Torque FORD KUGA 2011 1.G Workshop Manual

Output Shaft Speed (OSS) Sensor
MaterialsSpecification
Name
WSS-M2C924-A / 4U7J-
M2C924-AA
Automatic Transmission
Oil E-AW
Removal
1.
Refer to: Health and Safety Precautions (100-00
General Information, Description and
Operation).
2. WARNING: Be prepared to collect escaping fluid.
E115345
3.
E115335
Installation
1. NOTE: Make sure that a new component is
installed.
Material: Automatic Transmission Oil E-AW (WSS-M2C924-A / 4U7J-M2C924-AA)
transmission fluid
E115336
2. WARNING: Make sure that a new bolt is installed.
Torque: 5Nm
E115253
G1163635en2008.50 Kuga8/2011
307-01- 72
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 72
REMOVAL AND INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

Torque Converter Seal
Special Tool(s) / General Equipment303-293
Remover, Crankshaft Seal
21143
Special Tool(s) / General Equipment308-095
Installer, Input Shaft Bearing
16038
Round-Ended Steel Rule
Materials
Specification
Name
WSS-M2C924-A / 4U7J-
M2C924-AA
Automatic Transmission
Oil E-AW
Removal
1.
Refer to: Transmission (307-01 Automatic
Transmission/Transaxle - Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD,
Removal).
2.
E115423
3. Special Tool(s): 303-293
303-293303-293
E115424
G1163637en2008.50 Kuga8/2011
307-01- 73
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 73
REMOVAL AND INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

Installation
1. CAUTION: Make sure that the matingfaces are clean and free of foreign
material.
Material: Silicone Sealant LG (WSS-M4G320-A3/ 6G9N-M4G320-AA) sealant
3mm3mm
E115316
2. Torque: 18Nm
x9x9
E115315
3.
E115327
4.
E115314
5.Refer to: Transmission Fluid Drain and Refill
(307-01 Automatic Transmission/Transaxle -
Vehicles With: 5-Speed Automatic Transaxle
- AW55 AWD, General Procedures).
G1163608en2008.50 Kuga8/2011
307-01- 76
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 76
REMOVAL AND INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

Installation
1. NOTE:Make sure that a new component is
installed.
1.
2.
NOTE: Only tighten the bolts finger tight at
this stage.
2
1
2
1
E114441
2. Torque: 16Nm2.
2121
E114440
3.2. CAUTION: Use an open-ended
wrench to prevent the component
from turning.
3. Torque: 25Nm
1
3
2
1
3
2
E114442
4.
E114437
G1163634en2008.50 Kuga8/2011
307-01- 79
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 79
REMOVAL AND INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

Turbine Shaft Speed (TSS) Sensor
MaterialsSpecification
Name
WSS-M2C924-A / 4U7J-
M2C924-AA
Automatic Transmission
Oil E-AW
Removal
1.
Refer to: Health and Safety Precautions (100-00
General Information, Description and
Operation).
2.
E115344
3.
E115335
Installation
1. NOTE: Make sure that a new component is
installed.
Material: Automatic Transmission Oil E-AW (WSS-M2C924-A / 4U7J-M2C924-AA)
transmission fluid
E115336
2. WARNING: Make sure that a new bolt is installed.
Torque: 5Nm
E115252
G1163632en2008.50 Kuga8/2011
307-01- 81
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 81
REMOVAL AND INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

Make sure that the torque converter
remains in the transmission.
General Equipment: Transmission Jack
x2x2
E114751
5. Perform this and the following operation
simultaneously.
Torque: 48
Nm
x2x2
E114623
6.Torque: 48Nm
E114621
7.Remove the following items:
1. General Equipment: Wooden Block General Equipment: Transmission Jack
E114733
8.Torque: 48Nm
E114622
G1163646en2008.50 Kuga8/2011
307-01- 92
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 92
INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

9.Torque: 48
E114620
10.Torque: 6Nm
E114624
11 .Lower the vehicle.
12. Special Tool(s): 303-290A
E114730
G1163646en2008.50 Kuga8/2011
307-01- 93
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 93
INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL
Nm
303-290A
x2

13.Torque: 80Nm
x2x2
E114608
14.Special Tool(s): 303-290A
303-290A303-290A
E114730
G1163646en2008.50 Kuga8/2011
307-01- 94
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 94
INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

15.
E114729
16.Torque: 148Nm1.
2. Torque: 10
Nm
1
2
1
2
E114607
17.Remove the Special Tool(s): 303-290-01,
303-290-03A, 303-290-05A, 303-290A,
303-290A-14
18. Refer to: Lifting(100-02 Jacking and Lifting,
Description and Operation).
19. Material: Grease K-HT (ESD-M1C220-A /
A88SX1C220AA) grease
E114591
20. Torque: 60Nm1.
2. Torque: 60
Nm
3. Torque: 25Nm
4. Torque: 9Nm
E115556
1
2
3
1
1
4
G1163646en2008.50 Kuga8/2011
307-01- 95
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 95
INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

21.
20 mm1
2
20 mm1
2
E101044
22.Torque: 25Nm
E101021
23. 1. CAUTION: Make sure that the
installation marks are aligned.
Torque: 35Nm
2. Torque: 35Nm
3. Torque: 35Nm
3
x2
2
1
2
1
x3
3
x2
2
1
2
1
x3
E101042
24.Refer to: Front Halfshaft LH (205-04 Front Drive
Halfshafts, Removal and Installation).
25. Torque: 48
Nm1.
2. Torque: 80
Nm
1
2
E114913
G1163646en2008.50 Kuga8/2011
307-01- 96
Automatic Transmission/Transaxle
— Vehicles With:
5-Speed Automatic Transaxle - AW55 AWD
307-01- 96
INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL