FORD WINDSTAR 1996 1.G Owners Manual

Driving Your Windstar
259
[DR21600(ALL)10/93]
When stopped in traffic for long periods of time in hot weather,
place the gearshift selector lever in P (Park) to increase the
engine idle speed. This aids in engine cooling and air
conditioner efficiency. If the engine overheats, turn the selector
knob to select the fresh air position to stop the air conditioner
compressor. Increase the engine speed for a short time.
*
[DR21700(ALL)01/93]
Vehicles with trailers should not be parked on a grade.
However, if you must park on a grade, place wheel chocks
under the trailer's wheels as follows:
[DR21800(ALL)11/93]1.
Apply the foot service brake pedal and hold.
*
[DR21900(ALL)11/93]2.
Have another person place the wheel chocks under the
trailer wheels.
[DR22000(ALL)11/93]3.
With the chocks in place, release the foot service brake
pedal, making sure the chocks are holding.
[DR22100(ALL)11/93]4.
Apply the parking brake by pressing the service brake pedal
down firmly with your right foot while applying the parking
brake lever with your right hand.
*
[DR22200(ALL)11/93]5.
Shift the gearshift lever into P (Park).
File:wndrs.ex
Update:Tue Mar 19 08:18:48 1996

260
[DR22300(ALL)11/93]
Complete the following steps to start your vehicle after it has
been parked on a grade:
[DR22400(ALL)11/93]1.
Apply the foot service brake pedal and hold.
*
[DR22500(ALL)11/93]2.
Start the engine.
*
[DR22600(ALL)11/93]3.
Shift the gearshift lever into gear and release the parking
brake.
[DR22700(ALL)11/93]4.
Release the foot service brake pedal and move the vehicle
uphill to free the wheel chocks.
[DR22800(ALL)11/93]5.
Apply the foot service brake pedal and hold while another
person retrieves the chocks.
File:wndrs.ex
Update:Tue Mar 19 08:18:48 1996

261
Roadside Emergencies
%*
[RE00700(ALL)03/95]
Jump-Starting Your Vehicle
*
[RE00800(ALL)01/93]
Your vehicle's battery may discharge if you leave the lights or
any electrical equipment on after you turn the engine off. If this
happens, you may be able to jump-start from a booster battery
to start your vehicle.
*
[RE00900(ALL)02/95]
RWARNING
The gases around the battery can explode if exposed to
flames, sparks, or lit cigarettes. An explosion could result
in injury or vehicle damage.
*
[RE01000(ALL)02/95]
RWARNING
To protect yourself when charging a battery, always
shield your face and eyes. Make sure that you can
breathe fresh air.
%*
[RE01100(ALL)05/95]
RWARNING
Applying too much pressure on the ends when lifting a
battery could cause acid to spill. Lift the battery with a
carrier or with your hands on the opposite corners.
%*
[RE01200(ALL)05/95]
RWARNING
Batteries contain sulfuric acid which burns skin, eyes,
and clothing.
*
[RE01220(ALL)05/95]
If the acid touches someone's skin, eyes, or clothing,
immediately flush the area with water for at least 15 minutes. If
someone swallows the acid, have him or her drink lots of milk
or water first, then Milk of Magnesia, a beaten egg, or vegetable
oil. Call a doctor immediately.
File:wnres.ex
Update:Tue Mar 19 08:18:21 1996

262
*
[RE01400(ALL)03/95]
To avoid damaging your vehicle or your battery, and to avoid
injury to yourself, follow these directions for preparing your
vehicle to jump-start and connecting the jumper cables in the
order they are given. If in doubt, call for road service.
[RE01500(ALL)02/95]
To prepare your vehicle for jump-starting:
[RE01600(ALL)02/95]1.
Use only a 12-volt battery to jump-start your vehicle. Your
vehicle has a 12-volt starting system, so you need to use a
12-volt jumper system. You can damage your starting motor,
ignition system, and other electrical parts if you connect
them to a 24-volt power supply (either two 12-volt batteries
in series or a 24-volt motor generator set).
*
[RE01700(ALL)03/95]2.
Do not disconnect the battery of the vehicle that needs a
jump-start. You could damage the vehicle's electrical system.
*
[RE01800(ALL)03/95]3.
Park the second vehicle close to the hood of your vehicle,
but make sure the vehicles do not touch each other. Set the
parking brake on both vehicles and stay clear of the engine
cooling fan.
*
[RE01900(ALL)03/95]4.
Check the battery terminals and remove any excessive
corrosion before you attach the jumper cables.
*
[RE02000(ALL)01/93]5.
Turn on the heater blower in both vehicles. Turn off all other
switches and lights in both vehicles to prevent possible
damage to either vehicle's electrical systems.
File:wnres.ex
Update:Tue Mar 19 08:18:21 1996

Roadside Emergencies
263
% [RE02100(ALL)02/95]
To connect the jumper cables:
[RE02200(ALL)02/95]1.
Connect one end of the first jumper cable to the positive (+)
terminal of the dead battery. (You can connect either jumper
cable to the positive (+) terminal, as long as you use the
same cable for both positive terminals.) Most jumper cables
have a red cable and a black cable. The red cable is generally
used for the positive terminals and the black for the negative
ones.
*
[RE02300(ALL)04/95]2.
Connect the other end of the first cable to the positive (+)
terminal of the booster battery.
*
[RE02400(ALL)03/95]3.
Connect one end of the second cable to the negative (s)
terminal of the booster battery Ð NOT to the dead battery.
[RE02500(ALL)12/93]4.
Connect the other end of that cable to a good, unpainted
metallic surface in the engine compartment of the vehicle
that needs a jump-start. The following illustration shows
where you can find a metallic surface.
*
[RE02600(ALL)05/95]
RWARNING
Do not connect the end of the second cable to the
negative (-) terminal of the battery to be jumped. A spark
may cause an explosion of the gases that surround the
battery.
File:wnres.ex
Update:Tue Mar 19 08:18:21 1996

264
[RE02700(ALL)08/94]
24 pica art:0050022-B
Jumper Cable Placement (3.8L)
File:wnres.ex
Update:Tue Mar 19 08:18:21 1996

Roadside Emergencies
265
[RE02750(ALL)04/95]
24 pica art:0050259-B
Jumper Cable Placement (3.0L)
[RE02800(ALL)02/95]
After you connect the jumper cables to the batteries:
*
[RE02900(ALL)03/95]1.
Make sure that the jumper cables are not in the way of
moving engine parts, then start the vehicle that has the
booster battery. Run the engine at a moderate speed.
File:wnres.ex
Update:Tue Mar 19 08:18:21 1996

266
[RE03000(ALL)02/95]2.
Let the dead battery charge for a few minutes and then start
the vehicle that has the dead battery. If the starter does not
crank, check for good, solid jumper cable clamp attachments.
It may take a couple of tries before your vehicle starts. If
your vehicle does not start after several attempts, you may
have a different mechanical problem.
*
[RE03100(ALL)03/95]3.
When both vehicles are running, let them idle for a few
minutes to charge the dead battery.
% [RE03200(ALL)02/95]
Take the jumper cables off in the following order:
[RE03300(ALL)02/95]1.
Remove the negative (s) end of the jumper cable from the
metallic surface in the engine compartment of the vehicle
that needed a jump-start.
*
[RE03400(ALL)03/95]2.
Remove the other end of the negative (s) cable from the
booster battery.
*
[RE03500(ALL)03/95]3.
Remove the positive (+) cable from the booster battery.
*
[RE03600(ALL)03/95]4.
Remove the other end of the positive (+) cable from the
vehicle that needed a jump-start.
% [RE03700(ALL)02/95]
After your vehicle is started, let it idle for a while to let the
engine ªrelearnº its idle conditions and drive it around for a
little while with all electrical accessories turned off, to let the
battery recharge.You may need to use a battery charger to
fully recharge the battery.
File:wnres.ex
Update:Tue Mar 19 08:18:21 1996

Roadside Emergencies
267
%*
[RE03800(ALL)01/93]
Changing a Flat Tire
*
[RE03900(ALL)01/95]
If you get a flat tire while you are driving, do not apply the
brake heavily. Instead, gradually decrease the speed. Hold the
steering wheel firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off the ignition, set
the parking brake, and turn on the hazard flashers.
% [RE04000(ALL)02/95]
Using the Spare Tire
*
[RE04100(ALL)03/94]
Your vehicle has a temporary spare tire (unless you ordered the
optional full-size spare tire). This spare tire is smaller than a
regular tire and is designed for emergency use only. Use it only
when you get a flat tire and replace it as soon as you can. This
spare tire is marked with the words TEMPORARY USE ONLY
so that you can easily identify it.
*
[RE04200(ALL)01/93]
RWARNING
If you use the temporary spare tire continuously or do
not follow these precautions, the tire could fail, causing
you to lose control of the vehicle, possibly injuring
yourself or others.
*
[RE04300(ALL)02/95]
When you drive with the temporary spare tire, DO NOT:
*
[RE04500(ALL)02/95]
n
exceed 50 mph (80 km/h) under any circumstances
*
[RE04600(ALL)01/93]
n
load your vehicle so that it is heavier than the maximum
vehicle load rating listed on the tire decal
*
[RE04700(ALL)01/93]
n
tow a trailer
*
[RE04800(ALL)01/93]
n
use tire chains
*
[RE04900(ALL)01/93]
n
try to repair the temporary spare tire or remove it from its
wheel
File:wnres.ex
Update:Tue Mar 19 08:18:21 1996

268
*
[RE05000(ALL)01/93]
n
use the wheel for any other type of vehicle
*
[RE05100(ALL)01/93]
n
drive through an automatic car wash. Because the temporary
spare tire is smaller than a conventional tire, it reduces the
ground clearance. Your vehicle may get caught in the rails
and it could be damaged.
[RE05200(ALL)02/95]
Finding the spare tire
[RE05300(ALL)11/93]
The spare tire is stored underneath your vehicle, directly below
the cargo area.
[RE05400(ALL)02/95]
Removing the spare tire
*
[RE05500(ALL)01/93]1.
Open the liftgate and find the plastic hex nut cover in the
carpeting of the cargo area. Lift the cover to expose the hex
nut.
[RE05600(ALL)08/94]
17-1/2 pica
art:0050024-B
The spare tire cover
File:wnres.ex
Update:Tue Mar 19 08:18:21 1996