   pressure   has   dropped,   remove   the  
c

ap   and   top   up   the   level. F  
T
op   up   if   necessary.
F
R
efit the filler cap to the reservoir and
close   the   bonnet.
Practical information

230
C4-2_en_Chap07_infos-pratiques_ed02-2015
Checks
Particle filter (Diesel)
- fixed  illumination   of   the   particle  f
ilter   warning   lamp,   accompanied  
b

y   an   audible   signal   and   a  
m

essage   that   there   is   a   risk   of  
b

lockage   of   the   particle   filter.
The presence of this label, in particular with
the
 
Stop
 
&
 
Start
 
system,
 
indicates
 
the
 
use
 
of
 
a s

pecific 12 V lead-acid battery with special
technology
 
and
 
specification.
 
The
 
involvement
 
o

f
 
a
 
CITROËN
 
dealer
 
or
 
a
 
qualified
 
workshop
 
i

s
 
essential
 
when
 
replacing
 
or
 
disconnecting
 
t

he
 
battery. As
 
soon
 
as   the   traffic   conditions   permit,  
r

egenerate   the   filter   by   driving   at   a   speed   of   at  
l

east
 
40
 
mph   (60   km/h)   until   the   warning   lamp  
g

oes
 
off.
If
 
the
 
warning   lamp   stays   on,   refer   to   the  
"

Additive
 
level"   section.
Unless
 
other wise
 
indicated,
 
check
 
these
 
components
 
in
 
accordance
 
with
 
the
 
manufacturer's
 
service
 
schedule
 
and   according   to   your   engine.
Other wise,
 
have
 
them
 
checked
 
by
 
a
 
CITROËN
 
dealer
 
or
 
a
 
qualified
 
workshop.
Air filter and passenger compartment filter
Refer to the manufacturer's s
ervice schedule for details of the
replacement
  intervals   for   these  
c

omponents.
Oil filter
Replace the oil filter each time the e ngine   oil   is   changed.
Refer
  to   the   manufacturer's  
s

ervice schedule for details of
the
  replacement   interval   for   this  
c

omponent.
12 V battery
The battery does not require any maintenance.
H owever,   check   that   the   terminals   are   clean a

nd   correctly   tightened,   particularly   in   summer
 a

nd   winter.
When carrying out work on the battery, refer to the "12 V battery" section for details of the
precautions
  to   be   taken   before   disconnecting  
t

he   battery   and   following   its   reconnection.Depending
  on   the   environment   (e.g.   dusty  a
tmosphere)   and   the   use   of   the   vehicle  
(e.g.
  city   driving),   replace them twice as often
if necessary .
A
  clogged   passenger   compartment   filter   may  
h

ave   an   adverse   effect   on   the   per formance  
o

f   the   air   conditioning   system   and   generate  
u

ndesirable
 o
dours.The start of saturation of the particle filter is
indicated
  by:
On a new vehicle, the first operations of
regeneration   of   the   particle   filter   may   be  
a

ccompanied   by   the   smell   of   "burning",  
w

hich   is   per fectly   normal.
Following
  prolonged   operation   of   the  
v

ehicle at very low speed or at idle,
you
  may,   in   exceptional   circumstances,  
n

otice   the   emission   of   water   vapour   at  
t

he   exhaust   on   acceleration.   This   does  
n

ot affect the behaviour of the vehicle
or
  the   environment.
Practical information