FORD EXPLORER 1996 2.G Owner's Manual

Safety Restraints
19
[SR04100( X)04/94]
10-1/2 pica
art:0020663-C
Rear combination lap and shoulder belts (2 door model)
[SR05800(ALL)08/94]
Center Front Lap Belt (If equipped)
[SR05900(ALL)10/90]
The lap belt in the center of the front seat does not adjust
automatically. You must adjust it to fit snugly around your
hips. Do not wear it around your waist.
*
[SR05950(ALL)06/95]
To fasten the belt, pull the belt across your hips and insert the
tongue into the correct buckle on your seat until you hear a
snap and feel it lock. Make sure the buckle is securely fastened.
%*
[SR06100(ALL)06/95]
If you need to lengthen the belt, unfasten it and tip the belt
tongue at a right angle to the belt. Pull the belt tongue over
your lap until it reaches the buckle.
*
[SR06400(ALL)06/95]
If you need to shorten the belt, pull on the loose end of the
webbing until the belt fits snugly.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

20
[SR06500(ALL)10/90]
To unfasten the belt, push the release button on the buckle. This
allows the tongue to unlatch from the buckle.
[SR06600(ALL)06/95]
Because the center front lap belt does not have a retractor, it
should be shortened and fastened when not in use.
[SR06700(ALL)05/94]
10-1/2 pica
art:0021123-A
Fastening and unfastening the front center safety belt
*
[SR06800(ALL)07/95]
RWARNING
The lap belts should fit snugly and as low as possible
around the hips, not around the waist.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

Safety Restraints
21
[SR07900(ALL)10/90]
Rear Lap Belt with Retractor
[SR08000(ALL)12/89]
Pull the belt out of the retractor with a steady motion and insert
the tongue into the proper buckle until you hear a snap and
feel the latch engage.
[SR08100( X)04/94]
10-1/2 pica
art:0020640-D
Fastening and unfastening the rear center safety belts (4-door model)
*
[SR08500(ALL)05/95]
To Unfasten the Safety Belts with Retractors:
*
[SR08600(ALL)08/95]1.
Push the release button on the buckle. This allows the
tongue to unlatch from the buckle.
*
[SR08700(ALL)03/95]2.
While the belt retracts, guide the tongue to its stowed
position. If you do not guide the tongue, it may strike you
or part of the vehicle.
%*
[SR09600(ALL)08/95]
Safety Belt Extension Assembly
*
[SR09700(ALL)07/95]
For some people, the safety belt may be too short even when it
is fully extended. You can add about eight inches (20 cm) to the
belt length with a safety belt extension assembly (part number
611C22). Safety belt extensions are available at no cost from
your dealer.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

22
*
[SR09790(ALL)08/95]
Use only extensions manufactured by the same supplier as the
safety belt. Manufacturer identification is located at the end of
the webbing on the label. Also, use the safety belt extension
only if the safety belt is too short for you when fully extended.
Do not use extension to change the fit of the shoulder belt
across the torso.
*
[SR09800(ALL)08/95]
RWARNING
Failure to follow these instructions will affect the
performance of the safety belts and increase the risk of
personal injury.
%*
[SR09900(ALL)08/95]
Safety Belt Maintenance
*
[SR10000(ALL)09/95]
Check the safety belt systems periodically to make sure that
they work properly and are not damaged.
[SR10020( X)06/95]
The short plastic boot on the front safety belt at the passenger
outboard anchor location covers an energy absorbing sew
pattern on the safety belt. In the event of an accident, the sew
pattern may release, and the colored label (REPLACE BELT)
may become visible. If this occurs,the safety belt must be
replaced.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

Safety Restraints
23
[SR10035(ALL)06/95]
33-1/2 pica
art:0021286-B
Energy absorbing sew pattern
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

24
[SR10040(ALL)06/95]
RWARNING
FAILURE TO REPLACE THE SAFETY BELT ASSEMBLY
UNDER THE ABOVE CONDITIONS COULD RESULT
IN SEVERE PERSONAL INJURIES IN THE EVENT OF
A COLLISION.
%*
[SR10200(ALL)10/95]
All safety belt assemblies, including retractors, buckles, front
seat belt buckle support assemblies (slide bar) (if equipped),
child safety seat tether bracket assemblies (if equipped), and
attaching hardware, should be inspected after any collision. Ford
recommends that all safety belt assemblies used in vehicles
involved in a collision be replaced. However, if the collision was
minor and a qualified technician finds that the belts do not
show damage and continue to operate properly, they do not
need to be replaced. Safety belt assemblies not in use during a
collision should also be inspected and replaced if either damage
or improper operation is noted.
%*
[SR10250(ALL)06/95]
Cleaning the Safety Belts
*
[SR10275(ALL)06/95]
Clean the safety belts with any mild soap solution that is
recommended for cleaning upholstery or carpets. Do not bleach
or dye the belt webbing because this may weaken it.
%*
[SR10300(ALL)06/95]
Air Bag Supplemental Restraint System
(SRS)
*
[SR10800(ALL)05/95]
The driver and right front passenger air bags are Supplemental
Restraint Systems (SRS), provided at these seating positions in
addition to the lap/shoulder belt, and are designed to
supplement the protection provided to properly belted
occupants in moderate to severe frontal collisions. The
supplemental air bag system does not provide restraint to the
lower body.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

Safety Restraints
25
%*
[SR10900(ALL)05/95]
The Importance of Wearing Safety Belts
*
[SR11000(ALL)06/95]
RWARNING
Safety belts must be worn by all vehicle occupants to be
properly restrained and help reduce the risk of injury in
a collision.
*
[SR11050(ALL)05/95]
RWARNING
All occupants of the vehicle, including the driver, should
always wear their safety belts, even when an air bag
Supplemental Restraint System is provided.
*
[SR11100(ALL)01/95]
There are four very important reasons to use safety belts even
with an air bag system. Use your safety belts to:
*
[SR11200(ALL)01/95]
n
help keep you in the proper position (away from the air bag)
when it inflates
*
[SR11300(ALL)01/95]
n
reduce the risk of harm in rollover, side or rear impact
collisions, because an air bag is not designed to inflate in
such situations
*
[SR11350(ALL)01/95]
n
reduce the risk of harm in frontal collisions that are not
severe enough to activate the supplemental air bag
*
[SR11400(ALL)01/95]
n
reduce the risk of being thrown from your vehicle
[SR11500(ALL)06/95]
RWARNING
The right front passenger air bag is not designed to
restrain occupants in the center front seating position.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

26
%*
[SR11600(ALL)01/95]
The Importance of Being Properly Seated
*
[SR11700(ALL)05/95]
In a collision, the air bag must inflate extremely fast to help
provide additional protection for you. In order to do this, the
air bag must inflate with considerable force. If you are not
seated in a normal riding position with your back against the
seatback, the air bag may not protect you properly and could
possibly hurt you as it inflates.
% [SR11800( X)05/95]
Important Information About the Right Front Passenger
Air Bag
[SR11900(ALL)05/95]
It is important for the front seat passengers' safety that they
remain properly seated whenever the vehicle is moving. This
means that small children should be secured in appropriate
child safety seats or infant seats, and all other occupants should
sit upright, with their backs against the seatback, and restrained
by lap and shoulder belts. No passenger should sit toward the
front edge of the seat, or stand or lean near the air bag cover
(which is near the glove box).
*
[SR12000( X)08/95]
RWARNING
If a passenger is not properly seated and restrained, an
inflating air bag could cause serious injury.
*
[SR12100( X)07/95]
In rear-facing infant seats, the infant's head is closer to the air
bag. The force of the rapidly inflating air bag could push the
top of the rear-facing seat against the vehicle seatback or center
armrests (if so equipped), or center console (if so equipped).
REAR-FACING INFANT CARRIERS MUST ALWAYS BE
SECURED IN THE REAR SEAT, and other child safety seats
and infant seats should be secured in the rear seat whenever
possible.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

Safety Restraints
27
*
[SR12290( X)07/95]
Your vehicle is equipped with a right front passenger air bag.
Air bags deploy with great force, faster than the blink of an eye.
Front passengers, especially children and small adults, must
never sit on the front edge of the seat, stand near the glove
compartment of the instrument panel, or lean over near the air
bag cover when the vehicle is moving. All occupants should sit
with their backs against the seatback, move the seat to the most
rearward position if possible and use the safety belts. Children
weighing less than 40 lbs. (18 kg) always should use child or
infant seats.
%*
[SR12300( X)07/95]
RWARNING
When using forward-facing child seats move the
passenger seat as far back from the instrument panel as
possible. NEVER SECURE REAR-FACING INFANT
SEATS IN THE FRONT SEAT.
*
[SR12310( X)11/95]
The force of the rapidly inflating passenger air bag could push
the top of the rear-facing seat against the vehicle seatback,
armrests or console. Rear-facing infant seats must always be
secured in the rear seat.
*
[SR12400( X)07/95]
RWARNING
Do not place objects or mount equipment on or near the
air bag cover on the steering wheel or in front seat areas
that may come in contact with a deploying air bag.
Failure to follow this instruction may increase the risk of
personal injury in the event of a collision.
*
[SR12500( X)08/95]
For additional important safety information on the proper use of
seat belts, child seats, and infant seats, please read the other
sections of this chapter of the Owner Guide, especially sections
entitledSafety Belts for ChildrenandSafety Seats for Children.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996

28
*
[SR12600( X)07/95]
For further information about the proper mounting of
equipment in the front seat of this vehicle, please refer to Ford's
brochure entitledSome Important Information About Air Bag
Supplemental Restraint Systemwhich can be obtained by calling
Helm Inc. at 1-800-782-4356. Ask for brochure FPS-8602.
%*
[SR12700(ALL)01/95]
How the Air Bag Supplemental Restraint System
Operates
*
[SR12800( X)06/95]
The Air Bag Supplemental Restraint System consists of the
driver and passenger air bags, impact sensors, a system
diagnostic module, a readiness light and tone, and the electrical
wiring which connects the components.
[SR12900(ALL)06/95]
The driver air bag is in the center of the steering wheel. The
right front passenger seat air bag (if equipped) is in the upper
right hand section of the instrument panel ledge above the
glove compartment.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996