Citroen C4 PICASSO 2016 2.G Owner's Manual
Page 341 of 527
Page 342 of 527
Page 343 of 527
Page 344 of 527
Page 345 of 527
C4-Picasso-II_en_Chap11_index-alpha_ed01-2016
Page 346 of 527
C4-Picasso-II_en_Chap11_index-alpha_ed01-2016
Page 347 of 527
16B78.0010
Arial Bold 12 pt
03-16
4Dconcept
Dia D eis
i
nterakLabels are applied at various points on your vehicle. They carry
safety warnings as well as vehicle identification
information.
Do
not
remove
them:
they
form
an
integral
part
of
your vehicle.
Automobiles CITROËN
declares, by application of the
provisions
of the European legislation (Directive 2000/53)
relating
to End of Life Vehicles, that it achieves the
objectives
set by this legislation and that recycled materials
are
used in the manufacture of the products that it sells.
Reproduction or translation of all or part of this document
is prohibited without written authorisation from Automobiles
CITROËN. We
draw your attention to the following points:
-
The
fitting of electrical equipment or accessories not
listed by CITROËN
may cause faults and failures
with
the electrical system of your vehicle. Contact
a
CITROËN dealer for information on the range of
recommended
accessories.
-
As
a safety measure, access to the diagnostic socket,
used
for the vehicle's electronic systems, is reserved
strictly
for CITROËN dealers or qualified workshops,
equipped
with the special tools required (risk of
malfunctions
of the vehicle's electronic systems that
could
cause breakdowns or serious accidents).
The
manufacturer cannot be held responsible if this advice is
not
followed.
-
Any
modification or adaptation not intended or
authorised by
Automobiles CITROËN or carried out
without
meeting the technical requirements defined by
the manufacturer would lead to the suspension of the
legal
and contractual warranties.Printed in the EU
Anglais
For
any work on your vehicle, use a qualified workshop
that
has the technical information, skills and equipment
required,
all of which a CITROËN dealer is able to provide.
* Subject to official publication of the results by the FIA.
Page 348 of 527
16B78.0010
Arial Bold 12 pt
C4-Picasso-II_en_Chap00_couv-imprimeur_fin_ed01-2016
16B78.0040Anglais*16B78.0040*
Page 349 of 527
306
In the event of a breakdown
C4-Picasso_II_en_Chap08_en_cas_panne_p306_ed01-2016
Lamps on the tailgate
For reassembly, carry out these operations in reverse order.
Identify the failed bulb. Open the boot. Remove the access cover.
Remove the three lamp fixing screws A . Disconnect the lamp connector. Carefully remove the lamp from the outside by pressing the retaining clip B .
To change a reversing lamp or direction indicator bulb: Use a standard pair of pliers to turn the bulb holder a quarter turn anticlockwise, and pull it out. Change the bulb. Model with LED lamps
Model with conventional bulb lamps
To change a sidelamp and brake lamp bulb: Turn the bulb holder a quarter of a turn anti-clockwise and pull the bulb out. Change the bulb.
Page 350 of 527
Transversal-Citroen_en_Chap00_debut
AUDIO AND TELEMATICS GUIDE