sensor Citroen C4 PICASSO RHD 2013 1.G Owner's Guide

198
Driving
Assistance in exiting from a
parallel parking space
) With the vehicle stationary, press
this control at the steering wheel,
)
Press on "Exit parking slot
" in
the touch screen tablet.
) Operate the direction indicator for the exitside chosen.)
Engage reverse or for ward gear and
release the steering wheel.
)
The assisted parking manoeuvre is in
progress. Without exceeding 3 mph(5 km/h), move for wards and backwards,
aided by the warnings from the "Parking sensors" system, until the indication of the end of the manoeuvre.
The manoeuvre is complete when the vehicle'sfront wheels are clear of the parking space.
At the end of the manoeuvre, the indicator lamp
in the instrument panel goes off, accompanied
by a message and an audible signal.
The assistance is deactivated: you can take over control.

)When you want to leave a parallel parkingspace, star t the engine.
or
)Select "Park Assist
" in the " Driving assistance
" menuof the touch screen tablet toactivate the function.
This indicator lam
p comes on in
the instrument panel to confirm the
activation of the function.

200
Driving

During a bay parking manoeuvre, thePark Assist system is automaticallydeactivated once the rear of the vehicle is within 50 cm of an obstacle.
) Select reverse, release the steerin
g wheeland star t moving without exceeding 5 mph (8 km/h).
)The assisted parking manoeuvre is in progress.
Without exceeding 5 mph (8 km/h), follow
the instructions displayed in the instrumentpanel, aided by the warnings from the"Parking sensors" system, until the indication of the end of the manoeuvre. At the end of the manoeuvre, the operatin
gindicator lamp goes out in the instrument panel,
accompanied by a message and an audible
signal. The assistance is deactivated: you can takeover control.



During parking and exit fromparking manoeuvres, the reversingcamera function may come intooperation. It facilitates monitoring of the surroundings of the vehicle,by displaying additional information in the instrument panel (see thecorresponding section).

201
4
Driving
The system is deactivated automatically:


- on switching off the ignition,

- if the engine stalls,

- if no manoeuvre is star ted within 5 minutes
of selection of the t
ype of manoeuvre,

- after a prolonged stop of the vehicle during a manoeuvre,

- if the road wheel anti-spin regulation (ASR) is triggered,

- if the speed of the vehicle exceeds thestated limit,

- when the driver interrupts movement of the steering wheel,

- if the driver presses the Park Assist control.

- after 4 manoeuvre c
ycles,

- on opening the driver's door,

- if one of the front wheels encounters anobstacle.
The operation indicator lamp goes off in the
instrument panel and a message is displayed
accompanied b
y an audible signal.
The driver should then take back control of thevehicle's steering.


Deactivation


If the system is deactivated during a manoeuvre, the drive should reactivate it manually to repeat the measurement.
The s
ystem is switched off automatically:
- when towing a trailer,
- if the driver's door is opened,
- if the speed of the vehicle is above 42 mph(70 km/h).
To switch the system of for a prolonged period, contact a CITROËN dealer or a qualified workshop.

In the event of a fault with the system,
this warning lamp is displayed in the
instrument panel and a messa
ge appears,
accompanied b
y an audible signal.
Operating faults
In the event of a fault with the power steering, this warning lamp
comes on in the instrument panel accompanied by an aler t message.
Contact a CITROËN dealer or a qualified
workshop.
Switching off

If the lateral distance between your vehicle and the space is too great, the system maynot be able to measure the space.
Anything projecting beyond the envelopeof the vehicle (long or wide load) is not taken into account by the Park Assist system during a manoeuvre.

In bad weather or in winter, ensure thatthe sensors are not covered by road dir t, ice or snow.
In the event of a fault, have the systemchecked by a CITROËN dealer or a qualified workshop.
The indicator lamp
for the function flashes for a few seconds.
If the fault occurs during the use of
the system, the indicator lamp goesoff.

205
5
Visibility

Operation of the rear foglamps is inhibited with the tailgate open. Opening the boot when these lamps are on causes them and their indicator lamp in the instrument panel to go off. They do not come back onautomatically when the boot is closed: they must be switched on again using the control stalk.

In good or rainy weather, by both day and night, the front foglamps and therear foglamps are prohibited. In thesesituations, the power of their beams may dazzle other drivers. They should only be used in fog or falling snow.In these weather conditions, you shouldswitch on the foglamps and dippedbeam headlamps manually, as thesunshine sensor may detect sufficient light.Do not forget to switch off the front andrear foglamps when they are no longer necessary.


Switching off the lightingwhen switching off the ignition

When the ignition is switched off, all of thelamps switch off immediately, except for thedipped beam headlamps if automatic guide-me-home lighting is activated.


Switching on the lightingwhen switching on the ignition

To reactivate the lighting control stalk, turn the ring A
to position A"0"- lighting off, thento the position of your choice.
If the lighting is switched on manually after switching off the ignition, there is an audiblesignal when a front door is opened to warnthe driver that they have forgotten to switch
off the vehicle's lighting, with the ignition off.
They switch off automatically after a periodwhich depends on the state of charge of thebattery (entry to energy economy mode).

207
5
Visibility
Automatic illumination
of headlam
ps

Activation
)Turn the ring to the "AUTO"position. The activation of the function is accompanied
by the display of a message. When a low level of ambient li
ght is detected by a sunshine sensor, the number platelamps, sidelamps and dipped beam headlamps
are switched on automatically, without any
action on the par t of the driver. They can alsocome on if rain is detected, at the same time as
automatic operation of the windscreen wipers.

As soon as the brightness returns to asufficient level or after the windscreen wipers
are switched off, the lamps are switched off
automatically.
Deactivation
) Turn the ring to another position.Deactivation of the function is
accompanied by the display of a message.

Operating fault

In the event of a malfunction of the sunshine sensor, the lighting comes on, this warning lamp is displayed
In fog or snow, the sunshine sensor may detect sufficient light. In this case, thelighting will not come on automatically. Do not cover the sunshine sensor, coupled with the rain sensor andlocated in the centre of the windscreen behind the rear view mirror; the associated functions would no longer be controlled.



Automatic "guide-me-
home" lighting


When the automatic illumination of headlampsfunction is activated, under low ambient light the dipped beams headlamps come on
automatically when the ignition is switched off.

Programming
Activation or deactivation, as well as the
duration of the guide-me-home lighting, is set in the " Driving aids" menu, then "Vehicle
settings".
Contact a CITROËN dealer or a qualifiedworkshop.
in the instrument panel accompanied by an audible signal and/or a message.

210
Visibility
To make your approach to the vehicle easier,
these illuminate:


- the zones facing the driver’s and
passenger’s doors,

- the zones forward of the door mirrors andrearward of the front doors.


Door mirror spotlamps


Switching on

The spotlamps come on automatically:


- when you unlock the vehicle,

- when you remove the electronic key from the reader,

- when you open a door,

- when you use the remote control to locate the
vehicle.




Switching off

They go off automatically after 30 seconds.

Exterior welcome lighting


Switching on
)
Press the open padlock on the
remote control or one of the front
door handles with Keyless Entry
and Star ting.
The dipped beam headlamps
and the sidelamps come on; your
vehicle is also unlocked.




Programming
Daytime running lamps
(LEDs)
They come on automatically when the engineis star ted, when the lighting control stalk is in position "0" or " AUTO".

In some weather conditions (e.g. low
temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.
The remote switching on o
f the lighting makesyour approach to the vehicle easier in poor
light. It is activated when the lighting control
is in the "AUTO" position and the level of light
detected by the sunshine sensor is low.



Switching off

The activation, deactivation and choice of
welcome lighting duration are done in the
" Driving assistance" menu then "Vehicle
settings". The exterior welcome li
ghting switches off
automatically after a set time, when the ignition
is switched on or on locking the vehicle.

217
5
Visibility
The windscreen wipers operate automatically,
without any action on the par t of the driver, if
rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.

Switching on
Switching off
The automatic rain sensitive windscreenwipers must be reactivated by pushing the control stalk downwards, if theignition has been off for more than oneminute. Brie
fly push the control stalk downwards.
A wiping cycle confirms that the instruction has been accepted.
This warning lamp comes on in theinstrument panel and a message is displayed. Brie
fly push the control stalk
downwards again, or place the control stalk in another position (Int, 1 or 2).
Automatic rain sensitive
w
indscreen wipers
This warning lamp goes off in the instrumentpanel and a message is displayed.

218
Visibility
Special position of the
w
indscreen wipers

To maintain the effectiveness of the "flat-blade" type of wiper blades, it is advisable to:


- handle them with care,

- clean them regularly using soapywater,

- avoid using them to retain cardboard on the windscreen,

- replace them at the first signs of wear.
This position permits release o
f the windscreen
wiper blades.
It is used for cleaning or replacement of the blades. It can also be useful, in winter, todetach the blades from the windscreen.
Do not cover the rain sensor, linked with the sunshine sensor and located in the centre of the windscreen behind the rear view mirror.
Switch off the automatic rain sensitivewipers when using an automatic car wash.
In winter, it is advisable to wait until thewindscreen is completely clear of ice before activating the automatic rain sensitive wipers.

Operating fault
If a fault occurs with the automatic rain sensitive wipers, the wipers will operate in
intermittent mode.
Have it checked by CITROËN dealer or a
qualified workshop.

On switching off the ignition: )
any action on the wiper stalk in the minute
after switching off the ignition places the
blades vertically on the screen.
When the system is no longer powered - at least
one minute after switching off the ignition - it is
possible to move the arms manually. ) To park the blades again, switch on the
ignition and operate the wiper stalk.
Replacement of the arms must only be done by a CITRO

224
Safety








Ty r e u n d e r - i nfl ation detection
The system continuously monitors thepressures on the four tyres, once the vehicle is moving.
It compares the information given by the four
wheel speed sensors with reference values,
which must be reinitialised ever
y time the tyre pressures are adjusted or a wheel changed. The system triggers an aler t as soon as it
detects a drop in the inflation pressure of one
or more tyres.
The under-inflation detection system does not replace the vigilance or theresponsibility of the driver. This system does not avoid the need tocheck the tyre pressures (including the spare wheel) every month as well as before a long journey. Driving with under-inflated tyres impairsroad holding, extends braking distances and causes premature tyre wear,particularly under arduous condition(high loading, high speed, long journey). S
ystem which automatically checks the pressure of the tyres while driving.

The inflation pressures defined for your vehicle can be found on the tyrepressure label (see the "Identificationmarkings" section). Tyre pressures should be checkedwhen the tyres are "cold" (vehicle stopped for 1 hour or after a journey of less than 6 miles (10 km) at moderatespeeds). Other wise, add 0.3 bar to the pressures shown on the label.

Driving with under-inflated tyresincreases fuel consumption.

290
Practical information

Type 1 fuse tables
Fusebox 1


Dashboard fuses

The fusebox is located in the lower dashboard (left-hand side).
Access to the fuses
)Refer to the paragraph "Access to the tools".
Fuse N°RatingFunctions
F
85 A Steering mounted controls
F1
820 A Touch screen tablet, audio and navigation system, CD player,USB por ts and auxiliary sockets.
F1
615 A
Front 12V socket.
F1
515 A
Boot 12V socket.
F2
85 A STA R T/STOP button.
F3
015 A Rear wiper.
F27 15 A
Front screenwash pump, rear screenwash pump.
F2
615 A
Horn.
F20 5
A Airbags.
F215 A Instrument panel.
F1
95 A Rain and sunshine sensor.
F12 5
A Keyless starting unit.
F2 5
A Manual headlamp adjustment control.