sensor Citroen C4 PICASSO RHD 2013 1.G User Guide

165
4
Driving
SymbolAssociated messageComments
" SYSTEM INACTIVE: S
peedunsuitable"If the speed of your vehicle is outside the operating range.
Where the speed is not suitable, a message is displayed while the speed is outside limits(below 42 mph (70 km/h) or above 93 mph (15 0 km / h), approximately). However, when
decelerating, the system is deactivated below 27 mph (45 km/h).
" System deactivated
"
On deactivating the function, in "DRIVING" display mode.
"
SYSTEM INACTIVE:Visibility reduced"The system switches to standby automatically if the sensor does not detect the vehicle in front correctly (very difficult weather conditions, sensor out of adjustment, ...).

166
Driving
The vehicle being followed may not be detected
in cer tain conditions such as, for example:
- when turnin
g,
- when changing lane,
- when the vehicle in front is out of the range
of the sensor (maximum range: around
100 m).
Operating limits
In the event of a fault with the system,
this warning lamp is displayed
accompanied by a message.

Operating fault

Have the system checked by a CITROËN
dealer or a qualified workshop.

At the first use of the system after repair, a message may be displayedindicating that the system is initialising. The system is not available while this is in progress. As soon as the message disappears the system is operationalagain. If the message does notdisappear, contact a CITROËN dealer or a qualified workshop.


The operation of the radar, located in the front bumper, may be disturbed by accumulations of grime (dust, mud...) or in certain weather conditions (snow, ice...).
The message "SYSTEM INACTIVE:Visibility reduced" is displayed to signal that the system has been put intostandby.
Clean the front bumper regularly.

186
Driving








Blind spot sensors

A warning lamp appears in the door mirror on
the side in question:


-
immediately, when being over taken,

- after a delay of about one second, whenover taking a vehicle slowly. This drivin
g assistance system warns the driver
of the presence of another vehicle in the blind
spot angle of their vehicle (areas masked from
the driver's field of vision), as soon as thispresents a potential danger.
Sensors fitted in the front and rear bumpersmonitor the blind spots.

This system is designed to improve safety when driving and is in no circumstances a substitute for the use of the interior rear view mirror and door mirrors. It is the driver'sresponsibility to constantly check the traffic, to asses the distances and relative speeds of other vehicles and to predict their movements before deciding whether to change lane.
The blind spot sensor system can never replace the vigilance and responsibility of thedriver.

Activation of the system is done in the " Driving assistance
" menu, with the ignition on.
)
Press this button to activate the
function; the associated indicator lamp comes on.
This indicator lamp comes on in the
instrument panel.

188
Driving
To deactivate the system, press
this button a
gain; its indicator lamp goes off as well as theassociated indicator in the
instrument panel. In the event of a fault, the warnin
g
lamp flashes then goes off.

Operating fault

Have it checked by a CITROËN dealer or aqualified workshop.
The system is automatically deactivated when towing with a towbar approved by CITROËN.


The system may suffer temporary interference in certain weather conditions (rain, hail...).
In par ticular, driving on a wet surface or moving from a dry area to a wet area can cause false alerts (for example, the presence of a fog of water droplets in the blind spot angle is interpreted as avehicle).
In bad or wintry weather, ensure thatthe sensors are not covered by mud, iceor snow. Take care not to cover the warning zone in the door mirrors or the detectionzones on the front and rear bumpers with adhesive labels or other objects;they may hamper the correct operation of the system. The state o
f the system remains in memory on switching off the ignition.
High pressure jet wash When washing your vehicle, direct the lance at least 30 cm away from the sensors.

189
4
Driving
This system indicates the proximity of an
obstacle (person, vehicle, tree, gate, etc.) which comes within the field of detection of sensorslocated in the bumper.
Certain types of obstacle (stake, roadworkscone, etc.) detected initially will no longer bedetected at the end of the manoeuvre due to
the presence of blind spots.






Parking sensors


This function cannot, in any circumstances, take the place of the vigilance and responsibility of the driver.The system is switched on by engaging reverse
gear. This is accompanied by an audible signal.
The system is switched off when you exit reverse gear.
Audible assistance
The proximity information is given by anintermittent audible signal, the frequency of whichincreases as the vehicle approaches the obstacle.
The sound emitted by the speaker (right or left)indicates the side on which the obstacle is located.
When the distance between the vehicle andthe obstacle becomes less than approximately
thirty centimetres, the audible signal becomescontinuous.

Rear parking sensors


Visual assistance

This supplements the audible signal bydisplaying bars in the screen or the instrument
panel which move progressively nearer to
the vehicle. When the obstacle is near, the"Danger" symbol is displayed.

190
Driving
Front par king sensors

The sound emitted by the speaker (frontor rear) indicates whether the obstacle is in front or behind.
The system will be deactivatedautomatically if a trailer is beingtowed or a bicycle carrier is fitted ona towbar (vehicle fitted with a towbar installed in line with the manufacturer'srecommendations).

In bad weather or in winter, ensure that the sensors are not covered with mud, ice or snow. When reverse gear isengaged, an audible signal (long beep)indicates that the sensors may be dirty.
Cer tain sound sources (motorcycle,lorry, pneumatic drill, etc.) may trigger the audible signals of the parkingsensor system. In addition to the rear parkin
g sensors, the front parking sensors are triggered when an obstacle
is detected in front and the speed of the vehicle
is still below 6 mph (10 km/h).
The front parking sensors are interrupted if
the vehicle stops for more than three seconds
in for ward
gear, if no fur ther obstacles are
detected or when the speed of the vehicle
exceeds 6 mph (10 km/h).

Deactivation / Activation of thefront and rear parking sensors

The system is deactivated in the " Drivingassistance" menu in the touch screen tablet.


Operating fault

In the event of a malfunction of
the system, when reverse gear
is engaged this warning lamp is
displa
yed in the instrument panel and/or a message appears, accompaniedby an audible signal (short beep).
Contact a CITROËN dealer or a qualified
workshop.
)Press this button. The indicator lamp in the button comes on.
Pressin
g this button again reactivates the system.The indicator lamp in the button goes off.

High pressure jet wash
When washing your vehicle, do notdirect the lance within 30 cm of thesensors.

The parking sensors are deactivated while the Park Assist system is measuring a space.See the "Park Assist" section.

191
4
Driving





Reversing camera


Clean the reversing camera regularly using a soft, dry cloth.
The reversing camera is activated automatically
when reverse gear is engaged.
Depending on version, the image is displayed in
the touch screen tablet or the instrument panel.
The space between the blue lines represents
the width of your vehicle except for the door
mirrors.
The blue lines represent the general direction of the vehicle.
The red lines represent a distance of about
30 cm beyond the edge of your vehicle's
rear bumper. The audible signal becomes continuous from this limit.
The green lines represent distances of about 1
and 2 metres beyond the edge of your vehicle's
rear bumper.

The turquoise blue curves represent the
maximum turning circle.
The reversing camera cannot in any circumstances be a substitute for thevigilance and responsibility of the driver.

Opening the tailgate causes the display to disappear.


The reversing camera function may be completed with parking sensors.
High pressure jet washingWhen washing your vehicle, do not direct the lance within 30 cm of thecamera lens.

194
Driving





Park Assist
This system provides active assistance with parking, detecting a parking space then controlling the steering to park in the space. It controls the steering while the driver manages the accelerator, brakes, gears andclutch (manual gearbox). During phases of entry into and exit from a parking space, the system provides visual and audible information
to the driver in order to make the manoeuvres safe. It may be necessary to move for wards and backwards more than once.
During a manoeuvre the steering wheelturns quickly: do not hold the steeringwheel, do not place your hand between
the spokes of the steering wheel and take care with loose and bulky clothing, scarves, handbags... There is a risk of injury.


When Park Assist is activated, itprevents a change to STOP mode of Stop & Start. In STOP mode, activation of Park Assist restarts the engine.


The Park Assist system cannot in anycircumstances replace the care and responsibility of the driver.
The driver must remain in control of their vehicle ensuring that thespace remains clear throughout themanoeuvre. In some circumstances, the sensors may not detect small obstacles located in their blind spots.
The driver can take control at any time bygripping the steering wheel.
The Park Assist s
ystem provides assistance for
the following manoeuvres:


- entr
y into a parallel parking space

- exitin
g from a parallel parking space

- ba
y parking

The Park Assist system takes control of the power steering for a maximumof 4 manoeuvre cycles. The functionis deactivated after these 4 cycles.If you think that your vehicle is notpositioned correctly, you should then take control of the steering to carry outthe manoeuvre.

The Park Assist system cannot workwith the engine off.

195
4
Driving

The sequence of manoeuvres and the driving instructions are displayed in the instrument panel.
You should always check thesurroundings of your vehicle beforestarting a manoeuvre.
The assistance isdeactivated: the display of this symbol indicates that the steering manoeuvres are no longer controlled by the system: you must takecontrol of the steering.
The assistance isactivated: the display of this symbol and a speed limit indicate that the steering manoeuvres are controlledby the system: do not touch the steering wheel.


The park sensors function is notavailable during parking spacemeasurement. It intervenes later whenmanoeuvring to warn you that your vehicle is approaching an obstacle: theaudible signal becomes continuouswhen the obstacle is less than thir ty centimetres away.
If you have deactivated the parking sensors, they are automatically reactivated during assisted parkingmanoeuvres.


Activation of Park Assist inhibits the blind spot monitoring function.

197
4
Driving
)Move for wards slowly until a message is
displayed, accompanied by an audiblesignal, asking you to engage reverse gear.
)Select reverse, release the steering wheeland star t moving without exceeding 5 mph (8 km/h).
)
The assisted parking manoeuvre is inprogress.
Without exceeding 5 mph (8 km/h), move
for wards and backwards, aided by the
warnings from the "Parking sensors"system, until the indication of the end of the manoeuvre.
)
At the end of the manoeuvre, the operating
indicator lamp goes out in the instrument panel, accompanied by a message and an
audible signal.
The assistance is deactivated: you can
take over control.