DACIA SUPERNOVA 2004 Repair Manual

AIR CONDITIONING
62
62 - 14
Correct AC system
filling.
Compressor does not work.
Ye s
Ye s No Ye s
Check the clutch coil. Damaged,
short-circuit?
Replace the
compressor.Restore the electric circuit
between E and clutch.
Is + 12 V at pol e E 5 of E relay?
Is + 12 V at pole E3 of E relay?
Is + 12 V at pole E3 of E relay?
Check fuse S6 from engine
compartment. Restore the
wiring between S6 and relay E.
No
Restore the wiring between pole
E1 of E relay a nd pole D5 of D
relay.
No
The wiring between injection
computer
and the pole E2 of E re lay is broken ?
Ye s
Repair the wiring.
Ye s
No
Check the pressure
controller electric circuit.
Injection computer does not receive
AC actuation?Yes
Check the switch electric circuit.
Pressure controller is working?
No
Replace the switch.
AC control switch is
working ?No
Ye s
Ye s
Check the pressure controller
electric circuit.
No
Replace the pressure controller.
No
DIAGNOSIS
vnx.su

SEALI NG OPENING ELEMENTS
65
65 - 1
D
OOR FRAMES GASKETS
DISMOUNTING
Dismount the front and rear frames gaskets following the doors outliners, by drawing towards
outside of one of their ends.
REMOUNTING
Perform in the reverse order the dismounting operations.
The mounting of the sealing gaskets on frames is performed by tapping with a rubber hammer.
CARRIAGE BODY SEALING
vnx.su

SEALING WINDOWS AND SCREENS
66
66 - 1
1. Windscreen gasket
2. H atchback gasket
3. Fix window gasket
DISMOUNTING
Di smount the windscreen gl ass (1), hatchback (2 ) , or fix (3), together with the ga sket by
pushing from the inside of the vehicle. The glass gasket shall be cleaned is reused, or replaced with a new one.
REMOUNTING
Position the gasket (2) around the glass (1) and place the a ssembly on a protection plate.
P lace t he gasket (2 ) all around the gl ass ( 1) where a c otton cord of 3 – 4 mm di ameter has
been previously introduced, leaving at the ends (3) about 20 mm of cord, and between the ends,
the distance shall be not more than 10 mm.
GLASSES SEALING
vnx.su

SEALING WINDOWS AND SCREENS
66
66 - 2
INSI
DE WIPERS
DISMOUNTING
Dismo unt :
- opening handle
- window regulator crank
- door opening mechanism
- door blocking button
- panel attachment screws
Detach the panel.
Remove the inside wiper.
REMOUNTING
Perform in the reverse order the dismounting operations.
vnx.su

SEALING WINDOWS AND SCREENS
66
66 - 3
DISMOUNTING
Lower the window in the minimum position.
Di
sm ount the out side wi per (1), by
detaching it from the clips (2).
REMOUNTING
Per f o r m in the reverse order the
dismounting operations.
OUTSIDE WIPERS
vnx.su

71
INTRENAL BODY TRIM
72 - 1
1. Front door threshold
covering
2. Rear door threshold covering
3. Upper front pillar covering
4. Middle pillar lower covering
5. Middle pillar covering
6. Rear passage covering
7. Rear side panel covering
8. Rear wheel passage covering CARR
IAGE BODY COVERINGS
vnx.su

71
INTRENAL BODY TRIM
72 - 2
DISMOUNTING
Dismou
nt :
- the attachment screw of front door
threshold covering on the front pillar; - the screws (2) and plastic nuts (4);
- release the front door threshold covering.
REMOUNTING
Perform in the reverse order the dismounting
operations. FRONT DOOR THRESHOLD COVERING
vnx.su

71
INTRENAL BODY TRIM
72 - 3
U
PPER FRONT PILLAR COVERING
DISMOUNTING
Dismo unt :
- the attachment screw (1) of the upper
front pillar covering (2) on the roof lining
- detach from clips (3) the upper front pillar
covering and release it.
REMOUNTING
Perform in the reverse order the dismounting
operations.
vnx.su

71
INTRENAL BODY TRIM
72 - 4
DISMOUNTING
Move the front seat in the most advanced po-
sition and dismount:
- front/rear belts attachment screws (1) of
rear door threshold covering on the middle pillar
lining, respectively the lateral frame lining; - screws (2) and a ttachment clips (3) of
the rear door t hreshold coveri ng on the lateral
frame lining;
- release the rear door threshold covering ( 5).
REMOUNTING
Perform in the reverse order the dismounting
operations. RE
AR D OOR THRESHOLD COVERING
vnx.su

71
INTRENAL BODY TRIM
72 - 5
DISMOUNTING
Dismo
unt :
- screw (2 ) and attachment clips (3) of the
middle pillar covering on the middle pillar lining;
- release the middle pillar covering.
REMOUNTING
Perform in the reverse order the dismounting
operations. MIDDLE PILLAR COVERING
vnx.su