ESP Citroen C4 AIRCROSS RHD 2014 1.G Owner's Manual

20
Familiarisation
Driving


Stop & Start
(Auto Stop & Go) function

Engine going into STOP mode

The "AS &G"
warning lamp comes on in
the instrument panel or the instrument
panel screen and the engine is put into
standby after a few seconds:

Engine going into START mode

Deactivation / Reactivation

You can deactivate the system at any time
by pressing the "AS &G O FF "
button; the
corresponding warning lamp comes on in the
instrument panel or the instrument panel screen.
The system is reactivated automatically
every time you start the engine with the
key or with the START/STOP button.
The "AS &G"
warning lamp goes off
and the engine restarts automatically:


- with a manual gearbox; when you fully

depress the clutch pedal.


- with a manual gearbox;
with the vehicle
stationary and your foot on the brake
pedal, when you put the gear lever into
neutral and release the clutch pedal. In certain condition, START mode may engage
automatically; the "AS &G"
warning lamp
flashes then goes off.
In certain circumstances the STOP mode may
not be available; the "AS &G"
warning lamp
flashes for a few seconds then goes off.
121122
122

28
Monitoring










Operation indicator lamps

If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.
It may be accompanied by an audible signal and a message in the instrument panel screen.



Warning lamp



is on



Cause



Action / Observations






Left-hand
direction
indicator


flashing with audible
warning. The lighting stalk has been pressed
downwards. If this indicator lamp flashes abnormally quickly, this
could indicate that the bulb of one of the direction
indicators has blown. Change the bulb or contact a
CITROËN dealer or a qualified workshop.





Right-hand
direction
indicator


flashing with audible
warning. The lighting stalk has been pushed
upwards. If this indicator lamp flashes abnormally quickly, this
could indicate that the bulb of one of the direction
indicators has blown. Change the bulb or contact a
CITROËN dealer or a qualified workshop.




Sidelamps
or
dipped beam
headlamps


fixed. The sidelamps or dipped beam
headlamps are on.




Main beam
headlamps


fixed. The lighting stalk is pulled towards
you. Pull the stalk to return to dipped beam headlamps.




Front foglamps


fixed. The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.




Rear foglamp


fixed. The rear foglamp is switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamp.

30
Monitoring










Deactivation indicator lamps

If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.
This is may be accompanied by an audible signal and a message in the screen.



Warning lamp



is on



Cause



Action / Observations



ASC/TCL
fixed. The ASC/ TCL off switch, located at
the bottom of the dashboard (driver's
side) has been pressed.
ASC/ TCL is deactivated.
ASC: active stability control .
TCL: traction control. Press the button to activate the ASC/ TCL.
The ASC/ TCL system is automatically activated on
starting the vehicle.

Stop & Star t
system
(Auto Stop & Go)
fixed. The off switch for the Stop & Start
(AS&G) system, located at the bottom
of the dashboard (driver's side) has
been pressed.
The Stop & Start (AS&G) system is
deaactivated. Press the switch again to activate the Stop & Start
(AS&G) system.

1
51
Monitoring

If you select the "- - -" setting, no
message will be displayed in message
display situations.

If the battery is disconnected, the
settings memory is cleared and the
default language (ENGLISH) is restored
automatically.

)
press the INFO
button to scroll the
languages (Japonais, English, Deutsch,
Français, Espanol, Italiano, Russe "- - -" and
RETURN) in succession,

)
press and hold the INFO
button for a few
seconds to confirm your selection.




Choice of the display LANGUAGE

In the menu screen:


)
press the INFO
button to select
"LANGUAGE"
:

)
press and hold the INFO
button for a few
seconds to display the "LANGUAGE"

screen:

79
2
Access

Deactivating the passenger
and rear electric window
switches
Reinitialising the electric
windows
When the button is pressed down, only
the window in the driver's door operates.
Always remove the key from the ignition
when leaving the vehicle, even for a
short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this,
press the switch concerned.
When the driver operates the
passenger electric window switches,
they must ensure that no one is
preventing correct closing of the
windows.
The driver must ensure that passengers
use the electric windows correctly.
Be aware of children when operating
the windows.

)
For the safety of your children, press
switch 5
to prevent operation of the
passenger and rear electric windows
irrespective of their position. From the switch in the driver's door:


)
pull the switch until the window is fully
closed, then release it,

)
pull the switch again for at least one
second after reaching the window closed
position.

The safety anti-pinch function is not active
during these operations.


When the button is pressed down, the switches
are deactivated.
When the button is up, the switches are activated. Should there be no automatic
movement of a window when rising or
after the safety anti-pinch has been
triggered three times in succession, the
electric windows must be reinitialised.

85
3
Comfort











Rear seats
Bench seat with fixed one-piece cushion and split backrest (left hand 2/3, right hand 1/3) which can be folded individually to adapt the load space in the boot.


Folding the backrest

Repositioning the seat backrest



)
Move the corresponding front seat for ward
if necessary.

)
Place the head restraints in the low
position (see "Rear head restraints").

)
Press control 1
for wards to release the
seat backrest 2
.

)
Fold the seat back 2
on to the cushion.


)
Straighten the seat backrest 2
and secure it.

)
Check that the red indicator, located next to
the control 1
, is no longer visible.

When repositioning the seat backrests, they
can be locked in one of two different positions,
depending on the speed in which the operation
is carried out:


- if done quickly, the backrest returns to its
original position 1
,

- if done slowly, the backrest goes into the
vertical position 2
.
To go from position 2
to position 1
, simply
release the backrest and push it until it locks
in place.

87
3
Comfort





Mirrors


Adjustment

Adjustment is possible when the ignition switch
is in the "ON" or "ACC" position.


)
Move control A
to the right or to the left to
select the corresponding mirror.

)
Move control B
in all four directions to
adjust.

)
Return control A
to the central position. Each fitted with an adjustable mirror glass
permitting the lateral rear ward vision necessary
for overtaking or parking. They can also be
folded for parking in confined spaces.

Demisting - Defrosting


Door mirrors

If your vehicle is fitted with heated
mirrors, the demisting-defrosting
operates with the engine running, by
switching on the heated rear screen
(see "Rear screen demist-defrost").
The objects obser ved are, in reality,
closer than they appear.
Take this into account in order to
correctly judge the distance of vehicles
approaching from behind.

114
Driving











Gear shift indicator *
System which reduces fuel consumption by advising the driver to change up on vehicles fitted with a manual gearbox.


Operation


*
According to engine.
The symbol appears in the
instrument panel suggesting that you
change up.
In the case of driving which makes
particular demands on the per formance
of the engine (firm pressure on the
accelerator pedal, for example, when
overtaking...), the system will not
recommend a gear change.
The system never suggests:


- engaging reverse gear,

- engaging a lower gear.

The system inter venes only when driving
economically.
Depending on the driving situation and your
vehicle's equipment, the system may advise
you to skip one or more gears. You can
follow this instruction without engaging the
intermediate gears.
The gear recommendations should not
be considered compulsory. In fact, the
configuration of the road, the amount of traffic
and safety remain determining factors when
choosing the best gear. Therefore, the driver
remains responsible for deciding whether or not
to follow the advice given by the system.
This function cannot be deactivated.

126
Driving





Cruise control


System which automatically maintains the vehicle speed at the value programmed by the driver, without any action on the accelerator pedal.
The cruise control is switched on
manually:
the vehicle speed must be at least 25 mph
(40 km/h) and second gear or higher must be
engaged in the case of a manual gearbox.
The cruise control is switched off
manually, by
an action on the brake or clutch pedal or if the
ASC system is triggered.
The programmed speed can be exceeded
temporarily by pressing the accelerator pedal.
The cruise control cannot, in any
circumstances, take the place of the
need to comply with speed limits or of the
vigilance and responsibility of the driver. The controls of this system are grouped
together on the steering wheel.


1.
"ON/OFF"
button: activation / deactivation
of the cruise control mode.

2.
"COAST SET"
button: store a driving
speed and decrease the cruising speed.

3.
"ACC R ES "
button: increase the cruising
speed and recall the stored speed.

4.
"CANCEL"
button: stop control of the
vehicle's speed.



Steering mounted controls

When you press button 1
, the "CRUISE"

indicator comes on in the instrument panel.


Display in the instrument panel


Programming



)
Press button 1
.

)
Set the programmed speed by
accelerating to the required speed, then
press button 2 "COAST SET"
.
To return to the programmed speed, simply
release the accelerator pedal.
Switching off the ignition cancels any
programmed speed value.

129
4
Driving





Parking sensors


This function cannot, in any
circumstances, take the place of the
vigilance and responsibility of the driver.



Rear parking sensors

This system indicates the proximity of an
obstacle (person, vehicle, tree, gate, etc.)
which comes within the field of detection of
sensors located in the bumper.
Certain types of obstacle (stake, roadworks
cone, etc.) detected initially will no longer be
detected at the end of the manoeuvre due to
the presence of blind spots.


Audible assistance

The proximity information is given by an
intermittent audible signal, the frequency of
which increases as the vehicle approaches the
obstacle.
When the distance between the vehicle and
the obstacle becomes less than approximately
thirty centimetres, the audible signal becomes
continuous.

The system is switched on by engaging reverse
gear. This is accompanied by an audible signal.
The indicator lamp in the button comes on to
confirm that the system is active.
The system is deactivated when you come out
of reverse gear.