bulb DODGE DURANGO 2008 2.G User Guide

Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle's OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine. If you crank or start the engine, you
will have to start this test over.
3. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
4. Approximately 15 seconds later, one of two things will
happen:
a. The MIL light will blink for approximately 5 sec-
onds and then remain on until the first engine crank orthe key is turned off. This means that your vehicle's
OBD system isnot readyand you shouldnotproceed
to the I/M station.
b. The MIL light will remain fully illuminated until the
first engine crank or the key is turned off. This means
that your vehicle's OBD system isreadyand you can
proceed to the I/M station.
If your OBD system isnot readyyou should see your
dealer or repair facility. If your vehicle was recently
serviced or had a battery failure or replacement, you may
need to do nothing more than drive your vehicle as you
normally would in order for your OBD system to update.
A recheck with the above test routine may then indicate
that the system is now ready.
Regardless of whether your vehicle's OBD system is
ready or not ready, if the MIL symbol is illuminated
during normal vehicle operation, you should have your
MAINTAINING YOUR VEHICLE 389
7

REPLACEMENT LIGHT BULBS
LIGHT BULBS Ð Interior Bulb No.
Dome Light.................... NotServiceable
Liftgate Lamp........................... 567
Overhead Console Lights........... NotServiceable
Reading Light................... NotServiceable
Visor Vanity Lights............... NotServiceable
LIGHT BULBS Ð Exterior Bulb No.
Headlight............................. H13
Front Park/Turn......................3457AK
Back-Up..............................3057
Center High Mounted Stoplight.............. 921
Front Side Marker........................ 168
Fog Lamp...........................9006LL
License Plate Light....................... 168
Rear Tail, Stop, Turn Signal and Side Marker....3057
BULB REPLACEMENT
Headlights/Parking/Turn Signal
1. Remove the two bolts attaching the headlight to the
upper fender reinforcement (hood must be open to access
bolts).
430 MAINTAINING YOUR VEHICLE

2. Remove one nut that attaches the headlight to the
inner fender panel. Access to the nut is possible by
opening the fender panel access door which is located in
the wheel liner.
3. Grasp the headlight and pull firmly to disengage the
headlight from the fender panel.4. While firmly holding the headlight in your hands
disconnect all connectors by following the procedure
described in step number 5 below.
5. Remove the bulb connector from the headlight making
sure to pull and release the red tab on all connectors.
Loosen the connector by pressing down on the black
and/or green release which is located below or above the
red tab. The green release is located above the red tab on
the H13, the black release is located above the 3457AK
red tab.
6. Twist and remove socket from lamp.
7. Remove bulb from socket and replace.
NOTE:These are Halogen bulbs. Take care not to touch
the bulb with your fingers. Body oils from your fingers
could cause excessive heat build-up which reduces bulb
life.
MAINTAINING YOUR VEHICLE 431
7

4. Remove the three screws holding the bulb strip to the
back of the tail lamp.5. Remove the bulb strip from the tail light lens.
434 MAINTAINING YOUR VEHICLE

6. Remove bulbs from bulb strip by pulling the bulb
straight out.
MAINTAINING YOUR VEHICLE 435
7

License Lights
1. Remove the two screws securing the lens to the
liftgate.2. Rotate the socket 1/4 turn counterclockwise.
3. Pull bulb from socket.
436 MAINTAINING YOUR VEHICLE

Center High-Mounted Stoplight
1. Remove two screws securing stoplight housing assem-
bly to the liftgate.2. Turn socket 1/4 counterclockwise and free from hous-
ing.
3. Pull bulb straight from socket to remove.
MAINTAINING YOUR VEHICLE 437
7

Fog Lights
To replace the left foglamp bulb:
1. Remove the three wheel liner screws.2. Remove the remove the far left air dam screw at the
bottom of the fascia.
3. Peel back the liner and access the foglamp.
4. Rotate the socket and connector 1/4 turn counter-
clockwise and pull straight reward to disengage from the
lamp.
5. Remove the bulb from the socket and replace.
The right foglamp can be accessed from below the
vehicle. Follow the previous steps 4 and 5 of the left
foglamp to replace the bulb.
NOTE:These are Halogen bulbs. Take care not to touch
the bulb with your fingers. Body oils from your fingers
could cause excessive heat build-up, which reduces bulb
life.
438 MAINTAINING YOUR VEHICLE

Special Additives...................... 413
Torque Converter...................... 280
Axle Fluid............................. 441
Axle Lubrication (Axle Fluid)............... 414
Ball Joints............................. 400
Battery.......................384,385,386,397
Charging............................ 375
Emergency Starting..................... 375
Gas Caution.......................... 375
Keyless Transmitter Replacement (RKE)....... 26
Saving Feature (Protection)............... 139
Belts, Drive............................ 394
Belts, Seat.............................. 40
Body Mechanism Lubrication............... 401
B-Pillar Location........................ 309
Brake Assist System...................... 296
Brake Control System, Electronic............. 295
Brake Fluid............................ 441Brake System........................291,410
Anti-Lock (ABS)....................291,295
Disc Brakes.......................... 410
Fluid Check.......................... 410
Hoses.............................. 411
Master Cylinder....................... 410
Parking............................. 290
Warning Light.....................195,199
Brakes............................... 291
Brake/Transmission Interlock............... 276
Break-In Recommendations, New Vehicle........ 74
Bulb Replacement....................... 430
Bulbs, Light............................ 430
Calibration, Compass..................... 166
Camera, Rear........................... 156
Capacities, Fluid........................ 439
Caps, Filler
Fuel................................ 336
INDEX 463
10

Information Center, Vehicle................. 159
Inside Rearview Mirror.................... 83
Instrument Cluster....................... 193
Instrument Panel and Controls.............. 191
Instrument Panel Lens Cleaning............. 419
Integrated Power Module (Fuses)............ 427
Interior Appearance Care.................. 418
Interior Fuses.......................... 421
Interior Lighting........................ 138
Interior Lights.......................... 138
Intermittent Wipers (Delay Wipers)........... 144
Introduction............................. 4
Inverter Outlet (115V)..................... 177
Jack Location........................... 367
Jack Operation.......................367,370
Jacking Instructions...................... 371
Key, Programming........................ 15Key, Replacement........................ 15
Key, Sentry (Immobilizer)................... 13
Keyless Entry System...................... 20
Keys................................. 12
Knee Bolster............................ 53
Lane Change and Turn Signals.........142,193,432
Lap/Shoulder Belts.....................40,46
LATCH
(Lower Anchors and Tether for CHildren)....... 68
Life of Tires............................ 319
Liftgate................................ 35
Lights..............................77,137
Airbag............................61,203
Anti-Lock Warning..................... 195
Automatic Headlights................... 140
Back-Up............................. 432
Brake Warning........................ 199
Bulb Replacement...................... 430
470 INDEX