dimensions Citroen C4 DAG 2008.5 1.G Owner's Manual

Page 3 of 282

6
F A M I L I A R I S A T I O N
O P E N I N G

 Unlock the vehicle with the remote
control or the key.

 Press up on the lever and lift the
tailgate.
Tailgate Spare wheel and tools
Access to the spare wheel

 Lift the carpet, then remove the tool
holder to gain access to the wheel.

 134
Locking filler cap

 Turn the key a quarter turn to lock
and unlock the fi ller cap.
When refuelling, place the cap on the
carrier on the inside face of the fi ller
fl ap.

 68 If your spare wheel is of different
dimensions to the wheels on the
vehicle, it is essential to use it only
on a temporary basis, and to not
drive above 80 km/h (50 mph).

 67 Access to the tools
The tools are located in a protective
holder in the spare wheel.

B. Removing the fi ller cap.
Fuel tank capacity: 10 litres approxi-
mately.

A. Opening the fuel fi ller fl ap.
To open the fuel fi ller fl ap, pull at its
notched edge. There is a fuel label on
the inside of the fl ap.
Fuel tank

Page 157 of 282

135
XI
P R A C T I C A L I N F O R M A T I O N
Refi tting the wheel Dimension of the spare wheel
If your spare wheel is of different
dimensions to those on the vehicle
(identifi ed by a label), it is essential
to use it only on a temporary basis,
to drive not above 80 km/h (50 mph)
and to have the original wheel refi t-
ted as soon as possible.

Switch on your hazard
warning lamps.

Never get underneath the
vehicle if it is supported only by
the jack; use an axle stand.

The jack is designed specifi cally
for your vehicle, do not use it for
other applications.

Refi t the repaired original wheel
as soon as possible.

With a spare wheel fi tted, drive
with caution.

The wheel should be correctly
positioned fl at in the centre of
its well. Light alloy wheels
If your vehicle is equipped with
light alloy wheels and a steel spare
wheel, then if fi tting the latter it is
normal to note that the heads of the
wheel bolts do not come to bear on
the wheel rim.
The steel spare wheel is secured
by the conical tapering of the wheel
bolts’ shafts, see diagram.
When refi tting the light alloy wheel,
ensure that the wheel bolt heads are
in undamaged condition.

 Refi t the wheel in place.

 Undo the yellow central screw by
a few turns, then position it at the
centre of the wheel.

 Do up the central screw until tight
so that the wheel is securely re-
tained in place.

Page 192 of 282

168
XII
T E C H N I C A L D A T A

3-door
model
5-door
model

A 2.608

B 4.288 4.275

C 0.950

D 0.730 0.717

E 1.502/1.510

F 1.497/1.505

G 1.769 1.773

H 1.456/1.496

I 1.964
DIMENSIONS (IN METRES)