Citroen C4 RHD 2006.5 1.G Owners Manual

c
ab
III
92 ISOFIX anchoring points and
the ISOFIX fastening system
The lateral rear seat positions are
equipped with the ISOFIX regula-
tion anchorages.
There are 3 rings for each seat
position:
- Two “bottom” rings
a and b
located between the backrest
and the vehicle seat. These are
about 28 cm apart.
- One “top” ring c located in the
boot between the wheelarch and
the seat backrest.
ISOFIX child seats have two
latches which are easy to secure
on the two “bottom” rings a and b. Some ISOFIX child seats also
have a top belt, which is for attach-
ing on the ISOFIX “top” ring
c.
To attach the top belt, raise the
head restraint of the vehicle seat,
then pass the bucke between the
two supports. Next fix the buckle
on the “top” ring c and tension the
top belt.
In all cases, the head restraint has
to be raised to the maximum.
This fixing system is intended for
children weighing up to 18 kg.

C H I L D R E S T R A I N T S

ab
III
93
Incorrect installation of a child
seat in a vehicle compromises
protection of the child in the event
of a collision. The ISOFIX fasten-
ing system enables you to reduce
those risks posed by incorrect
fitting, offering you a convenient,
strong and reliable fitting for a
child seat in your vehicle.
In the front passenger’s seat, it is essential to deactivate the
front passenger’s airbag as soon as a “rear-facing” child seat is
installed in this position. Otherwise the child risks be ing killed or
seriously injured should the airbag deploy.
Take care to comply with the fitting instructions given in the ch ild
seat manufacturer’s user guide.
The ISOFIX child seat recommended for your vehicle is:
ISOFIX RÖMER Duo:
It is marketed in the CITROËN network. It is equipped with
a top belt and
so it is approved as an “ISOFIX universal” child seat.
If it is installed in a rear seat position, the vehicle’s corre sponding front
seat should be adjusted so that the child’s feet do not t ouch the backrest
of this front seat.
This ISOFIX child seat can also be installed in seat position s that are not
equipped with ISOFIX anchoring points. In this case, it is co mpulsory to
secure it to the vehicle seat by means of the vehicle seat belt .
C H I L D R E S T R A I N T S

III
94 1 - Spotlamps
A press on one of the buttons will switch the corresponding sp
otlamp on
or off.
They will not come on if the ignition is switched off or t he vehicle is in
economy mode.
Automatic lighting of interior lamps
- When you enter the vehicle:
They come on immediately you unlock the vehicle or open a door .
They go out 30 seconds after doors have been closed, or after the igni-
tion has been switched on.
- When you leave the vehicle:
They come on when you remove the ignition key (for about 30 se conds),
or when a door is opened.
They go out after 30 seconds with the doors closed, or immedia tely the
vehicle is locked.

In this position, the interior lamp comes on when you open a door
or the boot.
In this position, it is deactivated and switched off permane ntly.
In the front, the spotlamps are deactivated.
In this position, lighting is permanent.
2 - Front and rear interior lamps
I N T E R I O R L I G H T I N G

III
95
Glovebox lighting
Comes on automatically when the
cover is opened. Do not forget to
close it again. Does not work with
the ignition off.
Boot lighting
Operates automatically on open-
ing the tailgate.
Sill lighting
These light up automatically with
the interior lamps.
I N T E R I O R L I G H T I N G

III
96 Glovebox
To open, pull the handle and lower
the lid.
The glovebox has:
- Storage locations for pens, spec-
tacles, telephone cards, etc.
- Three sockets for connecting audio/video equipment.
- A ventilation duct A can be
adjusted manually. It uses the
same conditioned air as the air
vents. Storage drawer
To open: press at the centre of the
drawer.
To retrieve an object, lift the drawer
up using the aperture provided.
Storage flap
To open: press at the centre.
I N T E R I O R C O M F O R T
WARNING: As a safety measure,
the glovebox must remain
shut when the vehicle is in motion. Floor mats
Use only the fixings provided in
the wallet that is attached.
If removing the mat on the driver’s
side :
- slide the seat as far as possible
rearwards,
- completely undo the fixings,
-
remove the fixings, then the floor mat.When refitting, position the floor
mat correctly and press the fixings
firmly home.
Check that the floor mat is securely
in position.
To prevent any hindrance
under the pedals :
- use only the floor mats that are compatible with the
fixings already present in
the vehicle. It is essential to
use these fixings.
- never fit any further floor mats on top.

III
97
Storage pockets in the front doors and rear panels
Storage pocketsOddments tray on front central
console
I N T E R I O R C O M F O R T

III
98 Sun visors
Fold visors down to avoid dazzle
from ahead.
They can be disengaged from their
central fixing and pivoted over to
the side windows if required.
The passenger’s and driver’s sun
visors each have a mirror that can
be covered.
Sun visor with illuminated
mirror
Illuminates automatically on open-
ing the mirror cover flap (ignition
on).
Glasses-holder Carrier bag hook
- Press at the bottom to deploy the hook.
- Press at the top to stow the hook.
Grab handles/ Coat hooks
I N T E R I O R C O M F O R T

III
99
Cigar lighter
Operates when the ignition is on.
Push in and wait a few moments.
The cigar lighter will release
automatically. The cigar lighter
will gradually emerge for easy
removal.
12V accessories socket
(Maximum power : 150 Watts)
Operates when the ignition is on.
It is located on the central con-
sole.
Ashtray
To open it, lift the flap.
To empty the ashtray, lift at the
rear and pull towards you.
To refit
Reposition the front part of the
ashtray, then press on the rear
part.
Panoramic roof
The roof has two opaque blinds
positioned at the front and rear.
To close the front blind, pull the
handle rearwards.
To close the rear blind, pull the
handle forwards.
The blinds have a retard
mechanism which stows them
automatically when you release
them.
I N T E R I O R C O M F O R T

III
100 Luggage securing rings
Use the 2 side fixings at the rear,
as well as the 6 anchoring rings
on the boot floor and the rear seat
backrest, to secure your loads.
For safety reasons, in case of hard
braking, heavy objects should be
placed as far forward as possible.
Protective net
This helps to secure objects
stowed in the boot.
Boot separation
To keep objects separated in the
boot, you can use the separators
to create 3 compartments on the
boot floor.
Positioning
- Pull the handle.
- Fold the separators in an appro-
priate manner to make a firm
structure.
Note: Before any manœuvre,
make sure that the boot carpet is
correctly positioned. Storage
- Push the sides towards the cen-
tre.
- Push towards the rear.
B O O T

III
101
Boot hook Removal
(3- door model)
- Detach the cords.
- Carefully lift then pull, tilting it slightly on one side. Removal
(5- door model)
- Detach the cords.
- Carefully lift then pull.
Avoid using the rear shelf for heavy or hard items.
These could be dangerous if thrown around during hars h braking
or, if they touch the rear screen, could damage the heati ng
elements.
B O O T