jacking Citroen DS3 2011 1.G Owner's Manual

)
Place the jack 2
in contact with one of the
two front A
or rear B
locations provided on
the underbody, whichever is closest to the
wheel to be changed.
On vehicles fitted with sill finishers, the
jacking location is indicated by a marking
on the finisher. The jack must be placed
centrally in line with this marking, at the
jacking point located behind the finisher
and not on the plastic finisher itself.
)
Remove the bolts and store them in a clean
place.

)
Remove the wheel.


)
Extend the jack 2
until its base plate is in
contact with the ground. Ensure that the
centreline of the jack base plate is directly
below the location A
or B
used.

)
Raise the vehicle until there is sufficient
space between the wheel and the ground
so that the spare (not punctured) wheel can
then be fitted without difficulty.