reset Citroen C8 2008.5 1.G Owner's Manual

Page 33 of 250

Instruments and controls
READY TO SET OFF
2
37
Zero re-set
Your CITROËN dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
- Switch off the ignition,
- Press and hold the trip recorder re-set button,
- Switch on the ignition.
The display begins a countdown.
When the display shows "= 0 " , release
the button; the spanner disappears.
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for a few
seconds, after the service information. Oil level correct
Lack of oil
Flashing of
"OIL" ,
linked with the
service warning light,
accompanied by an
audible signal and a message on the
display, indicates a lack of oil which
could damage the engine.
If the lack of oil is confi rmed by a check
using the dipstick, it is essential that
the level is topped up.
Oil level gauge fault
Flashing of "OIL --"
indicates a malfunction
of the engine oil level
gauge.
Consult a CITROËN dealer. Dipstick

A = maximum, never exceed
this level as a surplus of oil
may damage the engine.
Contact a CITROËN dealer
without delay.

B = minimum, top up the level
via the oil fi ller cap, using
the type of oil suited to your
engine.
Trip recorder zero
reset button
With the ignition on, press
the button until the zeros
appear.
Lighting rheostat
With the lights on, press
the button to vary the
intensity of the lighting
of the instruments and
controls. When the lighting reaches
the minimum (or maximum) setting,
release the button then press it again
to increase (or reduce) the brightness.
As soon as the lighting is of the
required brightness, release the button.
The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
After this operation, if you wish to
disconnect the battery, lock the
vehicle and wait for at least fi ve
minutes, otherwise the zero re-set will
not be registered.

Page 118 of 250

122
1
4
2
3
3
3
4
4
2
4
3
4
4
4
4
4
3
3
3
3
3
2
3
5
5
3
2
4
3
5
4
3
4
3
4
4
4
4
4
4
4
3
5
2
3
4
3
3
3
3
3
4
4
5
4
5
5
5
5
4
3
4
5
5
4
5
current album
current track
e ject CD/DVD
TELEMATICS
CITROËN service
messages received
JUKEBOX
jukebox management
jukebox confi guration
hi-fi (320 kbps)
high (192 kbps)
normal (128 kbps)
playlist management
delete jukebox data
Jukebox status
CALL
call list
dial
directory
mailbox
services
customer contact centre
CITROËN assistance
DIRECTORY
managing directory fi les
consult or modify a fi le
add a fi le
delete a fi le
delete all fi les
confi gure directory
select a directory
name directory
select starting directory
fi le transfer fi le transfer fi le transfer
exchange by infrared
send all records
send one record
receive by infrared
exchange with SIM card
send all records to SIM
send one record to SIM
receive all SIM fi les
receive a SIM fi le
TEXT MESSAGES (SMS)
read received text messages
send a text message
write a text message
delete list of text messages
TELEPHONE FUNCTIONS
network
network search mode
automatic mode
manual mode
networks available
length of calls
reset
manage PIN code
activate/deactivate
save PIN code
modify PIN code
call options
confi gure calls
display my number
automatic reply after x ring(s)
ring options
for voice calls

Page 228 of 250

2
POWERSTOP
AUTOON
OFF
MODE
PLAYDOWN UPEJECT
DVD
SMART
MODE DISC IN
AV1 AV2
01
Additional lighting switch. RESET button.
Passenger compartment
lighting.
A/V source selection
(DVD/DIVX, AV1, AV2).
A disc is
inserted.
SMART mode
activation.
Av1: AV1 input selected.
Av2: AV2 input selected.
DVD player video signal.
CONTROLS
FIRST STEPS
On/Off.
Stop play.
A/V source selection (DVD/DIVX, AV1, AV2).
VCD/CD/MP3: next title.
Cursor up.
DVD/DIVX: previous chapter.
VCD/CD/MP3: previous title.
Cursor down.
Disc eject.
Play/pause.
DVD/DIVX: next chapter.

Page 250 of 250

10
The table below groups together the answers to the most frequently asked questions concerning the roof console display.
FREQUENTLY ASKED QUESTIONS
QUESTION SOLUTION
The player does not work. No reaction
when the ignition is switched on and when
the POWER button is pressed. - Check the vehicle's fuses.
- Press the RESET button.
The player does not react to pressing of the
remote control buttons. - The remote control batteries are lat. Replace the
m with alkaline manganese AAA type batteries.
- The remote control sensor is hampered by objects or is dirty. Remove all objects on the remote control
receiver or clean the surface using a damp cloth.
Image or sound interference while playing
a DVD. The image remains frozen during
play. The player cannot read the disc. The discs may be d
amaged or dirty.
The player does not play the disc inserted. - The format of the disc does not correspond to the speciications of the player.
- If it is cold, condensation may have formed on t he laser. Wait approximately 5 minutes to allow the humidity
to evaporate.
The player operates with no effect
(frozen image). - Switch off the player then switch it back on to r
eturn to normal operation.
- Press the RESET button.
The language is incorrect, the DVD menu
or the subtitles are set once the DVD has
been inserted. Check the output languages on the PREFERENCES menu.
When a DVD/VCD/SVCD is played, the
density of the colours is too weak/too
strong. - Remove the disc.
- Using the 7 or 8 buttons, set the COLOUR value re
quired and insert the disc again.
- To restore the default value, remove the disc and press the DISP button.
24