ignition Citroen C5 2012 (RD/TD) / 2.G Owner's Manual

8
FAMILIARISATION
INSTRUMENTS AND CONTROLS



1.
Electric windows/door mirrors/child safety
controls.

2.
Storing driver’s seat and door mirror settings.

3.
Audio/telematic steering mounted controls.

4.
Horn.

5.
Steering mounted controls:


- Speed limiter

- Cruise control

6.
Driver's airbag.

7.
Navigation controls for the audio/telematic and
trip computer systems.

8.
Driver's air vent.

9.
Instrument panel.

10.
Driver's air vent.

11 .
Stop & Start switch.

12.
Lighting/Direction indicators/Foglamp/Voice
recognition control stalk.

13.
Manual headlamp height adjustment.

14.
Steering wheel adjustment.

15.
Knee airbag.

16.
Locking/unlocking of doors and boot.

17.
Checks/Anti-intrusion alarm/Parking space
sensor controls.

18.
Ignition switch.

19.
Windscreen wiper/screenwash control stalk.

20.
Oddments tray or programmable heater
controls.

21.
USB port.

13
FAMILIARISATION
VISIBILITY


Front wipers

Control stalk positions

2
Fast wipe.

1
Normal wipe.

I
Intermittent wipe.

0
Off.


Lighting

Sidelamps.
Dipped/main beam. Lighting off.


)
Pull the control stalk towards you

to change between dipped and main
beam.

Front and rear foglamps on. Front foglamps on. Automatic illumination of head-
lamps.

Rear wiper (Tourer)



)
Rotate control C
to the desired posi-
tion.
Off
Intermittent wipe
Screenwash
Ring A

Ring B



86



Screenwash



)
Pull the screen wipe control stalk to-
wards you.



92-93



92

One press downwards:



- AUTO:
Automatic rain sensitive wip-
ers activated.

- Single wipe.
If the ignition has been switched off for
around 1 minute, automatic wiping must
be selected again.

15
FAMILIARISATION
MONITORING

Instrument panel

The hazard warning lamps
can also be used with the
ignition switched off.

A.
Fuel gauge and low fuel warning lamp.

B.
Cruise control/speed limiter information.

C.
Coolant temperature.

D.
Speedometer.

E.
Instrument panel screen.

F.
Mileage recorder.
G.
Trip mileage recorder reset button.

H.
Rev counter.

I.
Engine oil temperature.

J.
Automatic gearbox information.



- When the ignition is switched on, the orange and
red warning lamps come on.

- When the engine is running, these warning lamps
should go off .

- If any warning lamps remain on, refer to the
"Monitoring" section.



Hazard warning lamps




26




114

17
FAMILIARISATION
PASSENGER SAFETY


Front passenger's airbag
deactivation
Child lock

Seat belts and front
passenger's airbag
The seat belt fastened/unfastened sta-
tus for each seat category is indicated
by the illumination or fl ashing of the
warning lamps for each position:


A.
Not fastened/unfastened front and/
or rear seat belts warning lamp.

B.
Front left-hand seat belt warning lamp.

C.
Front right-hand seat belt warning
lamp.

D.
Rear right-hand seat belt warning
lamp.

E.
Rear centre seat belt warning lamp.

F.
Rear left-hand seat belt warning
lamp.

G.
Front passenger's airbag deactiva-
tion warning lamp.

H.
Front passenger's airbag activation
warning lamp.



35, 37-38
To use a rear facing child seat in the front
passenger's seat position, the passen-
ger's airbag must fi rst be deactivated.
To do this:


)
With the ignition switched off, insert
the key into the switch I
.

)
Turn the key to the "OFF"
position; the
passenger's airbag is deactivated.
The front passenger's airbag deactiva-
tion warning lamp G
comes on when
the ignition is switched on.



123
This deactivates the controls in the rear
of the vehicle, both for the rear windows
and for opening the rear doors from the
inside. The electric child safety device
is activated by pressing button J
.
The activation of the function is indi-
cated by a message on the instrument
panel screen and the lamp on button J
.



113

!!!
18
FAMILIARISATION

Electric parking brake

Never leave a child alone inside
the vehicle with the ignition on,
as they could release the park-
ing brake.

Hill start assist


Manual operation
The MANUAL application/release of
the parking brake is always possible
by pulling/pushing the control lever B
,
keeping your foot on the brake pedal.
Before leaving the ve-
hicle, check that warn-
ing lamp A (!)
(red) in
the instrument panel is
on fi xed (not fl ashing) and that warn-
ing lamp P
(red) in the control lever B

is on.
If you leave the vehicle with the
engine still running, apply the
parking brake manually. Do not leave the vehicle while
it is being held in the temporary
immobilisation hill start assist
phase. To aid starting on a gradient, your ve-
hicle is equipped with a system which
keeps it immobilised for a short time
(about 2 seconds), the approximate
time it takes to move your foot from the
brake pedal to the accelerator pedal.
This system is only active when:


- The vehicle is completely stationary,
with your foot on the brake pedal.

- In certain conditions on a gradient.

- With the driver's door closed. Before leaving the ve-
hicle, check that warn-
ing lamp A (!)
(red) in
the instrument panel is
on fi xed (not fl ashing) and that warn-
ing lamp P
(red) in the control lever B

is on.
Automatic operation
The electric parking brake releases au-
tomatically and progressively when you
press the accelerator. With the vehicle
stationary, the parking brake is auto-
matically applied when the engine is
switched off.

DRIVING SAFELY




128



134




127

20
FAMILIARISATION


)
Move the stalk briefl y upwards or
downwards, without going beyond
the point of resistance; the direction
indicators will fl ash 3 times.


Direction indicators -
"Motorway" function
DRIVING SAFELY



114



Ignition switch



●
S: Steering lock

To release the steering, turn the
steering wheel slightly while turning
the key, but without forcing.

●
M: Ignition on, drive position


●
D: Starter

Release the key as soon as the en-
gine starts. Do not operate the star-
ter when the engine is running.



70

22
FAMILIARISATION
DRIVING SAFELY

Stop & Start


Going into engine STOP mode
The "ECO"
warning lamp comes
on in the instrument panel and
the engine goes into standby:


- with the 6-speed electronic gear-
box system
; at speeds below 4 mph
(6 km/h), press the brake pedal or
put the gear lever into position N
.
Going into engine START mode
You can deactivate the system at any
time by pressing the "ECO OFF"
button;
the button's warning lamp comes on.
The system is reactivated automati-
cally every time you start the engine
with the key.
Before refuelling or doing anything
under the bonnet, you must switch off
the ignition with the key. The "ECO"
warning lamp goes
off and the engine restarts:


- with the gear lever in position A
or
M
, release the brake pedal,

- or with the gear lever in position N

and the brake pedal released, move
to position A
or M
,

- or engage reverse.
In certain circumstances, the STOP
mode may not be available; the "ECO"

warning lamp fl ashes for a few sec-
onds, then goes off.
In certain circumstances, START mode
may be invoked automatically; the
"ECO"
warning lamp fl ashes for a few
seconds, then goes off.


141




142

Deactivation / Reactivation



142

I
30
MONITORING






A few definitions
(trip computer)

Range
(miles or km)
Current fuel
consumption
(mpg or l/100 km or km/l)

Average fuel
consumption
(mpg or l/100 km or km/l)

Average speed
(mph or km/h)
Distance travelled
(miles or km)
This indicates the distance which
can still be travelled with the fuel re-
maining in the tank in relation to the
average fuel consumption over the
last few miles (kilometres) travelled.
This value may vary following a
change in the style of driving or
the relief, resulting in a signifi cant
change in the current fuel con-
sumption.
When the range falls below 20 miles
(30 km), dashes are displayed. After
fi lling with at least 5 litres of fuel,
the range is recalculated and is dis-
played when it exceeds 60 miles
(100 km).
If dashes are displayed continu-
ously while driving in place of the
digits, contact a CITROËN dealer
or a qualifi ed workshop. This function is only displayed from
20 mph (30 km/h). This is the average fuel consump-
tion during the last few seconds.
This is the average fuel consump-
tion since the last trip computer zero
reset.
This is the average speed calculated
since the last trip computer zero reset
(ignition on). This indicates the distance travelled
since the last trip computer zero reset.








Stop & Start time
counter
(minutes / seconds or hours /
minutes)
If your vehicle is fi tted with Stop &
Start, a time counter calculates the
time spent in STOP mode during a
journey.
It resets to zero every time the igni-
tion is switched on with the key.

I
32
MONITORING









Warning and indicator lamps

Visual indicators which inform the driver of the occurrence of a malfunction or
fault (warning lamp) or of the operation of a system (operation or deactivation
indicator lamp).


Warning lamp



is on



Cause



Action / Observations






STOP


fi xed, associated
with another
warning lamp. It is associated with a
punctured tyre or the engine
coolant temperature. Stop as soon as it is safe to do so.
Park, switch off the ignition and call a
CITROËN dealer or a qualifi ed workshop.




Service


temporarily. A minor fault has occurred
for which there is no specifi c
warning lamp. Identify the fault by reading the message
shown in the screen, such as, for example:


- the closing of the doors, boot, rear
screen or bonnet,

- the remote control battery,

- the tyre pressures,

- saturation of the particle emission fi lter
(Diesel).
For any other faults, contact a CITROËN
dealer or a qualifi ed workshop.

fi xed. A major fault has occurred
for which there is no specifi c
warning lamp. Identify the fault by reading the message
shown in the screen and contact a
CITROËN dealer or a qualifi ed workshop.
When the ignition is switched on
Certain warning lamps come on for a few seconds when the ignition is switched on.
When the engine is started, these warning lamps should go off.
If they remain on, before moving off, refer to the information for the warning lamp
concerned.

Associated warnings
The illumination, fi xed or fl
ashing, of certain warning lamps may be accompa-
nied by an audible signal and a message in the screen.
Warning lamps
When the engine is running or the
vehicle is being driven, the illumina-
tion of one of the following warning
lamps indicates a malfunction or
fault which requires action on the
part of the driver.
The illumination of a warning lamp is
always accompanied by the display
of an additional message, to assist
you in identifying the fault.
If you encounter any problems, con-
tact a CITROËN dealer or a qualifi ed
workshop.

I
33
MONITORING





Braking


fi xed, associated
with the STOP
warning lamp. The braking system fl uid level
is too low. You must stop as soon as it is safe to
do so.
Top up with brake fl uid recommended by
CITROËN.
If the problem persists, have the system
checked by a CITROËN dealer or a
qualifi ed workshop.

+

fi xed, associated
with the STOP
and ABS warning
lamp. The electronic brake force
distribution (EBFD) system
has a fault. You must stop as soon as it is safe to
do so.
Have it checked by a CITROËN dealer or
a qualifi ed workshop.

Warning lamp



is on



Cause



Action / Observations






Anti-lock
Braking
System
(ABS)


fi xed. The anti-lock braking system
has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and
contact a CITROËN dealer or a qualifi ed
workshop without delay.




Electric
parking
brake


fl ashing. The electric parking brake is
not applied automatically.
The application/release is
faulty. You must stop as soon as it is safe to
do so.
Park on fl at level ground, switch off the
ignition and contact a CITROËN dealer or
a qualifi ed workshop.




Electric
parking
brake fault


fi xed. The electric parking brake
has a fault. Contact a CITROËN dealer or a qualifi ed
workshop without delay.
The parking brake can be released
manually.
For more information on the electric
parking brake, refer to the "Driving"
section.