Citroen DS5 HYBRID4 2012 1.G Owner's Manual

239Checks
Coolant level
The coolant level should be closeto the "MA X" mark but should never exceed it.


Changing the coolant
The coolant does not have to be changed.


Coolant specifi cation

The coolant must conform to the
manufacturer's recommendations.

Power steering fluid
level
The power steering fluid level should
be close to the "MA X" mark. Unscrew
the cap, with the engine cold,
to check the level. Th
e brake fluid level should be close
to the "MA X" mark. If it is not, check
the brake pad wear.

Brake fluid level


Changing the fl uid

Refer to the ser vicing booklet for the inter val for
this operation.

Fluid specifi cation

The brake fluid must conform to themanufacturer's recommendations and meet the
DOT4 standard.
In addition, as the cooling system ispressurised, wait at least one hour after
switching off the engine before carrying out any work. To avoid any risk of scalding, unscrewthe cap by two turns to allow the pressure to drop. When the pressure has dropped, remove the cap and topup the level. When the en
gine is warm, the temperature of
the coolant is regulated by the fan. This can
operate with the ignition off.
On vehicles which are fitted with a particle
emission filter, the fan may operate after
the vehicle has been switched off, even if
the engine is cold
.

Screenwash / headlamp
wash level
To check the level or top up the fluid on vehicle
fitted with headlamp washers, immobilise the
vehicle and switch of the en
gine. )Before opening the bonnet, ensure that the
engine has completely stopped. )Open the screenwash reser voir filler cap.

To p p i ng up

This additive must be topped up by a CITROËN
dealer or a qualified workshop without delay.

Diesel additive level
(Diesel engine with particle
emission filter)
A low additive level is
indicated by illumination of
the ser vice warning lamp,
accompanied by an audible
warning and a message in the instrument panelscreen.

Specifi cation of the fl uid
To ensure optimum cleaning and to avoid freezing, the fluid should never be topped up or
replaced by plain water.

)
Take and pinch the level gauge to block itsbreather.)
Remove the gauge completely from
the reservoir to read the level in thetransparent section.) To p u p i f n e c e s s a ry. )
Refit the filler cap to the reser voir and close the bonnet.

Checks
Avoid prolonged contact of used oil or fluids with the skin. Most of these fluids are harmful to
health or indeed very corrosive.

Do not discard used oil or fluids into sewers or onto the ground.
Take used oil to a CITROËN dealer or a qualified workshop (France) or to anauthorised waste disposal site.
Used products







Checks
Unless otherwise indicated, check these
components in accordance with the servicing
booklet and according to your engine.
Other wise, have them checked by a CITROËN
dealer or a qualified workshop.
Before doing anything under the bonnet, switch off the ignition ( Readylamp off)to avoid any risk of injury resulting from automatic operation of the engine.The presence o
f this label, in particular with
the Stop & Start system, indicates the use of
a specific 12 V lead-acid battery with special
technology and specification. The involvement of a CITROËN dealer or a qualified workshop is essential when replacing or disconnecting the
battery.
12 V battery
The battery does not require any maintenance. However, check that the terminals
are clean and correctly tightened,
particularly in summer and winter.
When carr
ying out work on the battery, refer
to the "Practical information" section for
details of the precautions to be taken before
disconnectin
g the battery and following its reconnection.

Particle emission filter (Diesel)
The start of saturation of theparticle filter is indicated bythe temporary illumination of
this warning lamp accompanied by a message
in the multi-function screen.
As soon as the traffic conditions permit, regenerate the filter by driving at aspeed of at least 40 mph (60 km/h) until the warning lamp goes off.
If the warning lamp stays on, this indicates a low additive level.


On a new vehicle, the first par ticlefilter regeneration operations may be accompanied by a "burning" smell, which is perfectly normal.
Following prolonged operation of the vehicle at very low speed or at idle, you may, in exceptional circumstances,notice the emission of water vapour at the exhaust on acceleration. This does not affect the behaviour of the vehicle or the environment.
The 100% electric mode is not available during regeneration of the par ticle emissions filter.
Air filter and passenger compartment filter
Oil filter

Replace the oil filter each time the engine oil is changed.
Refer to the ser vicing booklet for
details of the replacement interval for
this component.
Re
fer to the ser vicing booklet for
details of the replacement intervals
for these components.
Dependin
g on the environment (e.g. dustyatmosphere) and the use of the vehicle (e.g. city driving), replace them twice as often if necessary.y A clogged passenger compartment filter mayhave an adverse effect on the performance
of the air conditioning system and generate undesirable odours.

243Checks
6-speed electronic gearbox
The gearbox does not require anymaintenance (no oil change).
Refer to the ser vicing booklet for
details of the checking interval for
this component.
Brake wear depends on the st
yle
of driving, par ticularly in the case
of vehicles used in town, over shor tdistances. It may be necessary tohave the condition of the brakes checked, evenbetween vehicle services.
Unless there is a leak in the circuit, a drop in
the brake fluid level indicates that the brakepads are worn.















Brake pads

For information on checking brake
disc wear, contact a CITROËN dealer or a qualified workshop.
Brake disc wear
Electric parking brake
This system does not require anyroutine servicing. However, in the
event of a problem, have the systemchecked by a CITROËN dealer or aqualified workshop.

















Only use products recommended by CITROËN or products of equivalent quality and specification. In order to optimise the operationof units as impor tant as the braking
system, CITROËN selects and offers very specific products.
To avoid damaging the electrical units, the use of a high pressure washer in the engine compar tment is strictly prohibited.
For more information, refer to the "Electric parking brake - Operating faults" section.

010
Technical data

Range varies according to the ambient climatic conditions, the driving style and conditions, the use of vehicle systems and ageing of the battery.











Electric motor and battery
Electric motor-

Te c h n o l ogy
Synchronous with permanent magnets.
Max. power: EU standard
(kW) 27

Max. power speed (rpm)

2 500

Max. torque: EU standard (Nm)

200

Max. torque speed (rpm) 1 250

E
fficiency (%) 80 to 90
High voltage batteryNi-MH(Nickel Metal Hydride)

Volt a
ge (V~)

200

Energy capacity (kWh / Ah)

1.1 / 5.5
Ran
ge (miles (km)) 1. 2 (2) (approximately)

247Technical data













Engine and gearbox
Diesel engineHDi160 PEF
Gearbox

Electronic gearbox system(6-speed)

Model code

RHC

Cubic capacit
y (cc)

1 997
Bore x stroke
(mm) 85 x 88

Max power: EU standard (kW)
120
Max power en
gine speed (rpm) 3 850

Max torque: EU standard
(Nm)
300

Max torque en
gine speed (rpm) 1 750

Fuel

Diesel

Catalytic converter
yes

P
article emission filter
yes

Oil capacities
(in litres)
Engine (with filter replacement) -

Diesel engineHDi160 PEF
Gearbox
Electronic gearbox system(6-speed)
Model code

RHC



- Unladen weight-


- Kerb weight
*



1 735


- Gross vehicle wei
ght (GV W)
2 265


- Gross train wei
ght (GT W)
on a 12% gradient
2 765



- Braked trailer (within GTW limit) on a 10% or 12% gradient 500



- Braked trailer
**
(with load transfer with the GTW limit)
800



- Unbraked trailer
500



- Recommended nose wei
ght 75

















Weights and towed loads (in kg)
*
The kerb weight is equal to the unladen weight + driver (75 kg).
**
The weight of the braked trailer can be increased, within the GTW limit, if the GV W of the towing vehicle is reduced by an equal amount; warning,
towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.
To make use of the 300 kg load transfer, the driver must be alone in the vehicle with no luggage in the vehicle.
The GTW and towed load values indicated are valid up to a maximum altitude of 1 000 metres; the towed load mentioned must be reduced b
y 10 % for each additional 1 000 metres of altitude.
The speed of a towing vehicle must not exceed 60 mph (10 0 km/h) (comply with the legislation in force in your country).
High ambient temperatures may result in a reduction in the per formance of the vehicle to protect the engine; if the ambient temperature is above 37 °C,
limit the towed load.