battery FIAT 500E 2016 2.G Repair Manual

Recreational.......................... .261
Towing Vehicle Behind A Motorhome ...........261
Traction ............................ .214, 215
Traction Control ......................... .222
Trailer Towing .......................... .261
Transaxle Automatic .............................32
Transmission Automatic ........................... .208
Fluid ............................... .328
Transmitter Battery Service (Remote Keyless Entry) . .38
Transporting Pets ..........................92
Tread Wear Indicators ..................... .248
Turn Signals ..........................112,164
UCI Connector .......................... .175
Uniform Tire Quality Grades .................345
Universal Consumer Interface (UCI) Connector . . . .175 Untwisting Procedure, Seat Belt
................53
Vehicle Identification Number (VIN) .............7
Vehicle Loading ......................... .235
Vehicle Modifications/Alterations ...............8
Vehicle Security Alarm Disarming ..............36
Vehicle Storage .......................... .201
Warnings And Cautions ......................7
Warranty Information ..................... .343
Washers, Windshield ....................116,118
Washing Vehicle ......................... .307
Water Driving Through ....................... .215
Wheel And Wheel Trim .....................309
Wheel And Wheel Trim Care .................309
Wind Buffeting ....................... .44, 131
Window Fogging ........................ .200
Windows ................................43
10
INDEX 357

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.