remote control Citroen C8 DAG 2008.5 1.G User Guide

>Visuel à venir
Accesses
26
CHILD SAFETY
Simultaneous locking or
unlocking of the tailgate
and the doors
The tailgate is locked or unlocked by
the remote control or the driver’s door
or passenger door lock.
To open, operate the handle C and lift
the tailgate. Tailgate release
Always remove the ignition key
when leaving the vehicle, even for
a short time. The tailgate locks automatically
when the vehicle is being driven
at more than 6 mph (10 km/h) and
unlocks when one of the front doors is
opened. A - Mechanical
This prevents either of the rear doors
being opened from inside.
- Turn the switch A a quarter of a
turn using the ignition key.
B - Electric
This disarms all the electrical controls
in the rear:
- electric windows,
- sliding side doors,
- sunroofs in rows 2 and 3.
With the ignition on, press button B .
A message appears on the display,
accompanied by an audible signal,
indicating the status of the function:
activated or not activated.
Always check the status before setting off.
This safety system is independent of
the central locking.
In the event of a serious impact, the doors
are unlocked automatically to permit
access by the emergency services. "Tailgate open" warning
When the engine is running or the
vehicle is being driven, you are warned
if the tailgate is not closed correctly by
a diagram on the display, accompanied
by an audible signal. This enables the tailgate to be
unlocked in the event of a central
locking fault.
-
Fold back a row 2 rear seat,
- Fold back a row 3 rear seat or the
bench seat to gain access to the
lock from inside the boot,
- Insert a small screwdriver into hole
D in the lock and push it towards
the left to unlock the tailgate.

84
Practical information Front courtesy light
Automatic switching on/off
The front courtesy light comes on
when the key is removed from the
ignition, when the vehicle is unlocked,
when one of the front doors is opened
or for location of the vehicle using the
remote control.
It switches off gradually after the
ignition is switched on and when the
vehicle is locked. Permanently on, ignition on.
Front: comes on when one
of the front or rear doors is
opened.
Permanently off. Individual reading light
Rear courtesy light rows 2 and 3
These are switched on and off by
means of a manual switch.
COURTESY LIGHTS
Rows 2 and 3: comes on
when one of the rear doors is
opened. Rear courtesy light

6
1
2 1
2 1
2
03
12
UP EJECT
SMART
MODE DISC IN
ARTDEDISC IN
POWER
STOP
DVDAV1
MULTIMEDIA SYSTEM ON/OFF BASIC FUNCTIONS
To switch on the multimedia system, switch on
the vehicle's ignition.
Press the POWER button on the roof console
display or on the remote control. Play begins automatically.
To load a disc, insert it gently, printed
face uppermost, until it is fully
inserted.
Press the EJECT button on the roof
console display.
Remove the disc gently.
LOADING/EJECTING A CD

9
13
03
4
SMART
SMART
MODE DISC IN
SEL
VOL+
VOL-
DVD
AV1AV2
MODE
2 The SMART mode can only be activated after
inserting a disc in the player.
The SMART mode is deactivated automatically when
the equipment is switched off.
Press the SMART button on the
remote control to activate the SMART
mode. The SMART indicator light
LED comes on.
Using the MODE button, connect
the AV1 and AV2 inputs to the AV
outputs. Press the SEL button one or more
times to display the TFT/LCD screen
settings table.
Press the VOL- or VOL+ button to
change the setting selected.
Press the ENTER button the save the
changes and exit screen setup.
BASIC FUNCTIONS
SMART MODE

17
05
1
1
2
123
456
789
MENU
INFORMATION AND ADVICEPLAYING A JPEG IMAGES CD
PLAYING A JPEG IMAGES CD
Check that the JPEG images have the extension
".jpeg".
The folder can only be selected in STOP mode ( n).
The volume, colours, contrast and brightness of the
images cannot be adjusted while the CD is being
played. Select the next/previous images using
the
5 and 6 buttons.
To activate the thumbnails mode,
press the MENU button. Insert the JPEG images CD in the
player. The navigation menu is
displayed on the screen.
To navigate through the iles, refer to the previous
section: 04 PLAYING AN MP3 CD, LISTENING TO A
COMPILATION.
To display an image in full screen
mode, press the buttons on the
remote control which correspond to
the number of the image.
The thumbnails mode is deactivated
automatically and the ilmstrip begins
starting with the image selected.

19
07
1
2
3
2
3
1
4
2Do not the discard the batteries or
the bulbs, take them to a collection
point.
CHANGING A BATTERY
MAINTENANCE AND CARE
REPLACING A BULB
Open the battery compartment on
the back of the remote control. Replace the remote control batteries when
the DVD/DIVX player no longer reacts to the

pressing of a button.
Remove the lat batteries.
Fit the 2 new AAA type (micro)
batteries. Observe the polarity
indicated.
Close the battery compartment. Replace the faulty bulb with a bulb of
the same type (12 V/2 - 3 W).
Close the cover.
Using a screwdriver, gently lift the
transparent cover of the interior light
located on the equipment in order to
remove it carefully.

10
The table below groups together the answers to the most frequently asked questions concerning the roof console display.
FREQUENTLY ASKED QUESTIONS
QUESTION SOLUTION
The player does not work. No reaction
when the ignition is switched on and when
the POWER button is pressed. - Check the vehicle's fuses.
- Press the RESET button.
The player does not react to pressing of the
remote control buttons. - The remote control batteries are lat. Replace the
m with alkaline manganese AAA type batteries.
- The remote control sensor is hampered by objects or is dirty. Remove all objects on the remote control
receiver or clean the surface using a damp cloth.
Image or sound interference while playing
a DVD. The image remains frozen during
play. The player cannot read the disc. The discs may be d
amaged or dirty.
The player does not play the disc inserted. - The format of the disc does not correspond to the speciications of the player.
- If it is cold, condensation may have formed on t he laser. Wait approximately 5 minutes to allow the humidity
to evaporate.
The player operates with no effect
(frozen image). - Switch off the player then switch it back on to r
eturn to normal operation.
- Press the RESET button.
The language is incorrect, the DVD menu
or the subtitles are set once the DVD has
been inserted. Check the output languages on the PREFERENCES menu.
When a DVD/VCD/SVCD is played, the
density of the colours is too weak/too
strong. - Remove the disc.
- Using the 7 or 8 buttons, set the COLOUR value re
quired and insert the disc again.
- To restore the default value, remove the disc and press the DISP button.
24