bulb Citroen C5 DAG 2007.5 (DC/DE) / 1.G Owner's Manual

160
VI
BC
D
EFA
C H A N G I N G B U L B S
H E A D L A M P S
Front headlamp unit with Xenon bulbs (D1S)
Bulbs:A Sidelamp: W5WB Dual-function Xenon lamp (dipped/main): D1SC Angular lighting: HP19D Daytime-running lamp: HP24
For the maintenance of the front headlamp unit and the changing of HP19, D1S and HP24 bulbs, con-tact a CITROËN dealer, bulbs, .
Front headlamps fi tted with Xenon bulbs: Because of risks of electrocution, we advise you to contact a CITROËN dealer if there is any problem.Front headlamps fi tted with Xenon bulbs: Because of risks of electrocution, we advise you to Front headlamps fi tted with Xenon bulbs: Because of risks of electrocution, we advise you to
You are advised to change the D1S bulbs at the same time, if one of them has failed.
Sidelamp1 Lift up the pegs E to remove the cover on the headlamp.2 Remove the protective cap F.3 Pull the bulb holder to remove it.4 Replace the bulb and replace the bulb holder.
5 Replace the protective cap F.6 Replace the cover and fi x it in place using the pegs E.

161
VI
E
ADCBGF
C H A N G I N G B U L B S
H E A D L A M P S
Main beam1 Lift up the pegs F to remove the cover on the headlamp.2 Remove the protective cap G.3 Disengage the retaining spring.4 Remove the bulb and replace it, paying attention to the direc-tion of fi tting.5 Replace the retaining spring.6 Replace the protective cap G.7 Replace the cover and fi x it in place using the pegs F.
Sidelamp1 Lift up the pegs F to remove the cover on the headlamp.2 Remove the protective cap G.3 Pull the bulb holder to remove it.4 Replace the bulb and replace the bulb holder.5 Replace the protective cap G.6 Replace the cover and fi x it in place using the pegs F.
HEADLAMP UNIT
Bulbs:A Main beam: H1B Sidelamp: W5WC Dipped beam: H7D Bend lighting: H7E Daytime-running lamp: HP24
For the maintenance of the front headlamp unit and the changing of HP24 bulbs, contact a CITROËN headlamp unit and the changing of changing of
dealer.
Halogen bulbs must not be changed until they have been off for a few minutes (risk of serious burns).
Do not touch the bulb directly with your fi ngers, use a lint-free cloth.
It is essential that only anti-U.V. type bulbs are used in order not to damage the headlamp.

162
VI
HI
Dipped beam1 Lift up the pegs F to remove the cover on the headlamp.2 Remove the protective cap H.3 Disconnect the connector by pressing it between the thumb and index fi nger.4 Free the bulb from its two metal clamps.5 Take out the bulb.6 Replace the bulb, exerting a slight axial force.7 Reconnect the connector, until it is all the way in.8 Replace the protective cap H.9 Replace the cover and fi x it in place using the pegs F.
Bend lighting1 Lift up the pegs F to remove the cover on the headlamp.2 Remove the protective cap I.3 Disconnect the connector by pressing it between the thumb and index fi nger.4 Free the bulb from its two metal clamps.5 Take out the bulb.6 Replace the bulb, exerting a slight axial force.7 Reconnect the connector, until it is all the way in.8 Replace the protective cap I.9 Replace the cover and fi x it in place using the pegs F.
C H A N G I N G B U L B S
H E A D L A M P S

163
VI
ABD1C
2
C H A N G I N G B U L B S
H E A D L A M P S
Front direction indicator1 Remove the fi xing screw of cover A, tip the cover over and remove.2 Remove the fi xing screw of lamp B and pull the headlamp unit to remove it from the bumper.3 Detach the bulb C by pressing on bars 1 and 2.4 Disconnect the connector (pull whilst pressing on the grey tongue using a fl at screwdriver).5 Replace the bulb.6 Connect the connector (push the grey tongue in well).7 Replace the headlamp unit in the bumper.8 Screw the headlamp unit in.9 Position the cover using its guides and screw in.
Bulbs: HP24W
When replacing, be careful not to pinch the electrical cables.
Front foglamp1 Remove the fi xing screw of cover A using a torx tool, tip the cover over and remove.2 Remove the fi xing screw of lamp B using a torx tool and pull on the unit to remove it from the bumper.3 Disconnect the connector.4 Remove the bulb by performing a quarter of a turn.5 Replace the bulb.6 Connect the connector.7 Replace the headlamp unit in the bumper.8 Screw the headlamp unit in.9 Position the cover using its guides and screw in.
Bulbs: H8

164
VIB
C
A
E
D
F
G
G
C H A N G I N G B U L B S
R E A R L A M P S
Rear lamp unit
Identify the failed bulb.
Bulbs:A Stop-lamps and sidelamps: P 21 W / 5 WB Sidelamp: R 5 WC Reversing lamp: H 21 WD Foglamp: H 21 WE Direction indicator: P 21 W
Rear lamp on boot1 Open the boot.2 Using a fl at screwdriver, remove the 3 clips which fi x the trim in the lamp area.3 Partially remove the trim F.4 Disconnect the connector.5 Detach the bulb holder G.6 Replace the bulb.7 Replace the bulb holder G.8 Connect the connector.9 Replace and fi x the trim F with its clips.
In some climatic conditions, mist may appear on the headlamp / indicator lenses. This is normal and will disappear (e.g. after the lamps have been on for a few minutes). If not, contact a CITROËN dealer. some climatic conditions, mist may appear on the h eadlamp / indicator lenses. This is normal and is no

165
VI
A
B
CD
C H A N G I N G B U L B S
R E A R L A M P S
Rear lamp on wing1 Remove the lateral boot trim fl ap A. To do so, pull it towards the inside of the boot, then pull it upwards.
2 Disconnect connector B.3 Unscrew the 2 fi xings C.4 Remove the lamp from its housing.
5 Detach the bulb holder D.6 Replace the bulb.7 Replace the bulb holder D.8 Place the lamp in its housing.9 Screw in the 2 fi xings C.10 Connect connector B.11 Refi t the trim A.Note: You can use the spare wheel jack handle to screw or unscrew the fi xings C.

166
VI
C H A N G I N G B U L B S
R E A R L A M P S
Third stoplamp
The third stoplamp uses diodes which cannot be replaced.
In case of malfunction, contact a CITROËN dealer.In case of malfunction, case of
Number plate1 Using a fl at screwdriver, detach the transparent cover by lever-ing it into the notch provided.2 Lift up and pull the transparent cover.3 Using a small fl at screwdriver, remove the faulty bulb.4 Fit the new bulb by fi rstly plac-ing the angled base on the axis of the clips, then press the bulb in to insert.5 Refi t the transparent cover by inserting it from the edge opposite the notch, then press on the edge of the transparent cover.
After each operation, check that the lamps work.
Bulb: W 5W

167
VI
C H A N G I N G B U L B S
Interior lamp
Unclip the transparent cover of the interior lamp to reach the bulb.
Bulb: W 5W
Spotlamp
Detach the cover.
To access the bulb, detach if nec-essary the partition of the affected spotlamp.
Side repeater
The side repeater is sealed.
If the bulb is faulty, replace the side repeater.
Contact a CITROËN dealer.
Boot lamp
To change the bulb, detach the cover and use a bulb W 5 W.

168
VI
Pavement lighting
To change the bulb for the door sill lighting: Detach the cover. Use a bulb W 5 W.
Floor lighting
To change the bulb for the fl oor lighting (front or rear): Detach the cover. Use a bulb W 5 W.
C H A N G I N G B U L B S
Glovebox
To change the glovebox bulb, detach the cover and use a W 5 W bulb.