Citroen C4 DAG 2008 1.G Owner's Manual

179
XIII
A U D I O
QUESTIONANSWERSOLUTION
The pre-set stations do not work (no sound, 87.5 Mhz is displayed, etc.).
The waveband selected is not the correct one.Press on the button BAND AST to retrieve the wave band (AM, FM1, FM2, FMAST) where the stations have been memorised.
Traffi c Announcements (TA) is displayed, but I do not receive any road information.
The particular radio station is not in the regional traffi c information network.Change to a radio station which does broadcast traffi c information.
The reception quality of the radio station being listened to gradually deteriorates or the pre-set stations do not work (no sound, 87.5 Mhz displayed, etc.).
The vehicle is too distant from the transmitter of the station being listened to, or no transmitter is present in the geographical area you are passing through.
Activate the RDS function to allow the system to check whether a more powerful transmitter is to be found in the geographical area.
The environment (hills, high buildings, tunnels, underground car parks, etc.) is blocking reception, even in RDS mode.
This phenomenon is normal and does not imply anything wrong with the radio.
The aerial is absent or has been damaged (for example after going through a car wash or in an underground car park).
Have the aerial checked by a CITROËN dealer.Have the aerial checked by a Have the aerial checked by a
Cutting of sound for 1 or 2 seconds in radio mode.
The RDS system during this brief sound cut-off is searching for a better frequency that might offer improved reception of the station.
Deactivate the RDS function if the phenomenon occurs too frequently and always on the same journey.
When the engine is not running, the radio stops after a few minutes.
When the engine is switched off, the working time for the radio depends on the vehicle battery charge.
The interruption is normal: the radio goes into economy mode, cutting off in order to save the vehicle’s battery.
You have to start the engine so as to increase the battery charge.
The message "the audio system is overheating" appears on the screen.
In order to protect the audio equipment in excessive ambient temperatures, the radio goes into an automatic thermic protection mode which results in a reduction in sound volume or stopping of the CD player.
Switch off the audio system for a few minutes in order to allow the system to cool down.

My Way is protected in such a way that it will only operate in your vehicle. If it is to be installed in another vehicle, contact a CITROËN dealer for coni guration of operate in your vehicle. If it is to be installed in another le. If it i
the system.
Certain functions described in this handbook will become available during the course of the year.
My Way
CONTENTS

2
1
5
10
01
2
346
14
12
9
1516
781311
1.
On/Off.
CD/SD card pause, mute for the radio.
Long press: reinitialisation of the system.
2. Volume adjustment.
3. Selection of the RADIO source. Displaying of the l ist of
stations. Access to the RADIO menu.
4. Selection of the MUSIC source. Displaying of the t racks (CD)
or of the folders (SD card). Access to the MUSIC me nu.6.
Opening of the PHONE menu and displaying of the ca ll list.
7. Selection of the successive displaying of:
RADIO, Map, NAV (if navigation is in progress),
Telephone (if a conversation is in progress),
Trip Computer.
Long press: displaying of a black screen (DARK).
8. Opening of the NAVIGATION menu and displaying
of the last destinations.
9. Opening of the TRAFFIC menu and displaying of the current
trafic alerts.
10. Abandon the operation in progress.
11. Navigation through the menus, selection and conirm ation.
Access to the short-cut menus.
Map zoom on Map or NAV display. 12.
CD eject.
13. Selection of the previous/next radio station from the list.
Selection of the previous/next CD.
Selection of the previous/next MP3 directory.
Selection of the previous/next page of a list.
14. Selection of the previous/next radio station.
Selection of the previous/next CD or MP3 track.
Selection of the previous/next line of a list.
15. Buttons 1 to 6:
Selection of the stored radio station.
Selection of the CD in the CD changer.
Long press: storing of the current radio station.
16. SD card reader.
FIRST STEPS
MY WAY CONTROL PANEL
3 - 4 Long press: access to the sound option settings (f ront/rear
and left/right balance, bass/treble, equalizer, lou dness,
automatic volume adjustment, initialise the setting s).
5. Opening of the SETUP menu.
Long press: access to the GPS coverage and the demonstration mode.

3
02GENERAL OPERATIONFor a detailed global view of the menus available, refer to the
"Display low charts" section of this handbook.
Press the MODE button several times in succession t
o gain access to the following menus:
For maintenance of the display, the use of a soft, non-abrasive cloth
(spectacles cloth) is recommended, without any addi tional product.
RADIO/MUSIC MEDIA PLAYERS
PHONE
(If a conversation is in progress)
TRIP COMPUTER FULL SCREEN MAP
NAVIGATION
(If navigation is in progress)
SETUP:
system language, date and time, display,
vehicle parameters, units and system parameters TRAFFIC:

TMC information and messages

4
02
1
2
3
3
2
1
1
1
3
2
1
1
1
1
1
1
1
1
1
1
1
1
2
2
2
2
1
1
2
1
2
2
2
2
2
2
2
1
1
1
1
1
1
GENERAL OPERATION
A press on the OK dial to permits access
to short-cut menus according to the
display on the screen. TRIP COMPUTER:
alert log
status of functions
MUSIC MEDIA PLAYERS: TA
play options
normal
random track
repeat folder
track intro
select music
NAV:
abort guidance
repeat advice
block road
route info
show dest.
trip info
route type
avoidance criteria
satellites
zoom/scroll voice advice
route options RADIO:
in FM modeTA
RDS
radiotext
regional prog. (REG)
AM
in AM mode TA
refresh AM list
FM
MAP:
abort/resume guidance
set destination
POIs nearby
position info
map settings
zoom/scroll
PHONE:
end call
hold call
dial
dtmf tones
private mode
micro off
SHORT-CUT MENUS

5
03
1
2
3
6
5
4
NAVIGATION - GUIDANCE
SELECTING A DESTINATION
Press the NAV button again or select
the NAVIGATION MENU function and
press the dial to conirm.
Select the DESTINATION INPUT
function and press the dial to conirm.
Press the NAV button.
Select the letters of the town one by
one conirming each time by pressing
the dial.
Once the country has been selected,
turn the dial and select the town
function. Press the dial to conirm.
NAVIGATION MENU
DESTINATION INPUT
Insert the SD card in the front panel reader and le
ave it there to use the Navigation functions.
The navigation SD card data must not be changed.
The map data updates are available from CITROËN dea lers.
A pre-set list (by entering the irst few letters) o f the towns in the
country selected can be accessed via the LIST butto n on the virtual
keypad. Select the NEW DESTINATION
INPUT function and press the dial to
conirm.
NEW DESTINATION INPUT
The list of the last 20 destinations appears under
the NAVIGATION
MENU function.

6
7
8
10
9
During guidance, pressing the end of the lights stalk repeats the last spoken guidance
instruction.
Repeat steps 5 to 7 for the STREET
and N° functions.
Turn the dial and select OK.
Press the dial to conirm.
Select the SAVE TO ADDRESS BOOK function to record the
address entered in a directory ile. Press the dial to conirm the
selection.
The system permits the recording of up to 4 000 con tact iles.
To speed up the process, the post code can be enter
ed directly after
selecting the POST CODE function.
Use the virtual keypad to enter the letters and dig its.Select the route type:
FAST ROUTE, SHORT ROUTE or
OPTIMISED ROUTE and press the
dial to conirm.
Then select START ROUTE
GUIDANCE and the press the dial to
conirm.
You can zoom in/zoom out on the map using the dial.
It is possible to scroll the map or select its orie ntation via the short-
cut menu of the FULL SCREEN MAP. Press the dial the n select
MAP SETTINGS or ZOOM/SCROLL and conirm.
It is also possible to select a destination FROM AD
DRESS BOOK or
FROM LAST DESTINATIONS.
FROM ADDRESS BOOKFROM LAST DESTINATIONS
START ROUTE GUIDANCE

7
03
5
6
7
1
2
3
4
NAVIGATION - GUIDANCE
ROUTE OPTIONS
Select the ROUTE DYNAMICS
function.
This function provides access to the
TRAFFIC INDEPENDENT or SEMI-
DYNAMIC options.
Select the AVOIDANCE CRITERIA
function. This function provides
access to the AVOID options
(motorways, toll roads, ferries).
Turn the dial and select the
RECALCULATE function to take into
account the route options selected.
Press the dial to conirm.
Press the NAV button.
Press the NAV button again or select
the NAVIGATION MENU function and
press the dial to conirm.
Select the ROUTE TYPE function and
press the dial to conirm. This function
allows you to change the route type.
Select the ROUTE DYNAMICS
function.
Select the ROUTE OPTIONS function
and press the dial to conirm.
NAVIGATION MENU
ROUTE OPTIONS
ROUTE TYPE
ROUTE DYNAMICS
AVOIDANCE CRITERIA
RECALCULATE
The route selected by the system depends directly o
n the route options.
Changing these options may change the route complet ely.

8
5
6
7
1
2
3
4
ADDING A STOPOVEREnter a new address, for example.
Once the new address has been
entered, select OK and press the dial
to conirm.
Select RECALCULATE and press the
dial to conirm.
Press the NAV button.
Press the NAV button again or select
the NAVIGATION MENU function and
press the dial to conirm.
Select the ADD A STOPOVER
function (5 stopovers maximum) and
press the dial to conirm.
Select the STOPOVERS function and
press the dial to conirm.
NAVIGATION MENU
STOPOVERS
ADD A STOPOVER
ENTER AN ADDRESS
OK
The stopover must be completed or deleted in order
for the guidance
to continue to the next destination. Otherwise, the system will always
return you to the previous stopover.
Stopovers can be added to the route once the destin
ation has been selected.
RECALCULATE

9
03
1
2
3
4
7
85
6
NAVIGATION - GUIDANCE
SEARCHING FOR POINTS OF INTEREST
Press the NAV button.
Press the NAV button again or select
the NAVIGATION MENU function and
press the dial to conirm.
Select the POI NEARBY function to
search for POIs around the vehicle.
Select the SEARCH POINTS OF
INTEREST function and press the
dial to conirm.
NAVIGATION MENU
SEARCH POINTS OF INTEREST
POI NEARBY
Select the POI IN CITY function to
search for POIs in the city required.
Select the country then enter the
name of the city using the virtual
keypad.
Select the POI NEAR ROUTE
function to search for POIs near the
route.
Select the POI IN COUNTRY function
to search for POIs in the country
required.
Select the POI NEAR DESTINATION
function to search for POIs near the
point of arrival of the route.
POI NEAR DESTINATION
POI IN COUNTRY
POI NEAR ROUTE
A list of cities present in the country selected ca n be accessed via
the LIST button on the virtual keypad.
POI IN CITY
The points of interest (POIs) indicate all of the s ervice locations in the vicinity (hotels, various
businesses, airports...).