CITROEN CX 1988 Service Manual

CARRYING OUT WORK ON THE
EXHAUST SYSTEM

ht into front exhaust pope (I ) the ball~joint (6) plus
joint
Tighter to 2.5 mdaN.
Ftt the turbine housing (51 vuith a seal
Engage clamp 141 oli the turbine 4 studs (3)
Slide a 5 rnn- thick shim between the sump and
pipe (I ) to allow for a clearance
M25/662, type engine: insert a seal between waste-
pipe 12) and the turbocharger.
Fit the 4 spacers and nuts to the turbine fixing studs (3).
Tighter to 2.5 mdaN in the order 1 - 2 - 3 - 4.
M25/648, type engine: position the clamp and the
seal of waste-pipe (2). Locate the 3 screws and nuts.
Tighten to 2.5 mdaN.
Adjust ball-jotnt support plate 17) fitted with flexible
lug (8) position, and hold It In an intermediate
pow
tion by means of 2 screws
Pile up RP distance pieces of various thicknesses bet-
ween the ball-joint and its flexible lug , ilefer to 1911.
Insert the ball-joint bolt (1 0).
Slacker ttre 2 ball-joint support plate screws (7) and
fit the other 2 attachment points without tightening Screw 111 ball-Joirnt t~old~ny down bolt (I 0) to 5 mdaN.
Do up ball Joint support plate (7) 4 attachment points

5-l
-1
4
-.
3 ----
2 .----
l-
6
--.
8
9
10

OUT 10 6004 T

1 2279 T ]
OUT 10 6004 T
13.462 /

r--
9o”c
4
I,4 bar
4,45 bars

2,5 bars mini
4,s ---f 5 bars

- l!bi°C ---+ 28%
- 3o”c - 50%
I_---1 I
&T-b-3-
/ 86“C - 9fi°C 1 ”
1 bar * 2184
1.1 bar 2184 +
8531