sensor CITROEN DS3 CABRIO DAG 2015 Handbook (in English)
Page 128 of 404
DS3_en_Chap06_conduite_ed01-2014
Rear parking sensors
System consisting of four proximity sensors, located in the rear bumper.
This detects any obstacle (person, vehicle,
tree,
gate, etc.) behind the vehicle, except
o
bstacles located just below the bumper.
An object, such as a stake, a roadworks cone or any other similar object may b
e detected at the beginning of the
m
anoeuvre, but may no longer be detected
w
hen the vehicle comes close to it.
The parking sensor system cannot in any circumstances take the place of
v
igilance on the part of the driver.
The
system is activated as soon as reverse
g
ear
is engaged, accompanied by an audible
s
ignal. The proximity information is given by:
-
a
n audible signal, which becomes more
r
apid as the vehicle approaches the
obstacle.
-
a
graphic (according to version) in the
m
ultifunction screen, with blocks which
b
ecome increasingly closer to the vehicle.
Activation
When the distance between the rear of the vehicle
and
the obstacle is less than thirty centimetres, the a
udible signal becomes continuous and the "Danger"
s
ymbol appears in the multifunction screen.
On
completion of the manoeuvre, when you exit
r
everse gear, the system becomes inactive.
Page 129 of 404
127
DS3_en_Chap06_conduite_ed01-2014
ProgrammingOperating faults
If there is an operating fault, when r
everse gear is engaged this w
arning
lamp comes on in the instrument panel,
a
ccompanied by an audible signal (short beep)
a
nd
a
message in the multifunction screen.
You
can
activate
or
deactivate
the
system
by
m
eans
of
the
multifunction
screen
configuration
m
enu.
The
system
state
is
memorised
when
s
witching
off
the
ignition.
For
more
information
on
access
to
the
parking
s
ensors
menu,
refer
to
" Vehicle
configuration"
o
r
" Vehicle
parameters"
section
for
your
m
ultifunction
s
creen.
The
system
will
be
deactivated
a
utomatically
when
towing
a
trailer
or
w
hen a bicycle carrier is fitted (vehicle
fitted with a towbar or bicycle carrier
recommended
by
CITROËN). In bad or wintry weather, ensure that
the
sensors are not covered with mud,
f
rost
or snow.
driving
Page 138 of 404
DS3_en_Chap07_visibilite_ed01-2014
The sidelamps and dipped beam headlamps are switched on automatically, without any
a
ction on the part of the driver, when a low level
of
external light is detected or in certain cases
o
f activation of the windscreen wipers.
As
soon as the brightness returns to a
s
ufficient level or after the windscreen wipers
are
switched off, the lamps are switched off
au
tomatically.
Automatic illumination of headlamps
Activation
F Turn ring to the "AUTO" position. The a
utomatic illumination of headlamps is
a
ccompanied by a message in the screen.
deactivation
F Turn ring to a position other than "AUTO". D
eactivation is accompanied by a message
i
n the screen.
Association with the automatic
"Guide-me-home" lighting
Association with the automatic illumination of headlamps provides "guide-me-home" lighting
w
ith the following additional options:
-
s
election of the lighting duration to 15,
30 or 60 seconds in the functions that can
be
set in the vehicle configuration menu
(
except in the case of the monochrome
s
creen A, for which the duration is set:
60 seconds),
-
a
utomatic activation of "guide-me-home"
l
ighting when automatic illumination of
h
eadlamps is in operation.
Operating fault
In the event of a fault with the
sunshine sensor, the lighting
c
ome
on,
this warning lamp is displayed in the
i
nstrument
panel and/or a message appears in
t
he
screen,
accompanied by an audible signal.
Contact a CITR
oË
N dealer or a qualified
workshop.
In
fog or snow, the sunshine sensor
m
ay
detect sufficient light. Therefore,
t
he
lighting will not come on
au
tomatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the windscreen
behind
the rear view mirror; the
a
ssociated functions would no longer
be c
ontrolled.
Page 143 of 404
141
DS3_en_Chap07_visibilite_ed01-2014
Automatic rain sensitive
windscreen wipers
The windscreen wipers operate automatically, without any action on the part of the driver, if
rain is detected (sensor behind the rear view
mirror),
adapting their speed to the intensity of
t
he rainfall.
Activation
This is controlled manually by the driver by pushing s talk A to the "AUTO" p osition.
It
is accompanied by the illumination
o
f this indicator lamp in the
i
nstrument panel and a message in
t
he multifunction screen.
Switching off
This is controlled manually by the driver by moving stalk A upwards, returning it to
p
osition
"0".
It
is accompanied by the indicator lamp
i
n the instrument panel going off and a
m
essage in the multifunction screen.The
automatic wiping must be r
eactivated if the ignition has been off
f
or more than one minute, by pushing
s
talk A downwards.
Visibility
Page 144 of 404
DS3_en_Chap07_visibilite_ed01-2014
Operating fault
If an automatic wiping fault occurs, the wipers will operate in intermittent mode.
Have
it checked by a CITROËN dealer or a
q
ualified
w
orkshop. To retain the effectiveness of the flat
wiper
blades, it is advisable to:
-
h
andle them with care,
-
c
lean them regularly using soapy
w
ater,
-
n
ot use them to hold a sheet of
c
ardboard against the windscreen,
-
r
eplace them at the first signs of
w
e a r.
Do
not cover the rain sensor, linked
w
ith the sunshine sensor and located in
the centre of the windscreen behind the
rear
view mirror.
Switch
off the automatic wiping when
u
sing an automatic car wash.
In winter, it is advisable to wait until the
windscreen
is completely clear of ice
b
efore activating the automatic wiping.This position allows the wiper blades to
be
lifted for winter parking, cleaning or
r
eplacement without damaging the bonnet.
In
the minute following switching off of the
i
gnition, any action on the wiper stalk positions
t
he wipers vertically.
To
park the wipers after this has been done,
s
witch on the ignition and operate the wiper stalk.
Vertical windscreen wiper
position
Page 152 of 404
Under-inflation detection
System which automatically checks the pressures of the tyres while driving.
T he under-inflation detection system
d
oes not replace the vigilance or the
r
esponsibility of the driver.
This
system does not avoid the need to
c
heck the tyre pressures (including the
s
pare wheel) every month as well as
b
efore a long journey.
Driving
with under-inflated tyres
i
mpairs road holding, extends braking
d
istances and causes premature
t
yre wear, particularly under arduous
condition
(high loading, high speed,
lon
g
jo
urney).The inflation pressures defined for
your vehicle can be found on the tyre
pressure
label.
See
the "Identification markings"
s
ection.
Tyre
pressures should be checked
w
hen the tyres are "cold" (vehicle
stopped
for 1 hour or after a journey of
l
ess than 6 miles (10 km) at moderate
s
peeds).
Other wise
(when hot), add 0.3 bar to
t
he pressures shown on the label.
Driving
with under-inflated tyres
i
ncreases fuel consumption.
The
system monitors the pressures in the four
t
yres, once the vehicle is moving.
It
compares the information given by the four
w
heel speed sensors with reference values,
which must be reinitialised ever y time the
tyre pressures are adjusted or a wheel
changed .
The
system triggers an alert as soon as it
d
etects a drop in the inflation pressure of one
or
more tyres.
Page 159 of 404
157
DS3_en_Chap08_securite_ed01-2014
Active City Brake
Active City Brakeis a driving assistance system that aims to avoid a frontal collision or reduce
t
he speed of an impact if the driver does
n
ot take sufficient action (inadequate brake
a
pplication).
This system is designed to improve driving safety.
I t remains the driver's responsibility to c
ontinuously monitor the state of the traffic and
t
o assess the distances and relative speeds of
other
v
ehicle.
Active City Brakecan in no circumstances replace the need for vigilance on the part of t
he
d
river.
never look at the laser sensor through an optical in strument ( magnifying g lass, m
icroscope...) at a distance of less than
1
0 centimetres: risk of eye injury.Automatic
braking occurs later than if
d
one by the driver, so as to intervene
only
when there is a high risk of
c
ollision.
Principle
Using a laser sensor located at the top of the windscreen, this system detects a vehicle
r
unning in the same direction or stationary
a
head of your vehicle.
When
necessary, the vehicle's braking system
i
s operated automatically to avoid a collision
w
ith the vehicle ahead.
conditions for activation
Active City Brakeonly operates if the following conditions are met:
●
i
gnition on,
●
t
he vehicle is in a for ward gear,
●
s
peed is between about 3 and 18 mph
(
5 and 30 km/h),
●
t
he braking assistance systems (ABS,
E
BFD, emergency braking assistance) are
n
ot faulty,
●
t
he trajectory control systems (ASR, DSC)
a
re not deactivated or faulty,
●
t
he vehicle is not in a tight corner,
●
t
he system has not been triggered during
t
he previous 10 seconds.
Safety
Page 161 of 404
159
DS3_en_Chap08_securite_ed01-2014
Operating limits
The system only detects vehicles that are stationary or moving in the same direction as
y
our vehicle.
It
does not detect small vehicles
(
bicycles, motorcycles), pedestrians or
a
nimals, nor non-reflective stationary
ob
jects. In difficult weather conditions (very
heavy
rain, snow, fog, hail...), braking
d
istances increase, which can reduce
the
ability of the system to avoid a
c
ollision.
The
driver must therefore remain
par
ticularly
v
igilant.
Never
leave accumulations of snow or
a
ny object projecting above the bonnet
o
r in front of the roof: this might fall into
t
he field of vision of the sensor and
generate
a detection.
The
system is not triggered or is interrupted if t
he d river:
-
a
ccelerates strongly
-
o
r turns the steering wheel suddenly
(
avoiding
m
anoeuvre).
Safety
Page 163 of 404
161
DS3_en_Chap08_securite_ed01-2014
Operating faults
In the event of an impact to the windscreen at the sensor, deactivate
the
system and contact a CITROËN
d
ealer or a qualified workshop to have
y
our windscreen replaced.
Never
try to remove, adjust or test
t
he sensor.
on
ly a CITR
oË
N dealer or a qualified
workshop
is able to work on the system.
When
towing a trailer or when the
v
ehicle is being towed, the system must
b
e deactivated.
Do not stick or other wise fix any object on the windscreen in front of the sensor.
Sensor fault
The operation of the laser sensor may suffer inter ference from accumulations of dirt or
m
isting of the windscreen. In this case you are
w
arned by the display of a message.
Use
the windscreen demisting and regularly
c
lean the area of the windscreen in front of the
sensor.
System fault
In the event of a malfunction of the system, you a re warned by an audible signal and the display
o
f the message "Automatic braking system
fault" .
Have
the system checked by a CITROËN
d
ealer or a qualified workshop.
Safety
Page 228 of 404
DS3_en_Chap10_info-pratiques_ed01-2014
Fuse N°Rating Functions
F8 20 AMultifunction
screen, audio system, navigation radio, alarm
c
ontrol unit, alarm siren.
F9 30 A12
V socket, portable navigation support supply.
F10 15 ASteering
mounted controls.
F11 15 AIgnition,
diagnostic socket, automatic gearbox control unit.
F12 15 ARain
/ sunshine sensor, trailer relay unit.
F13 5 AMain
stop switch, engine relay unit.
F14 15 AParking
sensors control unit, airbag control unit, instrument
p
anel, digital air conditioning, USB Box, Hi-Fi amplifier.
F15 30 ALocking.
F16 -Not
used.
F17 40 ARear
screen and door mirrors demisting/defrosting.
SH -PARC
shunt.