Citroen DS4 DAG 2010.5 1.G Workshop Manual
Page 51 of 342
Heated seats control
With the engine running, the front seats can be heated separately. Use the adjustment dial, placed on the side of each front seat, to switch on and select the level of heating required: 0: Off. 1: Low. 2: Medium. 3: High.
Additional adjustments
H e a d r e s t r a i n t h e i g h t a n d a n g l e adjustment
To raise a head restraint, pull it upwards. To remove the head restraint, press the lug A and pull the head restraint upwards. To put the head restraint back in place, engage the head restraint stems in the openings keeping them in line with the seat back. To lower the head restraint, press the lug Aand the head restraint at the same time. To adjust the angle of the head restraint, tilt
its lower par t for wards or rear wards.
The head restraint is fitted with a frame with notches which prevents it from lowering; this is a safety device in case of impact. T h e a d j u s t m e n t i s c o r r e c t w h e n t h e u p p e r e d g e o f t h e h e a d r e s t r a i n t i s l e v e l w i t h t h e t o p o f t h e h e a d . Never drive with the head restraints removed; they must be in place and
adjusted correctly.
Page 52 of 342
Comfort
Manual lumbar adjustment
Turn the knob to obtain the desired level of lumbar suppor t.
Electric lumbar adjustment
Press the front or rear of the control to obtain the desired lumbar suppor t.
This function provides a back massage; it only operates when the engine is running. Press the switch to activate the function. The warning lamp on the switch comes on and the massage function is activated for a period of 60 minutes. During this time, massage is per formed in 6 cycles of 10 minutes each cycle (6 minutes of massage followed by 4 minutes break). After an hour, the function is automatically
deactivated. The warning lamp in the switch goes off.
Deactivation
You can deactivate the massage function at any time by pressing the switch. The movement in progress continues until the initial non-
massage position is reached.
Massage function
Page 53 of 342
87Comfort
Front seats
Seat consisting of a seat cushion, a seat back and a head restraint which can all be adjusted to adapt your position for ease of driving and comfor t.
Driver's seat electric adjustments
F o r w a r d s - b a c k w a r d s a d j u s t m e n t
Push the control for wards or rear wards to
slide the seat.
S e a t c u s h i o n h e i g h t a n d a n g l e adjustment
Tilt the rear par t of the control upwards or downwards to obtain the required height. Tilt the front par t of the control upwards or downwards to obtain the required angle.
Seat back angle adjustment
Tilt the control for wards or rear wards to
adjust the angle of the seat back.
The electrical functions of the driver's seat are deactivated approximately one minute after the ignition is switched off. To reactivate them, switch on the ignition.
Page 54 of 342
Heated seats control
With the engine running, the front seats can be heated separately. Use the adjustment dial, placed on the side of each front seat, to switch on and select the level of heating required: 0: Off. 1: Low. 2: Medium. 3: High.
Additional adjustments
H e a d r e s t r a i n t h e i g h t a n d a n g l e adjustment
To raise a head restraint, pull it upwards. To remove the head restraint, press the lug A and pull the head restraint upwards. To put the head restraint back in place, engage the head restraint stems in the openings keeping them in line with the seat back. To lower the head restraint, press the lug Aand the head restraint at the same time. To adjust the angle of the head restraint, tilt
its lower par t for wards or rear wards.
The head restraint is fitted with a frame with notches which prevents it from lowering; this is a safety device in case of impact. T h e a d j u s t m e n t i s c o r r e c t w h e n t h e u p p e r e d g e o f t h e h e a d r e s t r a i n t i s l e v e l w i t h t h e t o p o f t h e h e a d . Never drive with the head restraints removed; they must be in place and
adjusted correctly.
Page 55 of 342
Comfort
Manual lumbar adjustment
Turn the knob to obtain the desired level of lumbar suppor t.
Electric lumbar adjustment
Press the front or rear of the control to obtain the desired lumbar suppor t.
This function provides a back massage; it only operates when the engine is running. Press the switch to activate the function. The warning lamp on the switch comes on and the massage function is activated for a period of 60 minutes. During this time, massage is per formed in 6 cycles of 10 minutes each cycle (6 minutes of massage followed by 4 minutes break). After an hour, the function is automatically
deactivated. The warning lamp in the switch goes off.
Deactivation
You can deactivate the massage function at any time by pressing the switch. The movement in progress continues until the initial non-
massage position is reached.
Massage function
Page 56 of 342
Storing driving positions
System which registers the electrical settings of the driver's seat and door mirrors. It enables you to store and recall two positions using the buttons on the side of the driver's seat.
Storing a position
Using buttons M/1/2
Switch on the ignition. Adjust your seat and the door mirrors. Press button M , then press button 1 or 2within four seconds. An audible signal indicates that the position has been stored.
Recalling a stored position
Ignition on or engine running
Press button 1 or 2 to recall the corresponding position. An audible signal indicates the end of the adjustment.
Storing a new position cancels the previous position.
You can interrupt the current movement by pressing button M , 1 or 2 or by using one of the seat controls. A stored position cannot be recalled
while driving. Recalling stored positions is deactivated 45 seconds after switching off the ignition.
Page 57 of 342
91Comfort
Rear seats
Bench seat with fixed one-piece cushion and split b ackrest (left hand 2/3, right hand 1/3) which can be folded individually to adapt the load space in the boot.
Move the corresponding front seat for ward if necessary. Position the seat belt between the outer and centre head restraints to avoid trapping the belt when repositioning the seat backrest. Place the head restraints in the low position.
F o l d i n g t h e b a c k r e s t
Pull control 1 for wards to release the seat back 2 . Fold the seat back 2 on to the cushion.
Straighten the seat back 2 and secure it. Check that the red indicator, located next to the control 1 , is no longer visible. Put the seat belt back in place on the side of the seat backrest.
R e p o s i t i o n i n g t h e s e a t b a c k r e s t
When repositioning the seat backrest, take care not to trap the seat belts.
Page 58 of 342
stowed position (down). They can also be removed. To remove a head restraint: release the backrest using control 1 , tilt the backrest 2 slightly for wards,
pull the head restraint upwards to the stop, then, press the lug A .
R e a r h e a d r e s t r a i n t s
Never drive with the head restraints removed; they must be in place and correctly adjusted.
Steering wheel adjustment
W h e n s t a t i o n a r y , pull the control lever to W h e n s t a t i o n a r y W h e n s t a t i o n a r yrelease the steering wheel. Adjust the height and reach to suit your driving position. Push the control lever to lock the steering wheel.
As a safety precaution, these operations should only be carried out while the vehicle is stationary.
Page 59 of 342
stowed position (down). They can also be removed. To remove a head restraint: release the backrest using control 1 , tilt the backrest 2 slightly for wards,
pull the head restraint upwards to the stop, then, press the lug A .
R e a r h e a d r e s t r a i n t s
Never drive with the head restraints removed; they must be in place and correctly adjusted.
Steering wheel adjustment
W h e n s t a t i o n a r y , pull the control lever to W h e n s t a t i o n a r y W h e n s t a t i o n a r yrelease the steering wheel. Adjust the height and reach to suit your driving position. Push the control lever to lock the steering wheel.
As a safety precaution, these operations should only be carried out while the vehicle is stationary.
Page 60 of 342
93Comfort
Mirrors
Each fitted with an adjustable mirror glass permitting the lateral rear ward vision necessary for over taking or parking. They can also be folded for parking in confined spaces.
D e m i s t i n g - D e f r o s t i n g
Adjustment
Move control A to the right or to the left to select the corresponding mirror. Move control B in all four directions to adjust. Return control A to the central position.
Door mirrors
The objects obser ved are, in reality, closer than they appear. Take this into account in order to correctly judge the distance of vehicles approaching from behind.
Folding
From outside: lock the vehicle using the remote control or the key. From inside: with the ignition on, pull control A rear wards.
Unfolding
From outside: unlock the vehicle using the remote control or the key. From inside: with the ignition on, pull control A rear wards.
If the mirrors are folded using control A , they will not unfold when the vehicle is unlocked. Pull again on control A .
The folding and unfolding of the door mirrors using the remote control can be deactivated by a CITROËN dealer.
Never fold or unfold the electric folding mirrors manually.
If your vehicle is fitted with heated mirrors, the demisting-defrosting operates with the engine running, by switching on the heated rear screen (refer to the "Rear screen demist-defrost"
page).