buttons Citroen C4 AIRCROSS 2012 1.G Owner's Manual

6
Familiarisation
Opening
A.
Folding/unfolding the key. B.Unlocking the vehicle.
C.Locking the vehicle.
Remote control
65

Unlocking

With the electronic key on your person and in one of the defined zones A, press one of thebuttons Bor C
to unlock the vehicle, then pull on the handle to open the door.
Locking
With the electronic key on your person and in one of the defined zones A
, press one of thebuttons B
or Cto lock the vehicle.


Keyless Entry and Starting system
60
64

54
Monitoring











AUDIO-CD system screen

Associated with the audio system, this provides
the following information:
- the time,
- audio system information (see "Audio and
Te l e m a t i c s ").



Setting the time


Selecting the adjustment mode

The digital clock can be set in automatic modeor in manual mode.
Select automatic modeor manual mode as follows: )Press button A"PWR" to switch on the audio system. )Access the setting mode by pressingbutton B
"TUNE" for approximately2 seconds.)Press button B"TUNE" several times to scroll through the various menus and select
the CT menu(clock time).

The order of the menus is the following:AF / CT / REG / TP-S / PT Y display language / SCV / PHONE / Functions setting mode OFF.
Manual mode
This mode permits manual setting of the timeusing the audio system buttons.
It can also be used when the "Automatic mode"
displays an inaccurate time, when the localRDS stations are broadcasting from a different
time zone. Automatic mod
e This mode permits automatic setting of thelocal time using the signal from RDS stations.
The symbol "CT"appears in the screen.

1
55
Monitoring
If no action is carried out within 10 seconds, the system will exit the "Functions setting mode" menuautomatically.
)Turn button B
"TUNE" to the left or to theright to select "CT ON"
(automatic mode)or "CT OFF"(manual mode). )After selecting the mode, you can exit the "Functions setting mode" menu by pressingbutton B
"TUNE" for approximately2 seconds.
The digital clock does not display seconds.
When the "minutes" display is set or reset to zero, the clock starts at the zero second of the minute selected.
The time setting is lost if the battery is disconnected.

Manual adjustment
)
With the ignition on or in the ACC (Accessories) position, press and hold
the CLOCK
button until the time displayflashes.)
Press the appropriate button to set the
time:
ButtonH:to set the hours The hours digits scroll when you press this button.
Button M:
to set the minutes
The minutes digits scroll when you press this button.
Button 00:to reset the minutes to zero.


- from 1 to 29 min:
rounded down to theprevious hour,

- from 30 to 59 min:
rounded up to the nexthour.)
After setting the time, press the DISPbutton; the time display stops flashing.
Set the time using the buttons as indicated below:

56
Monitoring

















AUDIO-TELEMATIC system screen If your vehicle is fitted with the navigation system, you have this colour touch screen.


General operation

Use the buttons on either side of the screen,
or touch the virtual buttons appearing in the screen to operate the system.
Uses a soft clean cloth to clean thescreen.
Do not use pointed objects on the touch screen.Do not touch the screen with wet hands.
For reasons of safety, the driver should only carry out operationsthat require close attention, with the vehicle stationary.
In addition, some functions are notaccessible when driving.
1.MODE
: access to the "Audio-video" menu.2.AUDIO
: selection of the Audio-video or
Navigation display.3.VOL
: volume adjustment. 4.PWR
: on/off.
5.SET: access to the "Settings" menu. T6.OPEN: access to the CD/DVD player.
7.INFO: access to the "Info" menu. 8.NAVI
: display the map with the location of
the vehicle. 9.SCALE
: map scale. 10. MENU: access to the "Navigation-guidance" menu.11.ENT
: scroll through a list or select an item.T


For more information on these menus, refer to the "Audio and telematics"section.

64
Access























"Keyless Entry and Starting" system


Selective unlocking
This setting is done via the "Equipment" menuof the colour screen.
By default, complete unlocking is activated.
System that allows the locking, unlockingand starting of the vehicle while keeping theelectronic key on your person.
It can also be used as a remote control; see the
"R
emote control" section.


Unlocking the vehicle


Complete unlocking
)
With the electronic key on your person andin one of the defined zones A, press oneof the buttons Bor Cto unlock the vehicle,
then pull on the handle to open the door.
Yo u r p a s s e ngers can also open their doors,
as soon as the electronic key is in one of
the defined zones.

Unlocking is confirmed by an audible signal and the direction indicators whichflash twice.
The door mirrors unfold at the sametime. Selective unlocking is only available onversions not fitted with deadlocking.

)With the electronic key on your person, press button B
once to unlock only the driver's door, then pull on the door handle
to open.)Press button Bagain to unlock the vehicle completely.


For security, the detection zones inwhich the electronic key is operational have a radius of about 70 cm aroundeach opening button.

65
2
Access
Locking the vehicle

Locking
)With the key in one of the defined zones A , press one of the buttons Bor C.
Deadlocking

)
With the electronic key in one of the defined zones A
, press button B
or Cto lock the vehicle. )
Within five seconds, press button Bor Cagain to deadlock the vehicle.
Always ensure that you have theelectronic key on your personbefore locking the vehicle: in some circumstances, it is possible to lock the vehicle without the presence of the electronic key having been detectedinside the vehicle.


Locking is confirmed by an audiblesignal and the direction indicators, which flash once
.
The door mirrors fold at the same time.

Locking is confirmed by two audible signals and by the direction indicators which flash three times .

The door mirrors unfold at the sametime.
The operating mode must be "OFF".
With Stop & Star t, if the engine is in Stop mode, the vehicle cannot belocked.

69
2
Access
Visit a CITROËN dealer with the vehicle's registration document and your personal identification documents and if possible the key code label.
The CITROËN dealer will be able to retrieve the key code and the transponder code required to order a new key.
Electronic key
The electronic key is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.Do not repeatedly press the buttons of your electronic key out of range and out of sight of your vehicle. You run the risk of stopping it from working and the remote control would have to be reinitialised.The electronic key cannot operate as a remote control when it is in the reader or even when the ignition is switched on.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by the emergency ser vices more difficult in an emergency.
As a safety precaution (with children on board), take the Keyless Entry and Star ting electronic key when you leave the vehicle, even for a shor ttime.
Electrical interference
The Keyless Entry and Starting electronic key may not operate if close to certain electronic devices: telephone, laptop computer, strong magnetic fields, ...
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could cause malfunctions.Don't forget to turn the steering to engage the steering lock.
When purchasing a second-hand vehicle
Have all of the keys in your possession paired by a CITROËN dealer, to ensure that only your keys allow your vehicle to be unlocked and star ted.

73
2
Access
For all work on the alarm system, contact a CITROËN dealer or aqualified workshop.






Alarm * System which protects and provides a deterrent against theft and break-ins. It provides the following types of monitoring:




- perimeter

The system checks for any opening of the vehicle.
The alarm is triggered if anyone tries to open adoor, the boot, the bonnet....


- volumetric

The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.

- tilt

The system checks for any change in theattitude of the vehicle.
The alarm is triggered if the vehicle is lifted,moved or knocked.


Self-protection function

The system checks for the putting out of service of its components.
The alarm is triggered if the battery, the centralcontrol or the siren wiring are put out of service
or damaged.
Locking the vehicle with full
alarm system
Activation
)
Switch off the ignition (OFF mode if your
vehicle has the Keyless Entry and Star ting system).) Remove the key from the ignition switch,
if your vehicle does not have the "Keyless
Entry and Starting" system.) Leave the vehicle, and close all the doorsand the bonnet. )
Press the locking button on the remote control or one of the door or boot buttons
if your vehicle has the "Keyless Entry and Starting" system.
Deactivation

Do one of the the following to deactivate thealarm:)
Press the unlocking button on the remotecontrol or one of the door or boot buttonsif your vehicle has the "Keyless Entry andStarting" system.
)
Switch on the ignition (ON mode if your
vehicle has the "Keyless Entry andStarting" system). ) Open a door or the boot while the system is being activated.
The alarm system is deactivated: the indicator
lamp A
goes off.
The alarm is bein
g activated: the indicator
lamp A flashes rapidly accompanied byan intermittent audible signal for about
20 seconds.

Once the 20 seconds have expired, the
system is active . The audible signal stops and
the indicator lamp in the button flashes slowly.

*
According to equipment.

86
Comfort
From the outside:) by locking or unlocking the vehicle,using the remote control or the locking / unlocking buttons (for vehicles fitted with
the "Keyless Entry and Starting" system).



If you have folded the mirrors using thecontrol C
, you must use this control tounfold them, other wise the mirrors will not be lock in place correctly.
Some mirror functions (in particular the automatic folding and unfolding of the door mirrors) can be configured via thecolour screen "Equipment" menu.
The mirrors can also be foldedmanually. From inside:
- with the i
gnition switch in the "ON" or "ACC" position, by pressing the control C,
- with the ignition switch in the "LOCK"
position, by pressing control C, within30 seconds.

126
Driving
When the cruise control is in operation,pay attention if you press and hold oneof the programmed speed adjustment buttons: this can result in a very rapidchange in the speed of your vehicle.
Do not use the cruise control on slippery roads or in heavy traffic. On a steep descent, the cruise control will not be able to prevent the vehiclefrom exceeding the programmed speed.
To prevent the mat from becomingcaught under the pedals:


- ensure that the mat is positioned correctly,


- never fit one mat on top of another.
T
o deactivate the cruise control:
)press the brakeor clutchpedal, or )press button 1 "ON OFF", or )press button 4 "CANCEL".
Deactivating the function
Reactivating the function

When the cruise control has been deactivatedusing the button 4 "CANCEL"
, you can return
to the stored speed by pressing button 3 "ACC
RES"
when you reach a minimum speed of 25 mph (40 km/h).

The cruise control may be deactivatedautomatically:
)when the vehicle reaches a speed below
20 mph (35 km/h),)when the active stability control system (ASC) comes into operation.