warning FIAT CROMA 2005 2.G Cut Off Switch Manual

Page 7 of 16

7
POWER SUPPLY AND FUEL CUT-OFF SWITCHES
The car is fitted with a safety switch that in the event of a crash comes
into operation by cutting off fuel and turning off the engine as a
consequence.
Certain versions are equipped with an additional safety switch that in the
event of a crash comes into operation by cutting off the power supply to
the electrical devices installed on the car.
These two safety switches therefore prevent dangerous fuel leaks due to
fuel line cracking, and sparks or electric discharges due to damaging or
malfunctioning of the electric components of the car in the event of a
crash.
IMPORTANT After a crash, remember to remove the key from the
ignition device to prevent battery run-down.
If, after a crash no fuel leaks or damages to the electric devices (e.g.
headlights) are found and the car can be started again, reset the fuel cut-
off switch and the power supply cut-off switch (where provided). Follow
the operations given below.
Resetting the fuel cut-off switch
To reset the fuel cut-off switch, press button A.
Resetting the power supply cut-off switch (where provided)
The switch is located inside the fuse box at battery positive terminal.
WARNINGIf, after a crash, you smell fuel or see leaks
from the fuel system, do not reset the
switches to avoid fire risk.
F0L0107m
603.46.631 Croma interr blocco 25-03-2005 8:27 Pagina 7

Page 8 of 16

8
POWER SUPPLY AND FUEL CUT-OFF SWITCHES
F0L0308m
F0L0307m
WARNINGBefore resetting the power supply cut-off
switch carefully inspect the car for fuel
leaks or damages to electric devices (e.g.
headlights).
WARNINGBefore resetting the fuel cut-off switch
carefully inspect the car for fuel leaks or
damages to electric devices (e.g.
headlights). To reset the power supply cut-off switch, proceed as follows:
❒press button A to reset the fuel cut-off switch;
❒open the bonnet;
❒operate the retaining clips B and remove the protection cover C;
❒press button D to reset the power supply cut-off switch.
Sunroof, sun curtain (where provided) and power window
system initialisation
After resetting the switches, initialise again sunroof, sun curtain and
power window system operation. For the relevant procedures refer
respectively to pages 105, 106 and 110 of the Owner Handbook
603.46.631 Croma interr blocco 25-03-2005 8:27 Pagina 8