height adjustment Citroen C4 PICASSO 2008 1.G Owner's Manual

Page 9 of 266

1
23
IN BRIEF
I
12
G E T T I N G S T A R T E DF r o n t s e a t s
Head restraint
Backrest angle
Seat height adjustment
Lumbar support
Longitudinal adjustment
Armrest
Manual adjustments
Electric adjustments :
Adjustment of seat height and angle, longitudinal adjustment
Adjustment of backrest angle and lumbar support
Driver : memorisation of driving positions
Note : The seats can also be ad-justed on a temporary basis :
- on opening one of the front doors,
- after switching on the ignition.
Heated seat control (located on the inside of the front seats)

Page 10 of 266

A
1
2
1
2
IN BRIEF
I
13
G E T T I N G S T A R T E D
Adjusting the steering wheel
The steering wheel can be adjusted in terms of height and reach.
Unlock the steering wheel by pull-ing control A towards you.
Adjust the position of the steer-ing wheel then lock it pushing the control back fully.
Automatic photochromic interior rear view mirror
This modifi es its role automatically and progressively between day use and night use.
It can be deactivated using control 1.
Child mirror (2)
This allows you to monitor the rear passengers. It can be folded away to eliminate dazzle.
Rear view mirrors adjustment
This operates with the ignition switched on.
From the driver’s seat, select the rear view mirror by moving control 1 to the left or right, then adjust the rear view mirror as required in the 4 directions using control 2.
Demisting-deicing of the rear view mirrors is linked to that of the rear screen.
Rear view mirrors foldback
When the vehicle is parked, the rear view mirrors can be folded back either manually or automati-cally.For safety reasons, these ad-justments must not be carried out whilst driving.

Page 80 of 266

A
80
II
FRONT AND REAR FOGLAMPS (Ring A)
In foggy conditions, if the ambient brightness is not such as to activate the automatic lighting, it is up to you to switch on your dipped beams manually, along with your foglamps as necessary.
These operate in conjunction with the sidelamps, the dipped beams or the main beams.
Headlamps adjustment
Depending on the vehicle load, it is recommended that you correct the height of your headlamp beams.
On the dashboard beside the driver :
0 Unladen
1 Partial load
2 Medium load
3 Full load.
Note : Vehicles equipped with Xenon dual-function directional headlamps have an automatic adjustment of headlamps depending on load.
For a vehicle equipped with rear foglamps :
- 1st turn forwards : lighting of rear foglamps.
- 1st turn rearwards: extinction of rear foglamps.
For a vehicle equipped with front and rear foglamps:
- 1st turn forwards: lighting of front foglamps.
- 2nd turn forwards: lighting of rear foglamps.
- 1st turn rearwards: extinction of rear foglamps.
- 2nd turn rearwards: extinction of front foglamps.
Note : Foglamps should be used only in conditions of fog or snowfall.
GUIDE-ME-HOME LIGHTING
With the ignition off, this func-tion temporarily switches on your headlamps to give you exterior lighting when you are leaving your vehicle.
This function is activated :

Page 81 of 266

A
80
II
FRONT AND REAR FOGLAMPS (Ring A)
In foggy conditions, if the ambient brightness is not such as to activate the automatic lighting, it is up to you to switch on your dipped beams manually, along with your foglamps as necessary.
These operate in conjunction with the sidelamps, the dipped beams or the main beams.
Headlamps adjustment
Depending on the vehicle load, it is recommended that you correct the height of your headlamp beams.
On the dashboard beside the driver :
0 Unladen
1 Partial load
2 Medium load
3 Full load.
Note : Vehicles equipped with Xenon dual-function directional headlamps have an automatic adjustment of headlamps depending on load.
For a vehicle equipped with rear foglamps :
- 1st turn forwards : lighting of rear foglamps.
- 1st turn rearwards: extinction of rear foglamps.
For a vehicle equipped with front and rear foglamps:
- 1st turn forwards: lighting of front foglamps.
- 2nd turn forwards: lighting of rear foglamps.
- 1st turn rearwards: extinction of rear foglamps.
- 2nd turn rearwards: extinction of front foglamps.
Note : Foglamps should be used only in conditions of fog or snowfall.
GUIDE-ME-HOME LIGHTING
With the ignition off, this func-tion temporarily switches on your headlamps to give you exterior lighting when you are leaving your vehicle.
This function is activated :

Page 86 of 266

A
II
85
For safety, these ma-noeuvres should not be performed while the vehi-cle is in motion.
FRONT SEAT BELTS
Fastening
Pull the belt down in front of you in a steady movement, making sure that it does not become twisted.
Press the fastening into its buckle.
Check that it is properly secured and that the automatic locking mechanism operates correctly by pulling sharply on the belt strap.
The abdominal part of the strap should be positioned as low down as possible in the lap and as tight as possible.
ADJUSTING THE STEERING
WHEEL
The steering wheel can be adjusted for height and reach. WITH THE VEHICLE STATION-ARY, fi rst adjust your seat to the most suitable position, then adjust the position of the steering wheel. Unlock the steering wheel by pulling the control A towards you. AAdjust the position of the steering wheel then lock it by pushing the control fi rmly back into its initial lo-cation.
Note : If you press fi rmly on your steering wheel after locking, a small click may be heard.
S T E E R I N G W H E E L A D J U S T M E N T
S E A T B E L T A D J U S T M E N T
The chest part should be posi-tioned if possible in the channel of the shoulder.
Each belt has a reel that adjusts its length automatically to the girth of the seat occupant.
Height adjustment
The correct positioning of the seat belt reel is around mid-shoulder level.
To adjust the belt, pinch the con-trol and slide it in the direction re-quired.
Unfastening
To unfasten the belt, press on the red button in the buckle.
The belt retracts automatically when not in use.

Page 112 of 266

110
III
Head restraint
To raise it, pull it upwards. To lower it, press on the control as well as on the head restraint. The adjustment is correct when the top of the head restraint is level with the top of the head. It can also be adjusted for tilt.
To remove it, press on the unlocking button and pull it up-wards.
To adjust the head restraint fore/aft, move the base of the head restraint to obtain the position desired.
Note : Never drive without the head restraints fi tted.
Backrest angle
Action the control and adjust the angle of the backrest.
It is possible to incline the backrest 45° rearwards by tilting it until it locks ; to unlock it, lift the control.
Seat height adjustment
Raise or lower the the control the number of times necessary to obtain the position desired.
Lumbar support
Rotate the control until you attain the position desired.
Longitudinal adjustment
Raise the control bar, then slide the seat to the positio n desired.
Armrest
To adjust the position of the armrest, pull it up and then fully down, and then raise it to the desired position.
F R O N T S E A T S M A N U A L A D J U S T M E N T S

Page 113 of 266

1
2
III
111
Heated seats
The front seats can be heated independently. Use the controls on the inner sides of the seats and choose one of the three heat intensities below
0 : Off.
1 : Slight heat.
2 : Medium heat.
3 : Strong heat.
The seat temperature will adjust automatically.
Note : the heated seats only func-tion when the engine is running.
Note : The seats can also be adjusted on a temporary basis :
- on opening one of the front doors.
- after switching off the ignition.
Electric adjustments :
Adjustment of seat height and angle, longitudinal adjustment
Adjustment of backrest angle and lumbar support
Raise or lower the front of control 1 to raise or lower the front of the seat base (on driver’s seat).
Raise or lower the rear of control 1 to raise or lower the seat.
Action control 1 forwards or rearwards to slide the seat forwards / backwards.
Push the top of control 2 forwards or rearwards to adjust the backrest angle.
Raise or lower control 2 to increase or decrease the lumbar support.
F R O N T S E A T S E L E C T R I C A D J U S T M E N T S

Page 122 of 266

III
119
A Lounge version is available in the 5 seater model. This has two se-cond-row seats that are identical to the fi rst-row seats, providing greater comfort for rear passengers.
ADJUSTING THE SEATS
The seats have the following adjust-ments :
- head-restraint adjustment,
- backrest angle,
- greater longitudinal adjustment,
- height-adjustable armrests.
Refer to the page " FRONT SEATS - Manual adjustments " for the operation of the adjustment controls.
LUGGAGE COVER BEHIND
THE SEATS
A fl exible luggage cover positio-ned behind the second-row seats enables you to prevent objects from sliding under or between the second-two seats, as well as concealing the contents of your boot from outside view.
It is fi xed to the fl oor by two hooks located behind the seats and an-chored at special points on the rear pillars.
This fl exible luggage cover is mo-vable and can be rolled up for stowage behind the second-row seats.
SEAT BELTS
For safety reasons, always attach your seat belt before positioning the armrest between yourself and the door.
STORAGE POCKETS
Two storage pockets are located on the insides of the Lounge ver-sion seats.
F E A T U R E S O F T H E 4 S E A T E R
L O U N G E V E R S I O N