heating Citroen C8 DAG 2009.5 1.G Owner's Manual

Page 12 of 270

17
1
FAMILIARISATION
Interior

Recommended settings for the Manual Air Conditioning

For optimum use of the system, we recommend:

If I require... Air distribution Temperature Air fl ow
Air
recirculation
AC

Heating
-

Cooling

De-icing

D
emisting


With Automatic Air Conditioning, operation in AUTO mode is recommended irrespective of the requirement.

Remember to switch the system off when the ambient air suits your requirements.

Page 30 of 270

Instruments and controls
READY TO SET OFF
2
33
Warning light is indicates Solution - action
ESP/ASR fl ashing.
wheel skid avoided. The system optimises the traction and improves
the directional stability of the vehicle.
Chapter 4, "Driving safety" section.
remaining on. a malfunction of the system.
E.g.: under-infl ation of the
tyres. Check the pressure of the tyres. Call a CITROËN
dealer.
remaining on
with the button
(below the
steering wheel
on the left)
pressed. deactivation of the system.
The operation of the system has been
deactivated. Chapter 4, "Driving safety" section.

Diesel
pre-heating lit. climatic conditions requiring
pre-heating. Wait until the warning light is switched off before
operating the starter.

Dipped
headlamps/
Daytime
lights lit. manual selection or
automatic lighting.
Rotate the ring on the lights stalk to the second
position.
lighting of the dipped headlamps
from the time the ignition is
switched on - daytime lights.
Depending on the country in
which the vehicle is sold.
Chapter 3, "Steering wheel controls" section.

Main beam
headlamps
pulling of the stalk towards
you. Pull the stalk to return to dipped headlamps.
and with an
audible signal,
ignition off. opening of the driver's door
with the lights still on.
Rotate the ring on the lights stalk to position 0.

Direction
indicators fl ashing with
buzzer. change of direction via the
lights stalk, to the left of the
steering wheel. To the Right: control to be pushed upwards.
To the Left: control to be pushed downwards.

Page 41 of 270

READY TO SET OFF
2
43
Starting and stopping
STARTING AND STOPPING
STOP position: steering lock.
The ignition is off.
Good practice when starting
Handbrake
If your vehicle is fi tted with a
version with a rotating front seat,
the handbrake can be disengaged.
Pulling the handbrake to immobilise
the vehicle then lowering the lever
does not release the brake, it permits
rotation of the driver's seat.
Pull the button placed at the end of the
handbrake forwards.
The handbrake lever lowers.
You can now rotate the seat.
To return to normal operation, pull the
lever up until it clicks.
If the handbrake is on or has
not been released fully, this is
indicated by:
- a warning light which comes on on the instrument panel,
- an audible signal,
- a message on the display.
Key
Take care not to place the key in
contact with grease, dust, rain or a
damp environment.
A heavy object attached to the key (key
ring, ...) weighing down on the shaft
of the key in the ignition switch may
cause a malfunction.
Running and accessories position.
Certain accessories can be used.
Starting position.
The starter is operated. Diesel pre-heating warning
light
Turn the key to the Running
position.
In cold weather, wait for this warning
light to switch off then operate the
starter (Starting position) until the
engine starts.
If the temperature is high enough, the
warning light comes on for less than
one second, you can start without
waiting.
Good practice when stopping
Minimise engine and gearbox wear
When switching off the ignition, let the
engine run for a few seconds to allow
the turbocharger to return to idle.
Do not press the accelerator when
switching off the ignition.
There is no need to engage a gear
after parking the vehicle.

Page 60 of 270

–
62
Ventilation 3 - Setting the air fl ow
Turn control knob 3 to the
right or to the left respectively
to increase or reduce the fl ow
of air.
4 - Intake of exterior air/ Recirculation of
interior air
Press button 4 to recirculate
the air inside.
The air recirculation indicator light 4
comes on.
Recirculation insulates the passenger
compartment from external odours and
fumes.
Used simultaneously with the air
conditioning 1 , recirculation improves
the performance of the system when
set to hot as well as to cold.
Avoid prolonged operation in
interior air recirculation mode
(risk of misting of the windows and
of deterioration of the air quality).
Recommended settings for the air conditioning
For optimum operation of the manual system, it is recommended :
With Automatic Air Conditioning, operation in AUTO mode is recommended,
irrespective of the requirement.
Remember to switch it off when the ambient air suits your
requirements.
If
I require... Air
distribution
Temperature Air fl ow Air
recirculation AC
Heating
Cooling
De-icing
Demisting
5 - Air conditioning
ON/OFF
The air conditioning is
intended to operate in all
seasons. In summer it allows
the temperature to be reduced and in
winter, above 0 °C, it increases the
effectiveness of the demisting.
Press switch 5 .
The air conditioning indicator light 5
comes on if the air fl ow is suffi cient.
Pressing this button again switches off
the air conditioning.

Page 65 of 270

ERGONOMICS and COMFORT
3
67
Seats
Memorising seat positions
Two driving positions can be
memorised, using buttons M/1 and

M/2 .
These are located on the side of the
seat:

- Place the ignition key in the
"running" position (2nd notch),

- Adjust your seat,

- Press button M , then button 1 for
a fi rst driving position within four
seconds.
Repeat the same actions on buttons M
and 2 to store another driving position.
An audible signal confi rms that a
position has been memorised.
Memorising a new position cancels the
previous one.
Activating a memorised driving
position Front heated seat
controls
When the engine is running, the front
seats can be heated separately.
Use the adjustment controls located on
the side of each front seat to switch on
and select the self-regulated level of
heating:

1: Low.

2: Medium.

3: High.

0: Off.
After recalling a memorised
position fi ve times in succession,
the function will be cancelled until
the engine is started.
Engine running
- Keep button 1 or 2 pressed down
until the end of setting of the
corresponding memorised position.
Engine off

- Briefl y press button
1 or 2 to recall
the corresponding memorised
position.